The effect of orifice shape and the injection pressure on enhancement of the atomization process for pressure-swirl atomizers

The following paper presents results of studies on the atomization process of water in pressure-swirl atomizers with different shapes of orifice using a laser diffraction technique. The effect of the shape of the orifice and the injection pressure on the droplet size distributions and mean droplet diameters was analyzed. The results obtained showed that droplet size decreases with an increasing injection pressure and droplet size distributions are expanded. The smallest droplet diameters were obtained by atomization in profiled and conical shaped orifice atomizers, however the largest droplet diameters were achieved for plain orifice atomizers. The analysis of the interfacial surface produced by the atomizers has shown that the greater enhancement of the atomization process had occurred using profiled and conical shaped orifice atomizers compared with plain orifice atomizers. The correlation for the Sauter mean diameter as a function of the Reynolds number and the ratio of orifice length to diameter has been proposed. The paper is related to agricultural water management. The data obtained are important from the point of view of the design of atomizers, agricultural treatments and crop protection.     

核桃黑斑病综合防治技术

通过对核桃黑斑病发病侵染规律及原因分析,采取加强水肥土管理,合理修剪,减少密蔽,改善通风透光条件;谨防蛀果害虫;越冬管理;药剂防治的综合措施防治,可有效控制核桃黑斑病的发生危害。     

保定地区几个早熟苹果品种(系)生长观察

为筛选适宜保定地区栽植的早熟苹果品种,以嫁接在SH40中间砧上的不同早熟苹果品种(系)为试材,测定了不同品种(系)早熟苹果树体生长发育指标和果实品质。结果表明:除嘎啦早熟变异外,其他供试品种(系)树体生长较好,3年生时Xu2-7、Xu3-2树高330.0~352.5 cm,4年生时为394.0~417.5 cm,Xu3-2、藤牧1号、信浓红4年生为336.5~381.0 cm。4年生时,干径以Xu2-5最大;短枝、中枝、叶丛枝均以Xu2-5最多,长枝以Xu2-7最多,总枝量以Xu2-5最多;藤牧1号短枝所占比例最高(57.4%)。应用模糊综合评判法得出Xu2-5、Xu2-7、信浓红、藤牧1号果实品质较高。     

花椰菜主要性状遗传规律以及性状相关性分析

总结了花椰菜的单球质量、成熟期、株高株展、花球品质等主要性状的遗传规律以及性状之间的相关性,并得出结论:花椰菜主要性状遗传规律以及性状相关性研究对育种研究具有重要指导意义,但必须注重与田间调查相结合,只有将遗传规律与田间调查有机结合才能提高育种效率,提高育种水平。     

滇朴干基腐朽病发生规律及综合防治

对滇朴干基腐朽病的调查、室内保湿培养、分离鉴定结果表明：引起滇朴干基腐朽的病原为伏革菌科隔孢伏革菌属的乳白隔孢伏革菌。该病害的发生随温度的升高、树龄的增长、降水的减少而逐渐严重，在土壤瘠薄、保水能力差的区域内发病严重。药剂防治80d后，用急救回生丹：金雷：水=1：1：50树干注射、包干的相对防效达86％；枝、干、叶喷70％甲基托布津＋杀毒矾700倍液的相对防效为79％；根部浇灌58％的雷多米尔＋杀毒矾800倍液的相对防效为81％。     

不同根颈直径苜蓿生理生化特性对低温胁迫的响应

为了探究不同颈粗苜蓿（Medicago sativa L.）的抗寒性与其根颈中生理生化特性的关系。以‘公农1号’紫花苜蓿为试验材料,对不同颈粗（3.50 mm,5.25 mm,7.00 mm）苜蓿根系进行低温胁迫（4℃,-10℃,-15℃,-20℃）处理,测定了苜蓿根颈活力、非结构碳氮含量和抗氧化酶活性。结果表明：低温胁迫对苜蓿根颈活力、非结构碳氮含量、非结构碳氮比（Cnstructured carbon nitrogen ratio,C/N）及过氧化氢酶（Catalase,CAT）活性均有极显著影响（P<0.01）;随低温胁迫的增加不同颈粗的苜蓿根颈活力均降低,可溶性糖和可溶性蛋白含量均呈增加-降低-增加的变化,淀粉含量、C/N和CAT活性均呈先增加后降低的趋势;苜蓿根颈活力大小与根颈中可溶性糖含量、可溶性蛋白含量、CAT活性及C/N显著相关（P<0.05）。研究认为,根颈直径大的苜蓿抗寒性较强,其通过调控根颈中可溶性蛋白、可溶性糖含量和CAT活性及C/N以适应低温胁迫。     

