两种商品木浆的纸浆性能研究

选取市场上具有代表性的两种商品针、阔叶木浆进行PFI打浆处理,研究在不同打浆度下浆料纤维质量、动态滤水性能、Zeta电位、微观结构等方面的变化,并对不同比例配抄条件下的成纸性能进行考察,结果表明:针、阔叶浆的打浆度与打浆转数之间的关系均符合线性分布:y=17.7503+0.0015x,R^2=0.9914(针叶浆);y=8.8986+0.00275x,R^2=0.9734(阔叶浆);经PFI打浆后,两种木浆纤维长度、宽度变化较小,细小组分含量变化明显;随着打浆度的升高,两者的滤水性能下降,Zeta电位先上升然后基本保持不变;初始打浆度下,随着针叶浆比例的减少、阔叶浆比例的增加,成纸的抗张强度先下降再增大,厚度逐渐下降至不变,定量逐渐增加,柔软度逐渐下降;随着打浆度的升高,成纸的抗张强度增大,厚度、定量逐渐下降,针叶浆成纸柔软度逐渐下降,阔叶浆成纸柔软度先升高再逐渐降低。     

意大利瓦勒拉尼整地系统与常规开沟犁整地效益对比分析

通过意大利瓦勒拉尼整地系统（由火车型犁和海豚型犁2种犁型构成,其中火车型犁近似水平沟式整地,海豚型犁近似大鱼鳞坑式整地）与常规开沟犁整地效益的对比试验,结果显示：同期覆土层（0～20 cm）的土壤含水量以瓦勒拉尼系统2种整地方式最高,是常规开沟犁整地的1.28倍和1.11倍。火车型犁整地的土壤容重为1.05 g/cm3,常规开沟犁整地为1.08 g/cm3,火车型犁整地后的土壤容重最小。瓦勒拉尼系统的火车型犁整地后的土壤毛管最大持水量是56.12%,远高于未整地的48.44%和普通犁整地的52.12%,分别是后两者的1.16倍和1.08倍。火车型犁整地后文冠果的地径达1.00 cm,是普通犁整地后地径0.42 cm的2.38倍;树高为0.93 m,是普通犁整地后树高0.53 m的1.75倍;保存率由59.30%提高至91.43%,提高了32.13个百分点;海豚型犁整地文冠果4年保存率则提高了13.42个百分点。     

毕节市漆树品种产量与树皮性状的灰色关联度分析

为漆树优良品种的选择以及灰色系统理论在林业林木品种评价上的运用提供参考，对毕节市8个漆树品种红漆大木、粉皮大木、灯台大木、红尖大木、肤胭皮、粉红皮、白杨皮、青杠皮等树皮解剖中6个主要性状与产漆量的关系进行灰色关联度分析。结果表明：漆树树皮解剖的单个性状对产漆量有直接影响，其中以漆汁道直径的大小关系最重要，直接关联度达0．7964；其次是活皮漆汁道单位面积与活皮厚度。从树皮解剖的综合性状看，漆树品种最好的依次是红尖大木＞红漆大木＞肤胭皮＞灯台大木＞白杨皮＞粉皮大木＞粉红皮＞青杠皮。分析结果与实际生产基本一致，表明在林业生产中运用灰色关联分析进行综合评价是可行的。     

Effects of spent mushroom substrates and inorganic fertilizer on the characteristics of a calcareous clayey‐loam soil and lettuce production

We evaluated the effects of the addition of two types of spent mushroom substrate (SMS), SMS from an Agaricus bisporus crop (SMS1) and a mixture of SMSs from an A. bisporus crop and a Pleurotus crop (50% v/v each) (SMS2), on the characteristics of a calcareous clayey‐loam soil and the yield and nutritional status of lettuce (Lactuca sativa L.), relative to crops receiving mineral fertilizer (M) and a control (C) without amendment. The application of SMS, especially SMS1, improved soil fertility compared with C and M soils. Moreover, the use of these organic substrates as soil amendments did not harm the plants and gave yields similar to that obtained with mineral fertilizer. The nutritional contents of the lettuce plants were greater than or similar to those of the plants from treatment C or M, except for the plant tissue concentrations of K, Fe and Zn, which were significantly reduced by SMS application. However, this latter fact did not reduce the lettuce yield in the amended soils. Therefore, the use of SMSs as organic amendments contributes to residue utilization, in an environmentally friendly way, and to improved soil fertility and crop yield.     

A calibration method of detecting soil water content based on the information-sharing in wireless sensor network

In agricultural production, there is contradiction between the cost and accuracy of detection during the course of acquiring soil water content (θ) online. This conflict is one of the core issues of automatic water-saving irrigation technology in agriculture. At the same time, capacitive soil moisture sensor (CSMS) has received considerable attention, for it can acquire θ with low cost and high precision, and meet the application requirements of wireless sensor network (WSN). But CSMS is vulnerable to the soil temperature (T_s) and salinity (S_s) in the measurement process. Therefore, this study took EC-5 sensor for example to establish water detection calibration models of soil temperature and salinity for single sensor, using Least Squares Support Vector Machines on MatLAB (LS-SVMlab) as the tool. On this basis, we explored the spatial variability of T_s and S_s, and then a method, which could be used to calibrate the output signals of sensors in multi-point network, was proposed based on the information-sharing (T_s or S_s) technology of WSN. Through laboratory experiment, we effectively reduced the impact of soil temperature and salinity on the single sensor. In example analysis, we investigated the detection precision and costs under different information-sharing radiuses (r). And the results indicated that the method we proposed based on the information-sharing technology of WSN could successfully calibrate the influence of soil temperature and salinity on sensors in multi-point network, and it was an efficacious approach to determine the balance between the calibration accuracy of moisture sensor and the investment of agricultural production. For example, while the calibration precision of soil temperature and salinity is respectively 1%, the costs can be reduced by 30%.     

