Genetic improvement of the Pacific oyster Crassostrea gigas (Thunberg) in Australia

The Pacific oyster industry in Australia is derived from importations from Japan in the late 1940s and early 1950s to Tasmania and is almost completely hatchery based. This makes it a good target for developing and deploying genetically improved strains. An allozyme survey comparing hatchery stocks with self‐recruiting Tasmanian stocks and with two collections from Japan found abundant variation and no significant evidence of allele loss. The subsequent selection programme (initiated in the summer of 1996/97) had several strands. We wanted to take advantage of the increased power that marker‐assisted selection could bring and, therefore, needed to develop a linkage map and isolate flanking markers around quantitative trait loci (QTLs). Several types of markers (allozymes, microsatellites and AFLPs) were used, and single‐pair crosses were set up; QTLs have been detected. Conventional selection programmes, one based on mass selection and one on family selection, have been established. Triploid Pacific oysters produced via chemical means have been available for several years, but rates of triploidy achieved by such means are usually less than 100%. In 1999, we will assess whether our tetraploid 2‐year‐old broodstock can be crossed with diploids to give 100% triploid offspring.     

Transpiration-induced axial and radial tension gradients in trunks of Douglas-fir trees

We determined the axial and radial xylem tension gradients in trunks of young Douglas-fir (Pseudotsuga menziesii (Mirb.) Franco) trees. Axial specific conductivity (k(s-a)) and sap flux density (Js) were measured at four consecutive depths within the sapwood at a stem height of 1 m. By definition, at a given position in the bole, Js is a function not only of k(s-a) but also of the driving force for water movement. The Js:k(s-a) ratio was therefore used to estimate axial tension gradients and the radial gradients at a stem height of 1 m were calculated from the differences in axial tension gradients at each depth. Tracheid lumen diameter and tracheid length were used to predict differences in k(s-a) and its divergence from the theoretical k(s-a) determined by the Hagen Poisseuille equation. The ratio of k(s-a) (determined in the laboratory) to Js (measured in the field) varied with depth in the sapwood, resulting in non-uniform axial and radial tension gradients from inner to outer sapwood. Transpiration-induced axial tension gradients were in the range of 0.006-0.01 MPa m(-1) excluding the gravitational tension gradient. At a stem height of 1 m, radial tension gradients were in the range of 0.15-0.25 MPa m(-1) and were lower in the middle sapwood than in the inner or outer sapwood. Axial tension gradients were 44-50% higher in the outer sapwood than in the inner sapwood. At a stem height of 1 m, radial Js, calculated on the basis of radial tension gradients and measured radial specific conductivity (k(s-r)), was about two orders of magnitude smaller than axial Js. Our findings indicate that large radial tension gradients occur in the sapwood and clarify the role played by xylem k(s-a) and k(s-r) in determining in situ partitioning of Js in the axial and radial directions.     

Magnesium influence on plant uptake of phosphorus in a calcareous soil

A pot experiment was conducted to investigate the role of magnesium (Mg) in plant utilization of ³²phoshorus (P)‐labelled P in a calcareous soil (Typic Hapluquent). Results with two successive harvests of ryegrass shoots indicated that Mg had no obvious influence on plant uptake of the P applied. In a separate incubation study with the same soil, labelled P along with different levels of Mg was introduced to the soil at two time intervals and soil inorganic P was fractionated. The isotope data of P in various fractions indicated that Mg at the test levels had no obvious influence on P transformation either. It is suggested from the experiments that Mg is unlikely to be able to promote plant utilization of fertilizer P in calcareous soils.     

Characterization ofSolanum tuberosum simple sequence repeats and application to potato culiwar identification

With the continued introduction of new potato cultivars, accurate identification is becoming difficult but is essential for maintaining cultivar integrity and Plant Breeders’ Rights. Hypervariable DNA sequences, referred to as simple sequence repeats (SSRs) or microsatellites, have been reported to be an excellent source of genetic markers. To determine the abundance, distribution, and composition of SSRs withinSolanium tuberosum, 252 sequences were searched for tetranucleotide and smaller SSRs with a minimum length of 20 nucleotides and a maximum discrepancy of two nucleotides. In total, 40 unique SSRs were observed in the 252S. tuberosum sequences examined and occurred at a frequency of one SSR every 8.1 kb. To assess the ability of site-specific amplified SSRs to identify potato cultivars, a simple (TCAC)_m and compound (TCAC)_m ? (CTT)_n SSR 5’ to the starch synthase gene and a compound (C)_p ? (CT)_q ? (AT)_r ? (G)_s SSR 5’ to the sequence encoding mature proteinase inhibitor I, were examined and shown to produce unique DNA profiles for 73 of 95 tetraploid cultivars. In total, 24 alleles were observed at these loci and the accurately sized amplified DNA products can be used to establish a database for cultivar identification. Site-specific amplified alleles were somatically stable and have been conserved in clonal variants of Russet Burbank independently maintained for almost seven decades, a characteristic essential for cultivar identification. As genetic markers, the abundant, informative, and easily examined site-specific amplified alleles of SSRs are ideal for quickly and accurately determining cultivar identity of S.tuberosum ssp.tuberosum.