八点黑獭兔胃、空肠、肝组织结构的研究

取60、90和180日龄八点黑獭兔的胃、空肠、肝制作切片,显微镜下研究其组织构造特点。结果显示：獭兔胃组织由内到外依次为粘膜、粘膜下层、肌层和浆膜,胃肌层随着日龄的增加而逐渐加厚;空肠粘膜层和肌层均随着年龄的增加而增厚,粘膜层中的肠绒毛尤为明显,杯状细胞的数目也有所增加;各年龄段肝切片差异不大,肝小叶不明显,肝细胞以中央静脉为轴心呈放射状排列,窦状隙内见有大量红细胞：相同年龄段獭兔的胃、空肠、肝组织学结构未见性别间的明显差异。     

Surgical Correction of Uterine Torsion and Mare–Foal Survival in Advance Pregnant Equine Patients

This article describes the surgical management of uterine torsion by midline celiotomy and cesarean section on 12 mares presented with signs of colic to a teaching veterinary hospital. The mares were either in full term of gestation (n = 7) or in advanced stage of pregnancy (n = 5). Six mares were in first parity. Uterine torsion was diagnosed by per rectal and per vaginal examinations. For surgical intervention, mares were anesthetized using a combination of xylazine (1.1 mg/kg) and ketamine (2.2 mg/kg), intravenously. After intubation, the animals were maintained on halothane (n = 4) or isoflurane (n = 8) inhalation anesthesia. Midline celiotomy was performed, and foals were delivered by cesarean section. In 11 mares, before closing the abdominal wound, the uterus was detorted manually and confirmed for its normal position. Both anesthetic protocols using halothane and isoflurane were found satisfactory for surgical correction of uterine torsion. After long-term follow-up, the study reported 75.0% (9/12) survival rate for mares. One mare was euthanized because of devitalized, necrosed, and adhered uterus to the abdominal wall. Of the nine surviving mares, seven were successfully bred. Three foals were born alive, and only one could survive on long-term basis. Of the nine dead foals, two had umbilical cord torsion.     

旋壳转速对腔内液体流动特性的效应

为研究旋壳转速对腔内液体流动特性的影响,以试验旋喷泵为研究对象,在高度验证叶轮与旋壳同步旋转试验与模拟结果准确性的基础上,对叶轮转速相同、旋壳转速不同的5个模型采用RNG k-ε湍流模型进行数值计算,分析腔内液体流动特性的变化情况,研究泵的性能.结果表明:旋壳转速增大,液体圆周速度和旋转系数均增大,圆周速度曲线沿径向逐渐形成同心圆,腔内液体做非刚性旋转.腔内液体径向压力梯度增大,压力低于624 kPa时,旋壳转速越高,压力越小;压力高于624 kPa时,旋壳转速越高,压力越大.集流管迎流区涡分布在进口附近,尾迹区涡集中在扩散段结尾处,整体呈增大趋势.旋壳转速增大,泵的扬程升高,但效率降低,通过改变集流管进口直径发现集流管并非效率降低的主要原因,而是由圆盘摩擦损失的增大导致的,圆盘摩擦损失随旋壳转速增加呈3次幂函数式增大,文中最优进口直径为13 mm.     

田面微地形对滴灌灌水均匀性的影响

首先分析了田面微地形对滴头实际工作压力的影响,田面越不平整,滴头实际工作压力与设计工作压力的差值越大,当田面局部高差大于滴头设计工作压力时,滴头流量等于零;然后提出了田面微地形产生的流量偏差率公式,并用泰勒级数展开;最后利用描述统计方法和独立样本T-检验的方法对余项进行分析,置信度为99%的余项取值区间为0.001￣0.002,说明余项能够被忽略,田面微地形产生的流量偏差率公式可以用简单的形式来表示。     

工程制图课程思政的实践与思考——以一堂课程思政示范课为例

课程思政是当前高校思想政治教育工作的新模式。本文以一堂工程制图课程思政示范课为例,讲解机件形状表达方法中的剖视图。首先构建了工程制图课程思政建设的总体框架,充分挖掘教学知识点中的思政元素,通过案例实施探讨知识点与思政元素的有机融入方式,并通过学生匿名问卷调查和教师代表的听课反馈来评估课程思政的教学成效。最后提出了课程思政建设中的几点思考。     

NETWORK FEOW APPROACH TO RELIABILITY EVALUATION IN IARGE SCALE NETWORKS BY MIXING INCREASING ELOW WITH DECREASING FLOW

Based on the maximum flow principle about networks, a network flow approach to reliability evaluation in large scale netwerks ty mixing inereasing flow with decreasing flow is proposed in this paper.This approach gets the initial flow of each branch in a r.etwork associated with a state of the retwork by decreasing flows of some branches correlative to another state of the network.As a result, the number of flow compute required can be reduced enormously.The numerical example shows that the approach is powerful. The comparison of this approach with the minimal cutset one is also given in this paper.     

切线泵流动特征的整流场数值模拟

对单级切线泵在设计工况进行了定常流动数值模拟，分析了叶轮流道及蜗壳内的液体流动情况。结果表明，切线泵内流场非常复杂，叶轮进口有明显冲击，叶轮各流道的速度、压力差异很大，环形蜗壳内流动呈现旋涡推进特征，上、下游流动有强烈的相互作用，整机流场不具有对称性；环形蜗壳的几何结构以及流场上、下游的相互作用是导致整机流场非对称特性的主要原因。计算结果为进一步改进结构、提高性能、减小水力损失提供了理论依据。     

低比转数离心泵叶轮出口紊流流动结构分析

在叶轮内三维紊流流动数值计算的基础上，从介质能量的观点，分析了不同工况下低比转数离心泵叶轮出口处的紊流流动结构。数值计算采用SIMPLEC算法，在贴体坐标系下求解Navier—Stokes方程，紊流模型采用标准的κ—ε模型。计算结果表明，在叶轮的出口附近靠近吸力面一侧存在一个低能区，而压力面一侧能量相对较高。这与有关文献中所指出的离心风机的“射流—尾流”结构相对应。当偏离设计工况时，该低能区的范围和强度略有增加，相对应的叶轮效率也降低。计算结果与水泵在这些工况下的效率实验结果相一致，说明低能区的存在是影响低比转数离心泵效率的重要因素。