Flowability,moisture sorption and thermal properties of tef [Eragrostis tef (Zucc.) Trotter] grain flours

Recently tef is attracting the attention of the modern food industry since it is a gluten-free grain encompassing highly appreciated nutritional advaxntages. As a relatively new raw material, little information on its handling and processing properties is available. Flowability, water sorption characteristics and thermal properties of flours from three Ethiopian tef varieties were studied. Wheat (whole and refined) and rice flours were included as references. Tef flours were less flowable than the reference flours and their flow properties were more sensitive to water activity changes. Tef flours led to sigmoidal sorption isotherms with estimated monolayer water content of 0.053 (BET model) and 0.057 (GAB model) g water/g dry solids. No significant differences among the three tef varieties were observed on their gelatinization enthalpies that were higher than that of wheat and similar to rice. The amylopectin recrystallization extent after 7 days of storage at 4 °C was significantly higher in tef than in wheat flour.     

不同通风工艺在浅圆仓中应用的研究

在对大豆进行冬季通风作业时,采用正压上行压入式、负压下行吸出式和先负压后正压三种作业方式分阶段进行通风,充分的利用自然冷源,达到降温目的,通过对比三种作业方式的降温效果、水分损耗、降温能耗、人工投入等,并根据粮情,找出最合适的通风方式。     

Influence of salinity and moisture on the threshold shear velocity of saline sand in the Qarhan Desert,Qaidam Basin of China: A wind tunnel experiment

Determination of the threshold shear velocity is essential for predicting sand transport, dust release and desertification. In this study, a wind tunnel experiment was conducted to evaluate the influence of salinity and moisture on the threshold shear velocity of saline sand. Saline sand samples (mean particle size of 164.50-186.08 μm and the total silt, clay and salt content of 0.80%-8.25%) were collected from three saline sand dunes (one barchan dune and two linear dunes) in the Qarhan Desert, Qaidam Basin of China. Original saline sand samples were placed in two experimental trays for wet and dry processing to simulate deliquescence and desiccation, respectively. Surface moisture content ranging from 0.30% to 1.90% was generated by the steam method so that the saline sand can absorb water in a saturated water vapor environment. The motion of sand particles was determined by the observers with a solid laser. The laser sheet (0.80 cm thick), which was emitted by the solid laser, horizontally covered the sand surface and was bound to the sand. Results show that the cohesion of saline sand results from a combination of salt and water. The threshold shear velocity increases exponentially with the increase in crust thickness for the linear sand dunes. There is a positive linear correlation between the original moisture content and relative threshold shear velocity. The threshold shear velocity of dewatered sand is greater than that of wet sand with the same original moisture content. Our results will provide valuable information about the sand transport of highly saline soil in the desert.     

基于变分法的FY-3C土壤水分产品适用性分析

FY-3C作为我国风云三号首颗业务卫星,其上搭载的微波成像仪(MWRI)可提供全天候土壤水分数据。【目的】获取高质量土壤水分数据可以对合理利用土壤水资源提供参考,为农田干旱监控和预报提供基础参数。【方法】选取山东省农业气象站土壤水分数据对FY-3C土壤水分产品进行检验,为获取更高质量FY-3C土壤水分产品,选用变分订正方法对FY-3C土壤水分产品进行偏差订正。【结果】FY-3C升降轨土壤水分产品与地面站土壤水分相关系数R分别为0.481 6和0.408 2,RMSE分别为0.099 6和0.091 0 cm~3/cm~3。订正后FY-3C升降轨土壤水分产品与地面站土壤水分R分别为0.701 4和0.892 4,RMSE分别为0.021 7和0.011 cm~3/cm~3。对2016年3—4月山东省干旱过程订正前、后FY-3C土壤水分变化情况进行对比,订正后FY-3C土壤水分更准确地反映出此次干旱过程。【结论】FY-3C土壤水分产品可以准确反映土壤水分随时间的变化趋势,订正后FY-3C土壤水分产品与地面站土壤水分间误差减小、相关性提高。     

不同裂解温度的污泥生物质炭理化特性分析

研究裂解温度对污泥生物质炭基础理化性质的影响,为安全、合理、高效处置污泥提供理论依据。将干燥污泥分别在200、300、500、700℃下进行热裂解处理(SBC200、SBC300、SBC500、SBC700),获得污泥生物质炭,测定其基础理化特性。结果表明：不同温度制备的污泥生物质炭表面颗粒结构完好,孔径范围均集中在10~50 μm,其中低温生物质炭SBC200表面较光滑,最可几孔径和中值孔径最大,分别为20.1 μm和14.8 μm,高温生物质炭SBC700表面较粗糙,比表面积最大,为5.98 m²/g。随裂解温度的提高,污泥生物质炭的产率、含水量、电导率、挥发分、阳离子交换量显著下降,全碳、氧、全氮、氢含量、有效磷和铵态氮均逐渐降低,pH和灰分含量显著增加。将污泥制备成生物质炭,是安全处置污泥的有效途径,低温制得的污泥生物质炭具有更大的提高土壤肥力的潜力,而高温制得的生物质炭在改良土壤酸性的应用上具有更大的潜力。