马来海松酸型聚氨酯烘漆耐热性研究

以马来海松酸酯多元醇为原料，制备了马来海松酸型聚氨酯烘漆，利用热重法，讨论了不同原料组分及配比，固化温度和固化时间等因素对烘漆耐热性的影响，另外，还利用ＤＳＣ，对二月桂酸二丁基锡对封闭异氰酸酯组分热解封温度的影响了讨论。     

LF-1型低毒脲醛树脂的固化和固化反应动力学

本文通过热分析研究了脲醛树脂的催化固化反应。比较了几种固化剂的性能,选择有效的固化剂,确定最佳固化条件以及判断树脂的固化深度。反应动力学研究结果表明,脲醛树脂的固化过程可用自加速型反应机制描述,固化反应动力学模型为:da/dt=3.685×10~(13)e~(-92110/(RT))α~(0.8)(1-α)~(1.2),活化能E=92.11kJmol~(-1),前置因子A_0=3.685×10~(13)min~(-1)。     

Experimental verification of<Emphasis Type="Italic"> Lasioderma serricorne</Emphasis> (F.) pupa development threshold previously defined using the thermal constant equation K=D(T−t)

This work verifies the development threshold of the pupal stage of L. serricorne whose larva fed exclusively on dried tobacco leaves. In previous work, using the thermal constant equation, this threshold was found to be 13.8 °C and the thermal constant to range from 89.05 to 94.05 day-degrees (°C). Lower temperatures, 10.5±0.5, 11.5±0.5 and 12.5±0.5 °C, close to this threshold, were tested in the absence of light and at a relative humidity of 65±3% . It was found that no development of either larva or pupa exists below this threshold     

高温水供热干燥速生杉木方材

运用高温水供热系统干燥速生杉木方材。生产性试验表明，6天内初含水率为55．5％的杉木方材干至始含水率5．4％，干燥质量符合细木工板生产的要求（少数高含水率木材除外）。此干燥法集中供热，具有热效率高、运行安全和经济可行等特点。     

Thermal properties of interior decorating material and the sensation of cold/warm by contact II: the relations among heat flux, temperature change of material, and sensation of cold/warm by contact

The main purpose of this study was to investigate the changes in heat flux and temperature after the subject's palm was in contact with interior decorating materials. The relations among heat flux, temperature, and sensation of cold/warm during contact were studied. Ten men and ten women were selected and introduced to 21 materials for the contact test. They were in contact with the specimens for 30min without seeing them in a climate-controlled room at 25°±1°C and 65% RH. Changes in the heat flux and temperature of the specimens were determined by a heat flux meter. A sensory evaluation test was applied to evaluate the cold-warm contact. Results indicated that the heat flux and temperature increased with increasing time after the subject's palm was in contact with the specimens. The heat flux (Q ₃₀) and temperature (T ₃₀) 30min after the subject's palm contacted the specimens were greater for male subjects than for female subjects. A positive linear regression equation existed between the values for Q₃₀ andT ₃₀, whereas a negative linear regression formula existed the sensation of cold-warm by contact (5) and the values of ln(Q ₁·). Therefore, the sensation of cold/warm by contact could be estimated simply by using the thermal physical properties of the interior decorating materials.Part of this report was presented at the International Conference on Effective Utilization of Plantation Timber, Chi-Tou, Taiwan, ROC, May 1999     

用有限元法分析木材中的温度分布

在木材应用中,了解温度在木材中的分布情况,掌握木材在受热时的温度场,才能有效地控制解冻,才能对干燥和防腐问题进行深入的研究,才能合理使用建筑围护材料。近年来,随着计算机应用和计算技术的发展,用数值方法求解木材中的热传导问题将成为有效、实用的方法。在许多种数值方法中,有限差分法和有限元法是目前较为成熟和用得普遍的方法。其中的有限元法是对古典近似计算的归纳和总结,它吸取了有限差     

杉木采伐对集水区土壤热状况的影响

土壤作为森林生态系统的子体系 ,是林木扎根并赖以生存的基础 ,也是土壤微生物一切生命活动的场所。因此 ,有关土壤养分、水分及其土壤物理结构特征等方面的研究报告颇多 (王政权等 ,2 0 0 0 ;张合平等 ,1 997)。但是有关森林土壤的热状况 ,以及林木采伐后对土壤热状况影响的研究报导很少 (康文星等 ,1 989;刘煊景等 ,1 993)。本文在获得采伐前连续 3年和采伐后连续 3年的观测数据的基础上 ,就杉木人工林生态系统土壤的热状况各因子之间 ,土壤各组成成分对热状况的单一或组合效应 ,以及皆伐这种人为强烈干扰对土壤热状况的影响进行了剖析。…     

应用热扩散式探针法对南方红壤丘陵区湿地松人工林耗水量的研究

运用Granier热扩散式探针法对湿地松(Pinus elliottii)树干液流密度进行长期连续测定,并对其周围多个气象要素和土壤要素进行同步测定。湿地松生长旺季不同月份晴天液流密度日变化规律基本一致,但液流启动、到达峰值的时间以及开始升高、开始下降的时间间隔存在差异。样木解析结果表明,处于低龄期的湿地松,整个木质部都可看作边材,边材面积和胸径可用二次函数很好地拟合。方差分析结果表明:不同胸径湿地松树干液流密度不存在显著性差异,与胸径无紧密关系。回归分析结果表明:湿地松日累计液流量与边材面积呈显著的线性相关关系,相关关系的判定系数达0.99。另外,单位边材面积日累计液流量与入选各气象因素的相关性显著,相关程度大小顺序为光合有效辐射>冠层相对湿度>冠层温度。结合边材面积-胸径回归方程和样木胸径调查资料,分别采用2种方法推算整个标准地的耗水量。经比较,2种方法所得结果差别不大,各自适用于一定的范围。     

Effects of high temperature kiln drying on the practical performances of Japanese cedar wood (Cryptomeria japonica) I: changes in hygroscopicity due to heating

The effect of heating on the hygroscopicity of Japanese cedar wood was investigated as a simple evaluation of thermal degradation in large-dimension timber being kiln-dried at high temperatures (>100°C). Small wood pieces were heated at 120°C in the absence of moisture (dry heating) and steamed at 60°, 90°, and 120°C with saturated water vapor over 2 weeks, and their equilibrium moisture contents (M) at 20°C and 60% relative humidity (RH) were compared with those of unheated samples. No significant change was induced by steaming at 60°C, while heating above 90°C caused loss in weight (WL) and reduction in M of wood. The effects of steaming were greater than those of dry heating at the same heating temperature. After extraction in water, the steamed wood showed additional WL and slight increase in M because of the loss of water-soluble decomposition residue. The M of heated wood decreased with increasing WL, and such a correlation became clearer after the extraction in water. On the basis of experimental correlation, the WL of local parts in large-dimension kiln-dried timber was evaluated from their M values. The results indicated that the thermal degradation of inner parts was greater than that of outer parts.     

大功率拖拉机强制润滑的仿真和试验

为了研究大功率拖拉机强制润滑系统的流量分配特性,基于AMESim分析平台建立了某系统的热液压流体模型,仿真得出强制润滑系统的流量分配特性,并用试验证明了热液压仿真结果的正确性,为液压润滑系统流量分配的改进设计提供依据。