基于浑浊度监测山区河流悬浮泥沙含量的试验研究

针对山区河流悬浮泥沙含量监测缺乏实时性的问题,对浑浊度及悬浮泥沙含量进行监测,分析光照强度、流速、颗粒粒径和水体含沙量对浑浊度的影响,建立浑浊度与悬浮泥沙含量的关系模型式。结果表明： 1）光照强度对浑浊度的影响最大,根据二者之间的关系,将光照强度（E）划分为3个区间：E≤6 800 lx、6 800 lx <E≤22 000 lx、E>22 000 lx,对应于3个区间,确定了浑浊度与悬浮泥沙含量的关系模型; 2）水流流速主要影响上层泥沙颗粒的分布,流速为0.16 m/s时测量区域的浑浊度大于流速为0.018 m/s时的浑浊度; 3）泥沙颗粒的粒径大于扬动流速能带动的临界粒径时,其会沉积在渠底,因此,泥沙级配中大于临界粒径的颗粒占比越大,悬浮泥沙含量越小,浑浊度越小; 4）水体含沙量越大,水沙输移过程中携带悬浮泥沙的量也越多,测量区域上层水样的浑浊度越大; 5）采用本研究确定的浑浊度与悬浮泥沙含量的3个关系模型,预测得到的悬浮泥沙含量与实际悬浮泥沙含量的平均相对误差分别为7.22%、10.00%、8.58%。根据在自然条件下不同光照强度区间测得的浑浊度,可以得出该测量区域的悬浮泥沙含量。由于浑浊度可以现场连续、快速测得,所以将此方法引入山区河流悬浮含沙量实时监测是可行的。     

建兰花叶病毒广东分离物的全基因组序列分析

【目的】建兰花叶病毒(Cymbidium mosaic virus,CymMV)是最主要的兰花病毒病原之一,其广泛传播对兰花产业发展造成严重威胁。探究CymMV遗传信息和进化,为广东省兰花病毒病的监测预警和兰花抗病毒病基因工程提供重要科学依据。【方法】对采自广州地区的墨兰疑似病毒病叶片进行CymMV的RT-PCR及DA-SELISA检测鉴定,利用相关分子生物学软件对CymMV分离物进行基因组序列组装、注释、系统进化及选择压力分析。【结果】首次在广东省发现2个CymMV分离物GZV013和ZC-29,基因组全长均为6227 nt,编码5个功能蛋白;GZV013与台湾分离物M2的核苷酸序列一致性为97.03%;ZC29与南京分离物NJ-1的核苷酸序列一致性为97.11%;CymMV各分离物的全基因组序列一致性为86.85%～98.31%,且多样性种群的分化与寄主种类和地理隔离关系密切;CymMV基因组每个区域均受到负选择的影响,并符合中性进化模型;编码RdRp、TGB1和TGB2的基因在基因组中变异率最高。【结论】GZV013与台湾分离物M2的亲缘关系最近,ZC29与南京分离物NJ-1的亲...     

Geographical information system (GIS) environmental models for aquaculture development in Sinaloa State,Mexico

This paper describes the use of a geographical information system (GIS) to construct environmental models for land-based aquaculture development in the State of Sinaloa, Mexico. Based on the source data, submodels were created focusing on three different themes: general environmental issues, water resources and water quality. Models enabled multicriteria and multiobjective decision making concerning site selection and location. In assessing site considerations these general models identified wider resource management options and solved conflicts of land allocation and land use between aquaculture and agriculture. Smaller-scale, more specific models enabled more detailed studies on environmental issues.     

Optimising codend configuration in a multispecies demersal trawl fishery

Abstract The relative efficiencies and selectivities of conventional and modified codends were examined in a demersal trawl fishery targeting several species, including eastern king prawns, Penaeus plebejus (Hess), whiting, Sillago spp. and cephalopods. The modifications to codends included: (i) reducing the circumference; (ii) increasing the mesh size in conventional diamond‐mesh designs; and (iii) orientating meshes on the bar so that they were square shaped. The codends were tested against a fine‐meshed control in paired comparisons onboard three commercial trawlers. The conventional codend comprised 41‐mm diamond‐shaped mesh attached to an anterior extension section at a ratio of 150 to 100 meshes and was demonstrated to be non‐selective for the targeted species. Reducing codend circumference to 100 meshes and increasing the size of mesh to 45 mm both improved selection for eastern king prawns, but the lateral mesh openings were estimated to be insufficient to allow juveniles of the other key species to escape. By contrast, codends made from 35‐ and 41‐mm mesh hung on the bar improved the size selection for eastern king prawns and selected stout whiting, Sillago robusta (Stead) (the smallest commercial‐sized fish) across narrow selection ranges and at 50% sizes of retention (L₅₀s) that were closely correlated to the transverse morphology of fish and the maximum mesh opening. With the exception of a reduction in catches of octopus, Octopus spp., by the 41‐square codend, there were no other impacts on commercial catches by the square‐mesh designs. It was concluded that diamond‐mesh codends are inappropriate for use throughout this multispecies fishery and that a modified design comprising at least 35‐mm mesh hung on the bar is required to minimise the fishing mortality of unwanted sizes of the key target species. The results are discussed in terms of the utility of these types of modifications for closely regulating selection in penaeid‐shrimp trawls.     

