A New Monte Carlo Method Based on State Analysis

A new Monte Carlo Method for system reliability evaluation is proposed in this paper. The repeated sampling of system states with relatively great probabilities is avoided in the simulation,thus the sampling efficiency is significantly improved. Besides,the negative correlations used in different trials can further reduce the estimated varinaces. The sparse matrix technique is employed to reduce the memory requirement and to save the computer time. Comparative studies show that the method proposed is of great value and the application to the IEEE reliability test system (power system) is successful.     

A NEW TESTABILITY MEASURE OF DIGITAL CIRCUITS

A new scoap-like testability measure SCTM(a signal conflict oriented testability meaure) is presented, which represents not only the difficulty to control and observe the value of a node,but also the probability to cause signal conflict in the process of test generation. A parallel calculation scheme is offered, which speeds up the calculation m/2 times. Here m is the word length of a computer.     

Vibration Analysis and System Simulation for a Stalled Wind Turbine

The aerodynamic characteristic of wind turbine is calculated by applying the Blade Element Momentum(BEM) theory.Also finite element mode analysis is done for the tower and the rotor.Then the multi-dynamic model of the wind turbine is built in Adams.Also the drive chain is calculated by applying state space method and programmed in Matlab/ Simulink.With that the combined simulation of vibration characteristics is carried out on the base of MATLAB/Simulink and ADAMS,in which the transmission effects and aero-elasticity coupling is fully considered.The results show that the method is able to simulate the vibration characteristic almost the same as software Bladed,which is well-known for analyzing performance and loads for the design and certification of wind turbines.     

Multiple Layer BP Neural Network for Fuzzy Calculating

The FCBP(Fuzzy calculating BP) algorithm which is proposed by this paper hasovercome the sensitivity for samples,reduced the number of input layer's samples,lightened the burden of input layer.it is suitable to fuzzy inference and pattern recognition.     

Detection of Edges within the Cross Sectionfrom Projections of Parallel Beams Via the Wavelet Method

The wavelet analysis are used in the detection of edges within the cross sectionfrom projections of parallel beams. This method can be applied in computerized tomography (CT) inorder to reduce the noise and the number of projections.     

DETERMINATION OF METALLIC IRON IN HIGH TITANIUM SLAG BY HEADSPACE GAS CHROMATNGRALHY

The following details are discussed in the present paper, after high titanium slag and H3PO4 is put in the closed system,the .reaction takes place under controlled temperature conditions, and the gas produced is collected. The two phases of gas liquid attain kinetic equilibrium, ihe gas above the liquid is used to make GC analysis with the aid of chromatographic column of 5A molecular sieve, TCD and N2 30ml/min. Satisfactory quantitative results can be achieved with simple instruments and uncomplicated operation technique.     

A MORE GENEEAL PRODUCTIVE FORCES DISTRIBUTION MODEL WITH ENTROPY CONSTRAINT

The productive forces distribution model with entropy constraint is established. it satisfies both the demand with minimization of total cosls and the other demands with optimum distribution at a certain level. The model's regular optimal solution is a gravity molel..     

The Optimization Design for the Parameters of Capacitor Welding

Through the analysis in this paper,the optimum relation of the discharging current peak interval t m ,the discharging loop equivalent inductance L and equivalent resistance R is obtained.This paper analyze the original discharging loop equivalent inductance L ,which provides an effective method for adjustment and selection of inductance L to realize the optimization energy saving design of the welding machine.