制动防抱死系统在汽车上的应用

在文中通过研究汽车制动时的受力情况、路面附着特性、制动防抱死系统的控制方式、组成和工作情况，得出了使车轮滑动率保持在20％的最佳状态可提高汽车的制动效能，缩短制动距离。并使汽车具有较好的转向和抵抗侧向力的作用，提高汽车制动时的方向稳定性的结论。     

活性炭吸附痕量银的研究

在静态、动态吸附条件下，分别选用果壳类净水用活性炭和煤质净水用活性炭对胶片工业废水中的痕量银的吸附行为进行了研究．结果表明，废水中的银浓度可降至＜５０ｐｐｂ，活性炭对银的吸附量达到３～５ｍｇ／ｇ．微孔发达的活性炭更适于吸附废水中的痕量银．随着银液浓度的升高，银液量增大，活性炭吸附能力增加．银液的最佳吸附ｐＨ值是５．     

聚乙烯吡咯烷酮修饰碳糊电极法测定水中苯酚

提出了以聚乙烯吡咯烷酮（ＰＶＰｒ）修饰碳糊电极测定水中苯酚的方法．在０．１ｍｏｌ／ＬＫＣｌ的酚试液中开路富集后，在磷酸盐缓冲液介质（ｐＨ５．６）中溶出，用微分脉冲伏安法测定，苯酚的溶出峰电位为＋０．７３Ｖ（Ａｇ－ＡｇＣｌ参比电极），检测限为０．０５μｇ／Ｌ．应用该法测定了废水中苯酚的含量，并讨论了该法测定苯酚的影响因素，比较了几种修饰电极测定苯酚的灵敏度，探讨了苯酚在该修饰电极上的富集机理     

犬瘟热病毒的静水压灭活

以250MPa的静水压力对犬瘟热病毒（CDV）处理30min之后，CDV被灭活，由其制成的灭活疫苗诱导犬产生中和抗体的能力明显优于传统的福尔马林灭活疫苗，免疫保护率达90％。电镜观察显示，经不同程度静水压力处理后的CDV粒子均发生变形，表面呈现凸起，但CDV H基因部分片段的RT－PCR扩增结果揭示，高达510MPa的静水压力作用30min也未能使其基因片段受到破坏。     

Capnographic documentation of nasoesophageal and nasogastric feeding tube placement in dogs

Objective: To evaluate the ability of capnography to document proper placement of nasoesophageal (NE) and nasogastric (NG) feeding tubes. This study was conducted in 3 phases. Phase I of this study was designed in order to test the efficacy of capnography to distinguish placement of a feeding tube in the alimentary tract versus the respiratory tract. Phase II was designed in order to document that carbon dioxide (CO₂) could be measured through a polyvinyl chloride (PVC) feeding tube. Phase III was performed in order to evaluate the technique of continuous monitoring during insertion of the feeding tube into the esophagus and stomach as would be performed during a clinical‐tube placement. Design: Prospective study. Setting: Research laboratory. Animals: 24 adult dogs. Interventions: In Phase I, sedated dogs were instrumented with an intratracheal catheter and an 8 French feeding tube placed nasally into the distal esophagus and later advanced into the stomach. In Phase II, dogs were anesthetized and an 8 French feeding tube was placed down the endotracheal tube, then into the esophagus and later advanced into the stomach. In Phase III, sedated dogs were instrumented with an 8 French feeding tube inserted intranasally and then advanced to the level of the nasopharynx, distal esophagus and, lastly, the stomach. Fluoroscopy was used in order to determine location of the feeding tube. Measurements and main results: Phase I measurements included respiratory rate and CO₂ from the trachea, esophagus, and stomach and pH of gastric fluid sample. Phase II measurements included respiratory rate and CO₂ from the endotracheal tube, feeding tube in the endotracheal tube, feeding tube in the distal esophagus, and feeding tube in the stomach. Phase III data collection included respiratory rate and CO₂ as the tube was passed through the nasal cavity, nasopharynx, esophagus and stomach. Phase I fluid samples were collected from 5 of the 9 dogs and had pH values from 1.68 to 4.20. In both phases, values for the respiratory rate and CO₂ from the esophagus and stomach were 0 ± 0, significantly lower (P < 0.001) than the values from the trachea. In Phase II, there was no significant difference between the respiratory rates (P = 0.886) and CO₂ (P = 0.705) readings obtained from the endotracheal tube compared to readings from the feeding tube in the endotracheal tube. In Phase III, there was a significant difference (P < 0.001) between the respiratory rates and CO₂ readings obtained from the nasal cavity and the nasopharynx when compared to those readings obtained from the esophagus and stomach. Measurement of CO₂ and respiratory rate resulted in a reading of 0 every time the feeding tube was in the esophagus or stomach. Conclusions: Capnography may be used in order to detect airway placement of NE and NG tubes.     

木材干燥导水系数和换水系数的研究

木材(板、方材)的导水系数和换水系数是反映木材干燥或存放过程中水分迁移的重要物性参数。然而,我国对木材导水系数和换水系数的研究和测定工作十分有限。木材干燥有关的理论计算中,常用原苏联的数据。由于这些数据本身可能存在的误差及用于我国树种的可靠程度难以估计,故使理论结果的实际运用受到限制。本文采用等厚试件系数分离法研究和测定了木材干燥过程动态导水系数和换水系数。     

用简易诊断法检查判断液压系统各元件的工作性能

故障的排除首先在于判断，目前基层维修网点大多数没有检测仪器和设备，出了故障乱拆乱卸，导致液压元件工作失灵，甚至整车液压系统瘫痪。拖拉机液压系统产生故障的主要原因是液压元件工作性能恶化引起的。为此，介绍了在没有检测仪器和设备的条件下，如何应用简易诊断法检查判断各液压元件的工作性能。     

Study on ambient noise in sawmill’s workshop

Ambient noise in 13 sawmill’s workshops was tested and analyzed to reveal its character and regularity. The situation of the ambient noise in sawmill’s workshops was evaluated     

手动比例复合阀在中高压液压绞纲机中的应用

中高压液压技术在海洋捕捞机械—绞纲机中的使用推动了我国渔业机械的发展,手动比例复合阀在中高压液压技术上的应用则大大加快了液压绞纲机在国内渔业生产中的普及。目前,我国浙江、江苏、福建、广东和山东等省沿海渔民使用的绞纲机普遍采用带手动比例复合阀的液压系统。为此,对手动比例复合阀换向、溢流、调速集成等功能进行了分析。     

水稻中系8541与中系8240光合特性的比较研究

本文通过光合作用参数的测定,详细的研究了中系8541和8240两种不同产量水平的水稻品种的光合特性.论述了在含等量叶绿素的条件下,中系8541和中系8240之间在对光谱的吸收、叶片的光合作用量子转化效率,叶绿体的PSⅡ(光系统Ⅱ)潜在活性(Fv/F_0)和原初光能转化效率(Fv/Fm等的主要区别.实验结果说明,上述各光合作用参数中系8541都优于中系8240.不仅如此.在Mg~(2+)作用下,Fv/Fo和Fv/Fm比值的提高以及Mg~(2+)对两个光系统激发能分配的调节能力中系8541也强于中系8240.