Plus tree of Cryptomeria japonica D. Don with a heterozygous male-sterility gene

To find plus tree clones of Cryptomeria japonica that are heterozygous for a male-sterility gene (Aa), we crossed a homozygous male-sterile tree (aa) with 63 clones. Male sterility in this case is controlled by a recessive allele at a single gene locus and is expressed only in homozygotes. All F₁ seedlings obtained by crossing the male-sterile mother tree and 62 out of the 63 clones produced pollen. In contrast, F₁ seedlings obtained from the crossing between the male-sterile mother tree and a plus tree clone, Ohara 13, produced 64 male-sterile individuals and 52 fertile individuals. The segregation ratio fitted the expected 1 : 1 ratio according to a chi-square test. These results clearly demonstrate that the Ohara 13 clone is heterozygous for a male-sterility gene.     

Distribution of boron in wood treated with aqueous and methanolic boric acid solutions

The distributions of boron in Japanese cedar (Cryptomeria japonica D. Don) sapwood blocks treated with aqueous or methanolic boric acid [B(OH)₃] solutions were explored through Raman spectroscopy and prompt gamma-ray analysis (PGA). B(OH)₃ was the sole boron species observed in Raman spectra of the wood blocks treated with either solution. Plots of weight gain of the treated wood blocks versus boron concentration in treatment solutions were found to be linear. The results indicated that the methanolic solution makes it possible to impregnate wood with much larger amounts of boron than the aqueous solution. PGA confirmed that B(OH)₃ was highly enriched near the end grains of the treated wood blocks. Raman measurements suggested that boron content in the bulk of the wood block is not as large as expected from the weight gain of the treated wood blocks when an ordinary air-drying method is used. It was concluded that the aqueous solution impregnates the cell walls of wood with boron more easily than the methanolic solution. Part of this report was presented at the 55th (Kyoto, March 2005) and 56th (Akita, August 2006) Annual Meetings of the Japan Wood Research Society. This article follows the previous rapid communication “Analysis of boron in wood treated with boric acid solutions using Doppler broadening method of prompt gamma-rays.” J Wood Sci (2006) 52:279–281     

Effect of improvement cutting on the community structure of aphyllophoraceous fungi on Okinawa Island

Improvement cutting, which decreases tree density by cutting and thinning while leaving logging residues, has been practiced on Okinawa Island since the 1970s and changes not only the vegetation composition but also the amount and composition of woody debris on the forest floor. To quantitatively compare the effect of improvement cutting with the effects of woody debris and vegetation on the community structure of aphyllophoraceous fungi, we conducted a field survey of vegetation composition, the amount and composition of woody debris, and the aphyllophoraceous fungi flora on Okinawa Island in December 2006. We established 3 plots in forest stands without logging and 13 plots in a forest that had undergone improvement cutting from 1 to 22 years before our field survey. The number and volume of woody debris tended to be highest soon after improvement cutting. We recorded 1,172 fungal samples belonging to 81 species in four orders. Fungal species richness was correlated with the composition of the woody debris. Fungal species composition in forest plots 1 year after improvement cutting differed from most of the other logged forests. Variation partitioning revealed that the effects of improvement cutting explained 14.1 % of the total variation in fungal species composition, and that differences in woody debris and vegetation not related to improvement cutting explained 40.4 %. Changes in the composition of woody debris caused by improvement cutting explained at most 2.7 % of the variation. This suggests that improvement cutting does not have a strong effect on fungal community structure, but woody debris does.     

Effect of dietary astaxanthin rich yeast,Phaffia rhodozyma,on meat quality of broiler chickens

We evaluated effects of dietary supplementation with astaxanthin (Ax)‐rich yeast, Phaffia rhodozyma (Xanthophyllomyces dendrorhous), on broiler chicken meat quality. Fourteen‐day‐old female Ross broilers were divided into three groups: control group, Ax‐free diet; Ax 10 group, 10 mg/kg Ax diet; and Ax 20 group, 20 mg/kg Ax diet for 28 days. At 42 days old, chickens were slaughtered, and then growth performance, meat quality and sensory attributes were analyzed. Compared with the control, a* values increased significantly after slaughter and 48 h postmortem for Ax 20 samples (P < 0.05) and for b* values in Ax 20 and Ax 10 groups (P < 0.05). Cooking loss decreased in the Ax 20 group (P < 0.05). After 120 h aging, contents of several free amino acids and total free amino acid content of Ax 20 group were significantly higher than the control (P < 0.05). In sensory evaluation, meat texture attributes improved significantly in the Ax 20 group (P < 0.01). No significant changes occurred in flavor attribute scores of meat soup from the Ax 20 group compared with the control even though most assessors preferred meat soup from the Ax 20 group. Overall, Ax‐rich yeast in the diet improves broiler chicken meat quality.     

