渠道边坡稳定的盐敏感性特征研究

工程中灌排渠道在运行多年后,随着土中含盐量的增加,会造成渠道边坡不同程度的滑塌、变形及结构的破坏。通过对盐化土的剪切试验和界限含水率试验,得到不同含盐量下土的抗剪强度指标和稠度界限,运用单因素试验分析含盐量对土的抗剪强度和稠度界限的影响规律。随着含盐量的增加,土体的团聚体稳定性降低,增加了粘粒的分散性,土的抗剪强度有所下降;同时土的稠度界限也会降低,增大了土的流动性,明确地说明含盐量增加也是影响灌排渠道边坡稳定性重要因素。     

基于籽粒运动的多维振动筛分效率分析

在对现有往复式振动筛面上籽粒的非线性跳动进行理论分析的基础上,利用LS-DYNA程序研究了往复式和两种新型多维运动筛面上籽粒的运动情况,并提出分散性衡量指标以反映籽粒在筛面上的分散情况,以此对3种筛面的筛分效率进行对比分析。研究中依据筛面与籽粒的实物结构和物料特性建立分析模型,考虑籽粒与筛面及籽粒间的摩擦、碰撞作用,求解得出籽粒的运动规律。结果表明两种新型多维筛面运动形式有利于提高筛分效率。     

水稻籽粒库强与其淀粉积累之间关系的研究

本试验以源限制型水稻品种亚优2号、献改优63和汕优63为材料，研究籽粒发育过程中籽粒库强与其淀粉积累之间的关系。结果表明：（1）强、弱势粒淀粉积累与其胚乳细胞的数目密切相关，两者表现出明显的同步性；（2）强势粒蔗糖合成酶、腺苷二磷酸葡萄糖焦磷酸化酶和淀粉合成酶最大活性高峰出现时间显著早于弱势粒的出现时间，     

棉麦两熟棉纤维强度与铃期气象因子关系研究

研究棉麦两熟棉纤维强度与铃期气象因子关系的结果表明,相对湿度是影响棉麦两熟多类型、棉株多部位铃棉纤维强度的主要气象因子,相对湿度对纤维强度的作用均为负效应,作用大小因棉铃着生部位而异。日照时数对两熟春棉、温度对两熟短季棉棉株上部（７～９果枝）、顶部（１０以上果枝）铃棉纤维强度有重要作用,均为正效应。     

汽油机曲轴圆角和下沉量的研究

以某汽油机曲轴为载体,计算分析了曲轴的静态性能,并改变圆角半径和圆角下沉量的大小,分析对曲轴强度的影响,从而为圆角滚压工艺选取曲轴圆角参数奠定理论基础。     

2种离子固化剂改善黄土抗剪强度和抗渗性的研究

为了探讨CONAID和LUKANG 2种离子固化剂的固土性能及其影响因素,对不同固化剂掺量、养护龄期、压实度和含水率的固化黄土进行了直剪试验和渗透试验.研究结果表明:随着固化荆掺量、养护龄期和压实度增大,2种固化土的内摩擦角和黏聚力呈上升趋势,渗透系数呈下降趋势,且规律比较接近.其中LUKANG固化剂对黄土抗剪强度和抗渗性的改善效果优于CONAID固化荆.建议在施工过程中选用LUKANG固化剂,掺量宜取0.01%.为了达到更好的抗剪和抗渗效果,应尽量延长固化土的养护龄期,增加压实度.     

Differences in swimbladder volume between Baltic and Norwegian spring-spawning herring: Consequences for mean target strength

Fish swimbladders, where present, contribute most to the scattering of sound by fish, as measured by the target strength (TS). The volumes of the swimbladders of two different European stocks of Atlantic herring were compared to consider the effect on estimates of TS. Swimbladder volumes of Baltic and Norwegian spring-spawning herring (Clupea harengus) were measured, together with individual herring fat content. Swimbladder volumes were found to differ significantly between the two herring stocks. Baltic herring have a larger swimbladder volume, which is suggested to be associated with the fish's low fat content, which in turn may be linked to its specific energy budget and the low salinity of the Baltic Sea. A buoyancy model that considered the different salinity conditions and fat proportions was used to evaluate the observed differences in swimbladder volume. The swimbladder volume data were subsequently used to model the mean target strength as a function of depth and growth pattern. Backscattering of the swimbladder was modelled using the modal-series-based deformed-cylinder model (MSB-DCM), describing the swimbladder as a gas-filled, elongated prolate spheroid. The fish body component was modelled as a fluid-filled ellipsoid using the distorted wave Born approximation (DWBA). Modelling results support a different TS-to-size relationship for Baltic herring, with a stronger echo, due to the larger swimbladder. Depth- and length-dependent TS relationships based on the model results are suggested.     

Verification of mean volume backscattering strength obtained from acoustic Doppler current profiler by using sound scattering layer

ABSTRACT:   Acoustic Doppler current profilers (ADCPs) have recently been used to estimate the dynamic characteristics and biomass of sound scattering layers (SSLs) or swimming speed of fish schools and to analyze SSL spatial distribution or various behavior patterns. This paper shows that it is necessary to verify mean volume backscattering strength (MVBS, dB) values acquired from each beam for quantitative analysis of the spatial distribution or the biomass estimates of such specific targets as SSL or a fish school when using an ADCP. In this study, the SSL was selected to be a homogeneous density layer over a large area and two methods were used to verify the MVBS values from each beam of the ADCP. First, a mutual comparison among four beams was conducted after calculating MVBS from the measured echo intensity. Second, the MVBS values were verified using comparison between the calculated MVBS from the 153.6 kHz ADCP and MVBS from three frequencies of a well-calibrated scientific echosounder. Moreover, the dominant scatterers (euphausiids) were collected by a framed midwater trawl. From these samples, biological data were used to identify the different frequency characteristics between two systems, using a distorted-wave Born approximation (DWBA) theoretical backscattering model in order to assess the averaged target strength and target strength TS differences for the three frequencies.     

某汽车转向纵拉杆设计分析

转向纵拉杆是汽车转向传动机构中重要的零部件,通过转向纵拉杆受力分析,对转向纵拉杆的强度、稳定性进行了校核,提供了纵拉杆设计分析的参考.     

A new lean no time test baking method with improved discriminating power

In response to customer concerns related to gluten strength in commercial baking, the Canadian Grain Commission assessed whether the Canadian Short Process (CSP) test bake method was generating useful data related to intrinsic strength of wheat varieties. Assessment of CSP loaf volume data for Canadian variety trials spanning 2003 to 2013 showed very little correlation with dough strength parameters as measured by farinograph and extensigraph. A lean no time (LNT) test baking method was developed that can better discriminate genotypes and provide objective indicators of the effect of intrinsic dough strength on baking quality. From early method development, through method validation and verification using diverse sets of samples targeting different Canadian wheat classes and grown in three different crop years, results showed the LNT method to be more discriminating and easily adopted by other laboratories. In 2015, the LNT method was adopted as the method of choice in future Canadian variety registration trials. The LNT method is fast, simple and well-suited to high throughput test baking conditions encountered in the evaluation of large numbers of breeder lines. A new objective parameter, loaf top ratio, was also introduced and found to correlate well with dough strength and dough handling properties.