双掺大流动性混凝土性能研究

研究了不同粉煤灰掺量对双掺大流动性混凝土性能的影响,并结合高效减水剂及粉煤灰的水化机理及混凝土抗压强度、碳化深度对双掺大流动性混凝土作了一定的性能分析论述,总结出其抗压强度及碳化深度之间存在的关系。     

Light, temperature and burial depth effects on Rumex obtusifolius seed germination and emergence

Trials were carried out to investigate the effects of light and temperature on germination of Rumex obtusifolius L. After several months of storage, seeds gradually lost dormancy and became photosensitive. Thermal optima for germination were between 20 °C and 25 °C in light or in darkness. At lower temperatures there was a greater demand for light, so that the greatest differences in germination percentage (between low and high temperatures) were found within the 10–15 °C temperature range. The calculated thermal minima ( x -intercept method) in light and darkness were 8.3 °C and 6.1 °C respectively. Daily temperature fluctuation increased germination even after seed irradiation with far-red light, suggesting a lower demand for the far-red-absorbing form of phytochrome. Seed burial inhibited germination in proportion to depth; however, germination inhibition was independent of seed phytochrome photo-equilibrium, which had been diversified by seed pretreatment with light. Seedlings did not emerge when seeds were buried >8 cm deep. Recovery of ungerminated seeds showed that excessive burial did not impede seedling emergence but rather prevented seed germination. However, this induction of dormancy was lost once germination processes were activated (24–48 h at 20 °C) that made germination irreversible. Temperature was also involved in inhibition, and low temperature (<15 °C) induced the least inhibition. This is discussed in terms of processes of respiration and fermentation in buried seeds.     

Effects of lodging of Echinochloa crus-galli L. on the herbicidal efficacy of MTB-951, a mycoherbicide using Drechslera monoceras (Drechsler) Subram. et Jain (= Exserohilum monoceras [Drechsler] Leonard et Suggs)

MTB-951 is a plant pathogen ( Drechslera monoceras ), which was isolated from native Echinochloa spp. in Japan. The conidia of this pathogen were used as the herbicidal active ingredient to control Echinochloa crus-galli L. The herbicidal efficacy of MTB-951 on E. crus-galli was drastically increased with an increasing water depth of between 1 and 10 cm. The efficacy also was increased when shoots were lodged by pushing down on them with a stainless steel net so that all parts of the weed were submerged. These results suggest that the contact area of the leaf surface of E. crus-galli with water is important for infection and that lodging the shoots of E. crus-galli might be effective in increasing the herbicidal efficacy. In order to find other methods to lodge the weed, we investigated several materials, of which diisononyl phthalate (DINP) was found to be the most effective. Using this material as a model, the effect of lodging on the herbicidal efficacy of MTB-951 was examined. The lodging ratio (ratio of the number of the plants lodged on the water surface to that of the total plants) was increased with an increased amount of DINP, between 0.5 and 8 kg ha⁻¹. The herbicidal efficacy of MTB-951 also was increased by DINP and a positive correlation was observed between the lodging ratio and herbicidal efficacy. These results indicate that lodging, which can increase the contact area between the leaf surface and water, enhances the herbicidal efficacy of MTB-951.     

Development of a spot plow providing complete inversion for effective weed control

Tillage for the "complete inversion" of soil, that is, overturning soil slices 180° was proposed, a "spot plow" was developed and tested to accomplish the task, and a simulation model was evaluated to demonstrate the efficacy of the plow on weed control. A 360 mm wide spot plow was designed to operate at a speed of 1.9 m s⁻¹ for the spot plowing with the least possible lateral displacement of the soil slice by utilizing the inertia of the soil slice and securely rotating it. In field experiments, complete spot inversion required an operating speed of at least 1.6 m s⁻¹; at lower speeds, a portion of the soil block was left half-inverted and further lowering led to considerable lateral displacement. The displacement in the forward and lateral directions was minimal, implying that spot plowing is suitable for potential application to and verification of the weed population dynamics model in the field. A simple linear matrix model of the population dynamics of annual weeds was proposed, whereby four layers of soil were set to describe tillage and other ecological events. The effect of tillage on weed control was evaluated by the equilibrium reproduction rate allowed to sustain a stable population of weeds. The simulation model showed that alternately changing the depth of spot plowing had a significant effect on controlling weeds of low-survival-rate seeds, even when some incomplete inversion of the soil slice was taken into account.     

