Edible arabinoxylan-based films. 1. Effects of lipid type on water vapor permeability,film structure,and other physical characteristics

Arabinoxylans (AX) are natural fibers extracted from maize bran, an industrial byproduct. To promote this polymer as a food ingredient, development of edible coatings and films had been proposed. Indeed, composite arabinoxylan-based films were prepared by emulsifying a fat: palmitic acid, oleic acid, triolein, or a hydrogenated palm oil (OK35). Lipid effects on water vapor permeability (WVP), surface hydrophobicity (contact angles), lipid particle size, and mechanical properties were investigated. Results showed that OK35-AX emulsion films had the lowest WVP. Emulsified films presented a bimodal particle size distribution; however, the smallest particle mean diameter (0.54 microm) was observed in OK35-AX emulsion films. Contact angles of water comparable to those observed for LDPE films (>90 degrees ) are measured on the OK35-AX film surface. Finally, only triolein-AX emulsion films had elongation higher than films without lipid. These results suggest that OK35 enhances functional properties of AX-based films and should be retained for further research.     

Effects of type of added salt and ionic strength on physicochemical and functional properties of casein isolates produced by electroacidification

A procedure developed for soybean protein precipitation which was based on electrodialysis was tested for the production of acid casein from reconstituted skim milk. In a previous paper, the performance of bipolar membrane electroacidification (BMEA) was evaluated under different conditions of ionic strength (micro(added) = 0, 0.25, 0.5, or 1.0 M) and added salt (CaCl(2), NaCl, or KCl) (1). The aim of this study, which is the complement of the work on evaluation of BMEA performance, was to evaluate the functionality of the protein isolates produced by BMEA and to compare the BMEA isolates to commercial isolates and an isolate produced by chemical acidification. It was not possible to show differences between the functional properties of isolates produced by BMEA, except at 1 M CaCl(2) micro(added), due to the variability of the isolates. However, the results showed that it is possible to obtain isolates similar to commercial isolates and that the addition of salt during the process does not induce variations in functional properties. From results on mineral concentrations, it appeared that the addition of monovalent cations did not influence the retention of monovalent or divalent cations in the BMEA isolates, while addition of divalent cations (CaCl(2)) influenced the retention of magnesium. According to previous results on evaluation of BMEA performances under different conditions of ionic strength and added salt, the difference observed for the BMEA isolate produced at 1.0 M CaCl(2) was confirmed.     

Nutrient Loading by Precipitation in the Maracaibo Lake Basin, Venezuela

Nutrient content and pH of rain samples collected at nine sites during 1988-1996 were studied to determine the amounts of N, P and S added by precipitation over Maracaibo Lake basin. The basin is a wide depression occupied by Lake Maracaibo and extensive alluvial plains and delimited by a mountainous zone of variable physiolgraphic characteristics with different cattle ranching and industrial activities. Rain pHs averaged ≈ 4 to 6, individual samples occasionally reached as low as pH 3 in the south basin. NH₄ ⁺ levels were significantly higher (up to 2.6 mg/l NH₄-N) than NO₃ ^? plus NO₂ ^?. Phosphorus levels were low, ranging from undetectable to 1.5 mg/l. The amounts of inorganic N/ha/yr added ranged from ≈ 5.4 Kg in the north to ≈ 8 Kg in the south basin; around the lakeshore, it was estimated that ≈ 9.8–16.8 Kg TN/ha (≈ 55 % as organic-N) are annually deposited. The annual amounts of SO₄-S/ha added range from ≈ 10 to 13 Kg. The contribution of precipitation to P in the ecosystem is very small; ≈ 0.02 – 0.8 Kg of PO₄-P/ha/yr was added in basin. The results of this study show that precipitation represents a significant factor for the total nitrogen and sulfur loading to Maracaibo Lake Basin.     

Origin of French virgin olive oil registered designation of origins predicted by chemometric analysis of synchronous excitation-emission fluorescence spectra

The authentication of virgin olive oil samples requires usually the use of sophisticated and very expensive analytical techniques, so there is a need for fast and inexpensive analytical techniques for use in a quality control methodology. Virgin olive oils present an intense fluorescence spectra. Synchronous excitation-emission fluorescence spectroscopy (SEEFS) was assessed for origin determination of virgin olive oil samples from five French registered designation of origins (RDOs) (Nyons, Vallée des Baux, Aix-en-Provence, Haute-Provence, and Nice). The spectra present bands between 600 and 700 nm in emission due to chlorophylls a and b and pheophytins a and b. The bands between 275 and 400 nm in emission were attributed to alpha-, beta-, and gamma-tocopherols and to phenolic compounds, which characterize the virgin olive oils compared to other edible oils. The chemometric treatment (PLS1) of synchronous excitation-emission fluorescence spectra allows one to determine the origin of the oils from five French RDOs (Baux, Aix, Haute-Provence, Nice, and Nyons). Results were quite satisfactory, despite the similarity between two denominations of origin (Baux and Aix) that are composed by some common cultivars (Aglandau and Salonenque). The interpretation of the regression coefficients shows that RDOs are correlated to chlorophylls, pheophytins, tocopherols, and phenols compounds, which are different for each origin. SEEFS is part of a global analytic methodology that associates spectroscopic and chromatographic techniques. This approach can be used for traceability and vindicates the RDOs.     

University Isotope Separator at Oak Ridge: The UNISOR Consortium

The UNISOR cooperative project, envisioned more than 3 years ago, is now successfully working. Research problems that involve a full range of experiments on nuclei far from beta stability are being investigated jointly by groups of scientists from several institutions. Some of the first work reported (16) included the identification, half-lives, and decay schemes of three new isotopes, (186)T1, (188)T1, and (116)I; the first or new decay schemes of (189)T1, (190)T1, (117)Xe, and (117)I; and the results of the perturbed gamma-gamma directional correlation work in (126)Xe. UNISOR is already stimulating international interest. A report (1) on the new research being planned with an isotope separator on-line to ORIC was presented at a Soviet Academy of Sciences meeting on nuclear structure in 1971. At an international nuclear physics conference in Munich in August 1973, Academician G. N. Flerov, director of the heavy-ion laboratory in Dubna, said the UNISOR project had inspired his laboratory to secure funds for a new, much improved isotope separator which is now installed on-line to their heavy-ion cyclotron to be used for detailed studies of nuclei far from stability. The UNISOR model for research has inspired a second such project, the Atomic Physics Consortium at Oak Ridge (APCOR). After an exploratory conference at Oak Ridge, scientists from ten institutions met in November 1973 to form an organizing committee for APCOR. As with UNISOR, the universities and the AEC will each provide a significant portion of the capital and operating costs. Heavy ions have opened up much new research in atomic physics, but such accelerator-based research represents a real "shift from traditional approaches concerning how, where, and on what time scale atomic physics experiments should be done" (17).     

Infant carrying by male chacma baboons

Male chacma baboons, Papio ursinus, carry their offspring during confrontations with higher ranking immigrant males, who are a threat to the infants' lives. The infants sometimes initiate these confrontations by approaching and provoking immigrant males when protective males are close by. Mothers rarely interfere during these interactions.     

The Gelation of CO(2): A Sustainable Route to the Creation of Microcellular Materials

Compounds with strong thermodynamic affinity for carbon dioxide (CO(2)) have been designed and synthesized that dissolve in CO(2), then associate to form gels. Upon removal of the CO(2), these gels produced free-standing foams with cells with an average diameter smaller than 1 micrometer and a bulk density reduction of 97 percent relative to the parent material.