Infrared spectroscopic study of alkaline oxygen treatment of lignin with ATR technique in aqueous state 1: method for determining quantitative spectra of oxygen-degraded lignin

For the fundamental study of oxygen delignification of kraft pulp, structural changes of kraft lignin during alkaline oxygen treatment were investigated with the use of infrared measurement with attenuated total reflectance (ATR) technique. In the neutralized reaction mixture of alkaline oxygen-treated kraft lignin, there is a significant amount of NaCl, so that the spectral changes of water due to the coexistence of NaCl was investigated, and how to remove the huge absorption of NaCl solution is discussed. Sodium vanillate–NaCl solutions were employed as model solutions for the reaction mixture. Partial least square (PLS) regression was applied for the prediction of NaCl concentration, and the spectrum of NaCl solution was subtracted from the spectrum of sodium vanillate–NaCl solution as background measurement. This allowed us to obtain the vanillate spectra free from the absorption of NaCl solution. In addition, the mathematical method for reconstructing the spectrum of NaCl solution is discussed. The spectrum of NaCl solution is reconstructed as the linear combination of basic spectra calculated by singular value decomposition (SVD), and it was subtracted from that of the sodium vanillate–NaCl solution. By this procedure, the vanillate spectra were also obtained quantitatively, as has been demonstrated in PLS regression study. It was also confirmed that the quantitative spectra of high molecular weight fraction of alkaline oxygen-treated kraft lignin were obtained by the use of this reconstruction technique.Parts of this report were presented at the 52nd Annual Meeting of the Japan Wood Research Society, Gifu, Japan, April 2002 and the 12th International Symposium on Wood and Pulping Chemistry, Madison, USA, June 2003     

Delignification of cell walls of <Emphasis Type="Italic">Chamaecyparis obtusa</Emphasis> during alkaline nitrobenzene oxidation

To clarify the behavior of whole lignins in wood cell walls during alkaline nitrobenzene oxidation, the delignification process from cell walls in normal and compression woods of Chamaecyparis obtusa Endl. (Cupressaceae) was observed using ultraviolet and transmission electron microscopies. The lignin content conspicuously decreased to around 10% after 35min in normal wood. The lignin content in compression wood finally leveled off at aroumd 10% after 50min. In gel filtration of oxidation products in ethyl acetate, a high molecular weight fraction was prominent in extracts from the early stage of the reaction. As the oxidation progressed, the high molecular weight fraction became less prominent in both normal and compression wood. Changes in the weights of cell wall residues during reaction indicated that approximately half of the components other than lignin were also removed from the cell walls. This shows that the majority of lignin with relatively high molecular weight is removed from the cell walls together with polysaccharides in the early stage of the reaction and that further oxidative degradation occurs in solution in later stages. Only a small amount of the lignin with low molecular weight could be analyzed by gas chromatography.Parts of this report were presented at the 47th (Kochi, April 1997) and 48th (Shizuoka, April 1998) Annual Meetings of the Japan Wood Research Society, and at the Lignin Symposium, Sapporo, October 1997     

Prediction of bending stiffness and moment carrying capacity of sugi cross-laminated timber

Cross-laminated timber (CLT) panels consist of several layers of lumber stacked crosswise and glued together on their faces. Prototype sugi CLT floor panels were manufactured and bending tests were carried out under the different parameters of lumber modulus of elasticity (MOE), number of layers, thickness of lumber and thickness of CLT panels. On the basis of above tests, bending stiffness and moment carrying capacity were predicted by Monte Carlo method. MOE of lumber was measured by using grading machine and tensile strength of lumber was assumed to be 60 % of bending strength based on the obtained bending test. Bending stiffness EI of CLT panels could be estimated by adopting composite theory and equivalent section area. Experimental moment carrying capacity showed 12 % higher value than the calculated moment carrying capacity by average lumber failure method, and also showed 45 % higher value than the calculated moment carrying capacity by minimum lumber failure method due to the reinforcement of the outer layer by the neighboring cross layer.     

Nondestructive detection of cracks near the surface of wooden boards by dynamic heat dissipation

A method to detect cracks near the surface of wooden boards has been developed where the change in surface temperature of the wood sample is monitored using an infrared camera following momentary heating by a flash. Cylindrical holes simulating cracks were drilled into the wood samples, and blackbody paint was painted onto the surface of the samples to assist flash absorption. This method uses the dynamic heat transport process from the blackbody paint to the surface of the wood sample to the cracks over a short timescale. The theoretical foundations of the observation method were outlined, and the technique was verified in experiments with samples of Cercidiphyllum japonicum, Western red cedar, Japanese cedar, Balsa, and medium-density fiberboard. The developed technique is able to detect the presence of holes located near the surface of some samples. However, this method could not detect the presence of holes in Balsa nor holes located deeper than 1 mm from the surface of the sample. A theoretical analysis of these phenomena was provided to help interpreting them.     

Molecular and biological characterization of <Emphasis Type="Italic">Chrysanthemum stem necrosis virus</Emphasis> isolates from distinct regions in Japan

Three isolates of Chrysanthemum stem necrosis virus (CSNV) were obtained from chrysanthemum plants in distinct regions of Japan in 2006 and 2007. All the original host plants showed severe necrotic symptoms on the leaves and stems. Amino acid sequence data of the nucleocapsid protein genes of the three isolates (CbCh07A, TcCh07A, and GnCh07S) showed high identities with those of two other CSNV isolates, HiCh06A L1 from Japan and Chry1 from Brazil. Furthermore, for the first time the complete nucleotide sequence of the S RNA was determined for CSNV (isolate HiCh06A). In phylogenetic analysis based on the non-structural protein genes from the genus Tospovirus, HiCh06A L1 was placed in the same genetic group as Tomato spotted wilt virus (TSWV) and Impatiens necrotic spot virus. Host range examination for isolates HiCh06A L1 and CbCh07A showed that green pepper (cv. ‘Kyoyutaka’, ‘Saitamawase’, ‘Tosakatsura’, ‘L3 sarara’ and ‘L3 miogi’) and tomato (cv. ‘Sekaiichitomato’) were systemically susceptible hosts, whereas TSWV-resistant Solanaceae species, Capsicum chinense, Lycopersicon peruvianum and a TSWV-resistant cultivar of green pepper (cv. TSR miogi), were resistant.     

The mechanism of resistance to lindane and hexadeuterated lindane in the Third Yumenoshima strain of house fly

The factors which cause lindane resistance in the Third Yumenoshima strain, a strain of house flies highly resistant to insecticides, were studied using hexadeuterated lindane. Hexadeuterated lindane has the same physicochemical properties as lindane, but the former is much less biodegradable than the latter. The LD₅₀ ratio of lindane to hexadeuterated lindane in this strain, deuterium isotope effect on LD₅₀ values, was larger than that in S_NAIDM, a susceptible (nonresistant) strain. The penetration rates of labeled and nonlabeled lindane through the insect cuticle were about the same for both strains. Thus, penetration rate does not cause resistance. The metabolic degradation of lindane in the resistant strain in vivo occurred much faster than in the susceptible strain. This was also the case for lindane degradation processes in vitro such as microsomal oxidation and glutathione conjugation. In both strains, significant isotope effects were observed in the degradation rates in vitro of labeled and nonlabeled lindane. Therefore, principal biodegradation and detoxication pathways should include reactions which cleave the CH bonds. When the much less biodegradable d₆ counterpart of lindane was applied to both strains, the susceptible strain became much more highly intoxicated than the other within 20 to 30 min. This indicates that a combination of both greater degradability and probably lower sensitivity at the action site are the main factors underlying resistance in the Third Yumenoshima strain.