发展木材工业,促进林业可持续发展

本文从发展木材工业的七个不同层面,论述了木材工业发展与生态建设和林业可持续发展的关系,指出发展木材工业与生态建设和林业可持续发展是相互依存、相互促进的,不仅可增加林产品供给,还可大量节约木材,保护森林资源,推动林木培育,增加森林资源,有力地支持生态建设,促进林业可持续发展.     

木材防腐剂的登记及质量监督制度探讨

对国内木材防腐的状况、木材防腐剂对人的毒性及对环境的影响、木材防腐剂登记的重要性及措施、防腐材的质量监督制度、以及目前防腐产业面临的迫切问题进行了简要的概述并提出了建议.     

气候因子对木材特性影响的研究进展

对国内外在木材学、气象学、植物学等领域内有关气候因子对木材特性影响的研究现状进行了总结和分析，阐述了进行气候因子对木材特性的影响研究的重要意义；光照因子、温度因子、湿度因子、降水因子以及自然灾害对木材特性的影响规律；气候因子对木材特性影响的研究方法；同时展望了气候因子对木材特性影响研究的发展方向。     

Liquefaction and product identification of main chemical compositions of wood in phenol

To clarify liquefaction ratios and their construction variations of the main chemical compositions of wood in phenol using phosphoric acid as a catalyst, the chemical ingredients of wood such as holocellulose, cellulose and lignin, were measured and extracted according to GB methods. With Fourier transform infrared （FTIR）, the product identification of reactant before and after liquefaction in phenol was investigated. The molecular weights and their distributions of the liquefaction results （acetone soluble parts） were studied by gel permeation chromatography （GPC）. Results show that the molecular weights and their distributions of poplar and Chinese fir are almost the same. In poplar, the distribution of cellulose is the largest, and that ofholocellulose the smallest after liquefaction. For Chinese fir, the distribution of holocellulose is the largest, and that of cellulose the smallest. After liquefaction of poplar cellulose, the change bands of FTIR spectrum observed below 1 600 cm^-1, can be attributed to new substitute groups. The same is true for poplar lignin. For Chinese fir, the spectra of liquefaction results of all chemical compositions differ from that of wood meal. This reveals the more activity groups were produced because of the reactions between Chinese fir and phenol. The research shows that the liquefaction ratios of poplar decrease in the following order： holocellulose 〉 lignin 〉 cellulose, and those of Chinese fir in the order： lignin 〉 cellulose 〉 holocellulose.     

纳米科技与21世纪的木材工业

总结了木材科学中已被采用的一系列纳米探测技术和研究成果。探讨了如何用现代化的先进设备和探测技术去检测与表征木材中的纳米结构。并预测了 2 1世纪的木材纳米技术的发展和产业化的前景。     

杨树微纤丝角的变异及其与木材性质的相关关系

微纤丝角为细胞次生壁S2层微纤丝排列方向与细胞主轴所形成的夹角,与木材的物理性质、力学性质和化学性质都有着直接的关系。应用x射线衍射法测定了7个杨树无性系(14株样木)胸径处各年轮的微纤丝角,并对应分析和测定了各年轮的木材基本密度、纤维长度、纤维宽度和纤维素含量。研究结果表明,杨树微纤丝角在年轮间存在显著差异,其径向变异规律为从髓心向外以微纤丝角逐渐降低,年轮间的平均微纤丝角在7.8旱?8褐洌荒静幕久芏取⑾宋ざ取⑾宋矶群拖宋睾吭谀曷旨湟泊嬖谙灾钜臁O喙胤治霰砻鳎⑾怂拷怯肽静幕久芏取⑾宋ざ取⑾宋矶群拖宋睾看嬖谙灾母合喙毓叵??0.01),相关系数分别为-0.450、-0.586、-0.516和-0.660。回归分析结果表明,多项式方程可较好地描述杨树微纤丝角与所测定的木材性质的关系,相关系数均在-0.45以上(n=125)。本文的研究结果认为,在今后针对杨树材性改良的育种计划中,微纤丝角是一个重要的选育和改良指标。图3表3参34。     

木材微波干燥技术与应用

1木材微波干燥的原理木材微波干燥是以湿木材作为电介质,放置于微波电磁场中,在频繁交变的电磁场作用下,使木材中水分子极化,极化水分子迅速旋转,相互摩擦,产生热量,从而加热和干燥木材。湿木料在微波电磁场中吸收的电功率可表示为:p=0.55fE2εtgδ10-12式中:p—单位体积木材吸收的电功率;f—电流频率;E—电场强度;ε—木材的介电系数;tgδ—木材损耗角正切。由上式可以看出,电场强度E越大,电流频率f越高,木材吸收的电功率就越多。这是因为电场越强,极化的水分子摆动的振幅越大,摩擦产生的热量就越多。但过高的电场强度,容易使木材击穿,这…     

杉木、马尾松裸根苗水分关系研究

Water relation parameters of bare-root seedlings of Chinese fir (Cunninghamia lanceolata Hook.)and Masson pine (Pinus massoniana Lamb.)were measured and changes of root growth potential as well as field survival rate of both species were studied after the bare-root seedlings were exposed in a sunny field condition.the results showed that masson pine had a lower osmotic potential(-2.07Mpa) at turgor loss point and at full turgor(-1.29Mpa),compared with Chinese fir(-1.80Mpa and -1.08Mpa respectively).The parameter Vp/Vo(63.27%) of Masson pine was higher than that of chinese fir (58.03%).This means that Masson pine has a stronger ability to tolerate desiccation,compared to Chinese fir according to analysis of above water relation parameters.Root growth potential and field survival rate decreased with prolonging duration of exposure.The field survival rate of both species was reduced to less than 40% after the seedling being exposed only two hours.Water potentials of -1.60 Mpa and -1.70 Mpa were suggested to be critical values for Chinese fir and Masson pine respectively in successful reforestation.     

低毒防腐剂百菌清及铜制剂对木材尺寸稳定及力学性能的影响

百菌清（CTL）、氨浴季铵铜（ACQ）、氨溶柠檬酸铜（ACC）处理马尾松（Pinus massoniana)、毛白杨（Populus tomentosa)后对木材尺寸稳定性及MOE／MOR的影响本文进行了研究。结果表明，除剂量11．48kg/m^3的百菌清处理的毛白杨外，以上防腐剂处理试材后吸水至饱和时的尺寸稳定性与对照相比有不同程度的增加，幅度为3．9％－28．05；各处理对抗弯弹性模量（MOE）影响幅度不大，其中对于马尾松，MOE差异不明显，对于毛白杨，各处理对MOE稍有增加（百菌清乳剂处理除外），幅度6．3％－8．1之间。各制剂处理马尾松、毛白杨后对抗弯强度（MOR）影响不明显。     

木材材性株内径向变异模式初探──Ⅲ.种植密度对湿地松、火炬松木材密度径向变异模式的影响

对两个地区不同种植密度的湿地松、火炬松进行了微密度分析，研究了种植密度对木材密度径向变异模式的影响。主要结果是：种植密度对湿地松和火炬松各密度特征值径向变异模式的影响，主要表现在变异曲线平均水平高低的变动，而对变异曲线形状的影响并不显著。种植密度对湿地松和火炬松各年轮宽特征值径向变异模式的影响，主要表现在年轮宽度RW和早材宽度EW变异曲线平均水平高低的变动和RW、EW与晚材宽度LW变异曲线形状的变动。种植密度对年轮密度RD的影响从年轮内宽度和年轮密度变异曲线平均水平高低两个方面起作用，出现较复杂的情况，并非所有情况下都是单调的正相关。