A SCAR marker linked to the N gene for resistance to root knot nematodes (Meloidogyne spp.) in pepper (Capsicum annuum L.)

The root-knot nematodes (Meloidogyne spp.) are important nematode pests and cause serious diseases in pepper in the world. No molecular markers linked to the nematodes resistance N gene have been reported. In this paper, ‘Carolina Wonder’ (Capsicum annuum L.), a sweet pepper line resistant to root-knot nematode with N gene, ‘20080-5-29’ (C. annuum L.), an inbred line susceptible to root-knot nematode with good horticultural characteristics, and their F₂ progeny with 320 individuals were used as materials. Evaluation of resistance and susceptibility of parental lines, F₁ and F₂ progeny inoculated with root-knot nematodes (Meloidogyne incognita) were carried out. ‘Bulked segregant analysis’ method was used to search for polymorphic markers from 512 pairs of AFLP primers. Based on the assessment of resistance and susceptibility and polymorphism of the AFLP marker in F₂ population, the genetic linkage distance between the AFLP marker and the N gene was estimated. One AFLP marker E39/M41-339 was obtained and transferred to a SCAR marker amplifying a 315 bp DNA fragment linked to the N resistant allele and a 331 bp fragment linked to the N⁺ susceptible allele. The distance between the molecular marker and the nematodes resistance N gene is 6.3 cM. This research delivered a valuable tool for the marker assisted selection of nematodes resistance in pepper.     

黄瓜根际促生菌的促生效应与防病作用

对黄瓜植物根际促生菌(PGPR)菌株的分离筛选、分类鉴定以及人们对其促生防病作用的应用和防病机制的研究现状进行了综述,以期为新型PGPR制剂的进一步研制、开发和应用提供参考.     

元蘑孢子萌发融合育种试验与研究

试验采用孢子萌发融合技术获得元蘑菌株,并对其进行了产量和形态指标测定,选育出的菌株经3年的栽培试验,产量高出常规品种15%,菇形好,命名为元蘑1号。     

Application of crop growth simulation and mathematical modeling to supply chain management in the Thai sugar industry

The poorly integrated cane supply planning between mills and cane growers in the Northeast of Thailand generates an excess of cane supplies that exceeds the mills’ capacity during the peak of harvest season. Each grower individually determines his/her cultivation plan by selecting planting dates and cultivars based on one’s own preference without taking into account the individual mill’s capacity and other growers’ plans. This situation causes most sugarcane grown in this area to reach its mature stage at the same period. In this study, we propose a framework of cultivation planning to cope with the problem. The focus of the cultivation plan is a long-term plan to determine the cultivation time, the cultivar selection and the corresponding prospective harvesting time window for each field such that overall sugar production is optimized.The crop growth model and a mathematical model are employed for yield simulation and optimization task. The crop growth model enables decision-makers to visualize cane production of each individual field at different dates with different cultivars and allow decision-makers to apply the mathematical programming to cultivation planning. The suggested framework has the potential to increase sugar production by 23% when compared to the traditional method.     

近红外玉米品种鉴别系统预处理和波长选择方

以7个品种玉米籽粒的鉴别系统为研究对象,对比研究了6种预处理方法和波长选择对模型鉴别能力的影响.结果表明,在被比较的6种预处理方法中,一阶导数方法能够使模型有更好的鉴别性能.使用一阶导数预处理和全光谱区的模型平均正确识别率和正确拒识率最高,分别为98.6%和98%,有5个品种的模型的正确识别率和正确拒识率都达到了100%.波长选择对一阶导数模型没有明显作用,但能使标准正态变量变换和矢量归一化模型鉴别准确度得到较大提高.     

基于Web的农机选型智能决策支持系统设计

根据农业机械在农业生产中的应用,结合计算机网络技术,设计了基于Web的农业机器选型智能决策支持系统;同时,阐述了其设计目标及原理,讨论和分析了系统的体系结构,给出了系统的4个主要功能模块,并确定了系统的总体结构。