Longevity of seeds of four annual grass and two dicotyledon weed species as related to placement in the soil and straw disposal technique

Persistence of seeds of the four winter annual grass species, Alopecurus myosuroides , Bromus sterilis , Bromus hordeaceus and Vulpia myuros , were studied under field conditions. The studies also included the two dicotyledon species, Tripleurospermum inodorum and Galium aparine . Seed samples were stored in the field at different depths in the plough layer for a year. Following germination, seedling emergence was taken as an indicator of field persistence. In a supplementary investigation, seed samples were placed on the soil surface or buried at 2 cm for a month and then tested for viability. Persistence of the two Bromus species was very short, irrespective of depth and duration of burial. Persistence of the other species was positively correlated with incorporation of seeds to a few centimetres depth. Increasing the depth of incorporation below 2 cm had a variable influence on persistence. Persistence of seeds placed directly on the soil surface was short, whether they were left there for a year or a month. Whether seeds at the soil surface were left uncovered or covered with chopped straw had limited influence on seed persistence. However, straw cover significantly increased persistence of A. myosuroides seeds and there was the same tendency with T. inodorum .     

软土路基处理若干方案浅谈

软土路基处理应根据软土、淤泥的物理力学性质、埋层深度、材料条件、公路等因素分别采取处理措施.     

高层建筑框架结构安全隐患的预控

本文概述了高层建筑框架结构在施工图设计阶段几个方面的问题。避免因设计者的疏忽而给结构安全带来隐患。     

Root distribution ofDactyladenia (Acioa) barteri andSenna (Cassia) siamea in alley cropping on Ultisol. I. Implication for field experimentation

Root observations were carried out on a typic Paleudult in the humid forest zone of south eastern Nigeria in an alley cropping trial usingDactyladenia (Acioa) barteri andSenna (Cassia) siamea as hedgerow trees and the interrow space planted to maize/cassava intercrop. Rooting depth ofD. barteri andS. siamea exceeded 1.6 m. Lateral root propagation ofS. siamea was 15 m, and ofD. barteri was 5 m from the hedgerows. The whole no-tree control plot was within the range of roots of the adjacent hedgerows. Rooting density and depth ofS. siamea in the no-tree control plot was generally higher than of cassava.S. siamea and cassava root density were inversely correlated. Assuming radial symmetry of root propagation, water and nutrients were available from an area 6.1 and 2.3 times larger than the allocated plot size ofS. siamea andD. barteri, respectively. Data obtained in alley cropping trials, not considering lateral root propagation, can be invalidated through exploitation of the no-tree control treatment and nutrient acquisition by hedgerow species from a larger area than allocated, thus underestimating and overestimating the performances of the respective treatments. Possible alternative measures for avoiding root interference are discussed but no good solution can be given.     

河网平原地区雨水管道设计方法的探讨

本文结合河网平源地区的水文地理特点，提出了雨水管道设计中管径确定与管道埋设分别独立进行，水力计算采用统一的水力坡降，管道埋设采用统一的安装坡度，以及提倡管底平接等设计思想与计算方法。     

Bearing properties of engineered wood products I: effects of dowel diameter and loading direction

The embedment tests of laminated veneer lumber (LVL) with two moduli of elasticity (MOE; 7.8 GPa and 9.8GPa), parallel strand lumber (PSL), and laminated strand lumber (LSL) were conducted in accordance with ASTM-D 5764. The load-embedment relation for each of these engineered wood products (EWPs) was established. The directional characteristics of bearing strength (_e), initial stiffness (k _e), and effective elastic foundation depth were obtained from the tested results. The effective elastic foundation depth (=E/k _e,E = MOE), based on the theory of a beam on elastic foundation, was obtained from thek _e and MOE. An of 90° (perpendicular to the grain) was calculated by dividingE ₉₀ [MOE of 90° from the compression test, but MOE of 0° (E ₀), parallel to the grain, obtained from the bending test] byk _e90, the initial stiffness of 90°. This study aimed to obtain the bearing characteristics of each EWP, taking into consideration their anisotropic structures, for estimating the fastening strength of a dowel-type fastener. The relations between the bearing coefficients ( _e,k _e,) on the loading direction and dowel diameter were established from the load-embedment curves. Based on the results of the embedment test, tested EWPs showed different tendencies in all directions from wood and glued laminated timber.Part of this study was presented at the 49th Annual Meeting of the Japan Wood Research Society, Tokyo, April 1999