Soil aggregate formation and stability induced by starch and cellulose

Soil aggregate (SA) can be formed and stabilized when soil organic matter (SOM) is decomposed in the soil. However, the relationships between the SA dynamics and SOM with different decomposition rates have not been clarified. Therefore, this study examined the effects of the addition of polysaccharides to soil on SA formation and stability. A Japanese tropical soil was incubated for 99 d at 30 °C in a dark environment following the addition of 0.5% (w/w) starch or cellulose. The decomposition rates of the amendments, and SA formation and stability were evaluated by measuring soil respiration rates, and distribution fractions of soil aggregate sizes and mean weight diameter (MWD) of SA, respectively. The cumulative soil respirations with all treatments rapidly increased until Day 12 of the incubation. The initial slope of the cumulative soil respiration in the soil with starch was significantly higher than that in the soil with cellulose. In either soil with starch or cellulose, the fractions of macro-aggregates (>1000 μm in diameter) significantly increased, respectively, compared with control soil. However, the fractions of meso-aggregates (250–1000 μm) and nano-aggregate (<20 μm) in the soil with starch significantly decreased, while those fractions in the soil with cellulose fluctuated until Day 6. The MWDs reached the maximum on Day 6, indicating the SA formation in the soils with starch or cellulose. The increasing rate of the SA formation in the starch-amended soil was greatly higher than that in the cellulose-amended soil. After Day 6, the MWDs in the soils with either polysaccharide decreased with similar trends with no significant differences between treatments, indicating similar stability of the SA in both treatments. This study showed that the different decomposability of the organic amendments might influence the SA formation differently, but not the SA stability.     

Evaluating and Comparing the Natural Cell Structure and Dimensions of Honey Bee Comb Cells of Chinese Bee,Apis cerana cerana (Hymenoptera: Apidae) and Italian Bee,Apis mellifera ligustica (Hymenoptera: Apidae)

The hexagonal structure of the honey bee comb cell has been the source of many studies attempting to understand its structure and function. In the storage area of the comb, only honey is stored and no brood is reared. We predicted that honey bees may construct different hexagonal cells for brood rearing and honey storage. We used quantitative analyses to evaluate the structure and function of the natural comb cell in the Chinese bee, Apis cerana cerana and the Italian bee, A. mellifera ligustica. We made cell molds using a crystal glue solution and measured the structure and inclination of cells. We found that the comb cells of A. c. cerana had both upward-sloping and downward-sloping cells; while the A. m. ligustica cells all tilted upwards. Interestingly, the cells did not conform to the regular hexagonal prism structure and showed irregular diameter sizes. In both species, comb cells also were differentiated into worker, drone and honey cells, differing in their diameter and depth. This study revealed unique differences in the structure and function of comb cells and showed that honey bees design their cells with precise engineering to increase storage capacity, and to create adequate growing room for their brood.     

CORRELATIONS AMONG ULTRASONOGRAPHIC MEASUREMENTS OF OPTIC NERVE SHEATH DIAMETER,AGE, AND BODY WEIGHT IN CLINICALLY NORMAL HORSES

Early diagnosis of high intracranial pressure (ICP) is critical for minimizing progressive brain injury due to reduced cerebral perfusion. In people, detecting enlargement of the optic nerve sheath diameter (ONSD) by transpalpebral ultrasonography has been found to be an accurate test for high ICP. Aims of this prospective, observational, cross‐sectional study were to test hypotheses that (1) ultrasonographic measurement of ONSD would be repeatable in horses, (2) have acceptable interobserver agreement, and (3) would be correlated with age and body weight. The sample population included 48 horses without clinical signs of high ICP and with varying ages and body weights. Two observers independently performed ONSD measurements in both eyes. All measurements ranged from 2.6 to 6.5 mm. The mean difference of repeated measures within observers was ≤0.1 mm and the coefficients of variation ranged from 5.0% to 8.8%. The mean difference of measures between observers was ≤0.2 mm. After correcting for performing multiple tests, no significant rank correlation (all r < 0.4 [absolute value]) was detected between ONSD and age or body weight. However, we observed smaller ONSD in foals versus adults (all P ≤ 0.002). In the foals, all observed measures of rostrocaudal and dorsoventral ONSD were <5 mm. In the adults, all observed measures of rostrocaudal and dorsoventral ONSD were ≤6.5 mm. Findings indicated that ultrasonographic ONSD measurement is a feasible test for use in horses of varying ages and sizes. Further investigation of this ultrasonographic measure as a clinical test for horse with suspected high ICP is warranted.     

Penetration behavior of bath induced by top-blown gas jets for steelmaking converter

The cavity induced by top-blow gas jets impinging on the bath surface is one of most important parameters, which has overwhelming influence on the rate of slag formation and metallurgical performance. Water model experiments are conducted through a 1/10 scaled-down top-blown convertor. Effects of lance height and gas flow rate on penetration behavior are studied, and also the influence mechanism of liquid surface tension on penetration depth is addressed based on the experiments and theory analysis. An energy utilization index (EUI) is defined to reflect how much the impinging kinetic energy of gas jets are transferred into bath for formation of cavity, and an improved model is proposed to predict penetration depth of jets. The results show that penetration depth increases with lowering lance height and increasing gas flow rate, and impact diameter increases with increasing lance height, but is little affected by gas flow rate. Influence of liquid surface tension on penetration depth is enhanced with increasing surface tension and penetration depth. The EUI increases with increasing lance height, and a function relationship of it with lance height is obtained based on the experiments.