Wavelet Edge Detection Method Based-on Multi-scale Fuzzy Logic

A novel edge detection algorithm is proposed by implementing fuzzy image enhancement at different scales.The implement of this algorithm can reduce the negative influence bring from the non-maximum suppression algorithm which select only one threshold.The success of the approach depends on the selection of a general fuzzy operator(GFO) for the enhancement of contrast of region after smoothing of image at different scales.Consequently,it is more obvious that coarse intensity changes are obtained at a large scale whereas the fine details of intensity changes are obtained at a small scale.A pretty performance is obtained by used this work.     

A Study on the FMS Planning and Scheduling System

After researching the function requirements of the planning and scheduling in manufacturing cells, the paper advanced a control structure with three phases, i. e. planning , scheduling and dispatching. The paper represented in detail the main purposes, requirements and scheduling actions in each phase. It suits to general machining FMSs.     

喷油嘴流量系数对柴油机性能的影响

研究了喷油嘴流量系数变化对单缸直喷柴油机性能的影响。结果表明,增大流量系数对ZH1105柴油机标定工况和低速大转矩工况的烟度和燃油消耗率有明显影响。通过对燃油喷雾的分析,揭示了流量系数影响柴油机性能的原因。     

Effect of soil matric potential on tomato yield and water use under drip irrigation condition

Field experiment was carried out to investigate the effect of soil matric potential (SMP) on tomato yield, evapotranspiration (ET), water use efficiency (WUE) and irrigation water use efficiency (IWUE) under drip irrigation condition in North China Plain. The experiment included five treatments, which controlled SMP at 0.2 m depth immediately under drip emitter higher than −10 (S1), −20 (S2), −30 (S3), −40 (S4) and −50 kPa (S5), respectively, after tomato plant establishment. The results showed that different SMP affected irrigation amount and tomato ET. Irrigation amount decreased from 185 mm (S1) to 83.6 mm (S5) in 2004, and from 165 mm (S1) to 109 mm (S5) in 2005, respectively. The ET decreased from 270 mm (S1) to 202 mm (S5) in both years. However, it was found that SMP did not affect the tomato yield significantly, for the range of SMP investigated. Both WUE and IWUE increased as SMP decreased. The maximum WUE (253 and 217 kg/ha mm) and IWUE (620 and 406 kg/ha mm) were for S5 in 2 years, whereas the minimum WUE (178 and 155 kg/ha mm) and IWUE 261 and 259 kg/ha mm) were for S1 in 2004 and 2005. Based on the above results, therefore, it is recommended that if the tomatoes are well irrigated (SMP is higher than −20 kPa) during establishment, controlling SMP higher than −50 kPa at 0.2 m depth immediately under drip emitter can be used as an indicator for drip irrigation scheduling during following period of tomato growth in North China Plain.     

苹果汁中展青霉素的去除动力学与热力学研究

利用Langmuir、Freundlich及Temkin吸附等温模型对LSA-800B型树脂吸附苹果汁中展青霉素的等温线数据进行拟合,确定较佳吸附模型,并且对吸附过程的热力学性质进行研究。此外,利用Lagergren拟一级、Mc Kay拟二级吸附速率模型和Weber-Morris颗粒内扩散模型对LSA-800B型树脂吸附苹果汁中展青霉素的静态吸附过程进行分析,确定较佳的吸附速率模型及吸附机理。结果表明:LSA-800B型树脂吸附苹果汁中展青霉素符合Freundlich吸附等温模型;吸附自由能变量ΔG0,证明LSA-800B型树脂对展青霉素的吸附是自发的物理过程;吸附焓变量ΔH0,说明吸附过程是放热过程,温度降低有利于展青霉素的吸附;吸附熵变量ΔS0,说明水分子不易对被吸附的展青霉素进行解析,解析过程需要其他溶剂;Lagergren拟一级吸附速率模型适合描述吸附过程的动力学,WeberMorris颗粒内扩散模型揭示其吸附过程由液膜扩散和颗粒内扩散共同控制。     

基于气温预报和神经网络的参考作物腾发量预报

采用反向传播人工神经网络(BP-ANN)逼近气象因子-参考作物腾发量ET0函数关系,以天气预报中的最高和最低气温为输入进行短期ET0预报。收集了南京站实测的2010年7月1日至2013年7月7日逐日气象数据和2012年7月1日至2013年6月30日逐日对未来7d的气象预报数据,以最高、最低气温及相应的日序数为3个输入因子,ET0为输出建立一个包含一个隐含层的3层BP网络,以2010年7月1日至2012年6月30日实测气象数据及通过FAO-56PM公式计算的ET0进行网络,以2012年7月1日至2013年6月30日实测气象数据及通过FAO-56PM公式计算的ET0进行网络验证。将2012年7月1日至2013年6月30日逐日对未来7d的气象预报中的最高、最低气温输入训练及验证后的网络,得到2012年7月1日至2013年6月30日逐日对未来7d的ET0预报值,并与FAO-56PM公式计算的ET0值进行比较以验证预报精度。结果表明,预见期1~7d内,预报的ET0和计算的ET0变化趋势基本一致,预报精度随着预见期的增加而降低;平均准确率(±1.5mm/d以内)达88.08%,相关系数为0.77,均方根误差为1.28mm/d,显示出了较高的预报精度。在局部时间段内出现的ET0,PM和预报ET0的较大差别的原因是该时段内的ET0更多地受到除了日最高和最低气温之外的其他因素的影响。提出的方法 ET0预报,随着气象预报准确度的提高,可实现较为精确的ET0预报。     

基于PRO/E的水轮机转轮三维造型

利用Pro／E和AutoCAD的良好接口直接调入已有的混流式转轮二维木模图的叶片截面图形，对于上冠和下环附近叶片延展时的不确定性和容易出现的畸变问题采用了虚拟上冠和确定叶片尖点的方法，进行了转轮的三维造型。造型完成后，可直接利用Pro／E下的分析功能得出叶片真实厚度、重心位置、体积、表面积、转轮开口、转轮质量等相关数据。实现了转轮三维几何设计与流体动力学设计的一体化．为转轮内流动CFD分析、性能预测和CAM奠定了可靠的基础。     

Water status response of corn and cotton to altered irrigation

Water is a primary limiting factor to crop production and thus crop water status is essential information for management decisions. Corn and cotton were grown in the field under two constant water regimes. The low water level (WL) was 0.662PET (potential evapotranspiration) in corn and rainfall for cotton. The high water level (WH) was 1.02PET for both crops. Two transient water treatments in each crop began as the two constant water level treatments but then the water inputs were reversed and the change in water status was monitored. When the transient water treatments were initiated, corn was at the V14 and V16 growth stages in the WL and WH treatments, respectively, and cotton was 2 weeks past first bloom for both water levels. The purpose of the experiment was to compare the sensitivity of leaf water potential (LWP) and crop canopy temperature to changes in irrigation rate. The transient water treatment of each crop that relieved water stress (TLH) changed from WL to WH and the treatment which induced water stress changed from WH to WL (THL). The LWP values of the transient water treatments reversed 5 and 8 days after reversing water input rates to corn in 1998 and 1999, respectively, and after 3 days in both years for cotton. A reversal in canopy temperatures, expressed as the amount of daily time that the temperature was above 28°C (DST), was not detected between the TLH and THL treatments of corn after 25 days in 1998 or after 13 days in 1999. The DST values of the cotton transient water treatments reversed after 4 days in 1998 and 5 days in 1999, when the values of THL became greater than for TLH. Corn tassels, which apparently transpire less than leaves, were forming at the beginning of the transient water treatments and their presence in the view of the infrared thermocouples may have reduced the apparent radiometric temperature difference between the transient water treatments. During the water status adjustment period following the initiation of the transient water treatments, there were significant linear relationships between LWP and DST in cotton in both years but only in 1998 in corn. Cotton canopy temperature could be used to rapidly monitor an entire field in contrast to LWP which accurately measures plant water status but cannot provide automated measurements across a large area.