Effects of photoperiod on gonadotropin-releasing hormone levels in the brain and pituitary of underyearling male barfin flounder

ABSTRACT:   A pleuronectiform fish, the barfin flounder Verasper moseri , expresses three gonadotropin-releasing hormone (GnRH) forms in the brain: salmon GnRH (sGnRH), chicken GnRH-II (cGnRH-II) and seabream GnRH (sbGnRH). To clarify the effects of photoperiod on GnRH systems, changes in brain and pituitary GnRH peptide levels were examined using time-resolved fluoroimmunoassays. In experiment 1, 5-month-old male barfin flounder (mean total length 9.0 cm, body weight 11.0 g) were divided into short (8:16 h light : dark [L:D] cycle; lights on 08.00–16.00 hours) and long photoperiod (16:8 h L:D cycle; lights on 04.00–20.00 hours) groups in mid September and maintained until November under natural water temperature (19.3–15.2°C). Brain sGnRH concentrations were significantly higher in the 16:8 h L:D group than in the 8:16 h L:D group, whereas no significant differences were observed in total length, body weight, plasma testosterone concentration, brain cGnRH-II concentration and pituitary sbGnRH content. In experiment 2, 7-month-old male barfin flounder (mean total length 16.5 cm, body weight 76.8 g) were divided into short and long photoperiod groups in mid December and maintained until February under natural water temperature (12.5–6.6°C). Total length, body weight and condition factor were significantly greater in the 16:8 h L:D group than in the 8:16 h L:D group, whereas no significant differences were observed in plasma testosterone concentration and GnRH levels in the brain and pituitary. These results indicate that levels of sGnRH in barfin flounder are influenced by photoperiodic treatment dependent on water temperature and/or body size.     

Diving behavior of immature, feeding Pacific bluefin tuna (Thunnus thynnus orientalis) in relation to season and area: the East China Sea and the Kuroshio–Oyashio transition region

Twenty‐four archival tags were recovered from Pacific bluefin tuna previously released off Tsushima Island in the East China Sea. By analysis of the time‐series data of the pressure and the ambient and internal temperature from the 24 tags, we examined the relationship between the tuna's pattern of diving and the thermocline depth. In the East China Sea, diving and feeding events occurred throughout almost the entire day in both winter and summer, suggesting that the purpose of diving is for feeding. In summer, the feeding frequency was greater than that in winter, which corresponds to the fact that growth is more rapid in summer than in winter. During summer in the Kuroshio–Oyashio transition region, on the other hand, feeding events were much more frequent than those in the East China Sea, in spite of a lower diving frequency. The mean horizontal distance traveled was also significantly higher and it seems that in this area they may move horizontally to feed on prey accumulated at the surface. We conclude that, in addition to the ambient temperature structure, the vertical and horizontal distribution of prey species plays an important role in the feeding behavior of Pacific bluefin tuna. One bluefin tuna migrated to the Oyashio frontal area, where both the horizontal and the vertical thermal gradients are much steeper. The fish spent most of the time on the warmer side of the front and often traveled horizontally to the colder side during the day, perhaps to feed. This implies that there is a thermal barrier effect, in this case from the Oyashio front, on their behavior. The frequency of feeding events was low, although all the monitored fish dived every dawn and dusk, irrespective of the seasons or location. It is possible that these twice‐daily diving patterns occurred in response to the change in ambient light at sunrise and sunset.     

Effect of horizontal advection induced by intrusion of the Kuroshio water on plankton biomass in the spring fishing period of shirasu on the Pacific coast of Japan

ABSTRACT:   This study explored the fundamental process that controls interannual change in plankton biomass on the Pacific coast of Japan, focusing on the spring period of shirasu fishery. A 1-D model of primary production revealed that the strength of horizontal advection induced by warm water intrusion from the Kuroshio into the Pacific coast is the most critical for plankton biomass compared with other factors such as diffusion and production. This conclusion was also confirmed by a sensitivity analysis of the model.     

Development of an air-injection press for preventing blowout of particleboard II: improvement of board properties using small-diameter holes for air injection

An air-injection press, which has holes punched in the heating plates, injects high-pressure air through the holes of one plate into boards during press heating. The air-injection press can manufacture boards from high-moisture-content particles by controlling blowouts of the boards. In this study, boards were manufactured from particles that had a moisture content of 25% by using the air-injection press, which reduced the required pressing time. Boards manufactured by injecting air through holes of 5 mm in diameter were of poor quality with a low internal bond strength of only 0.31 MPa. When the hole diameter was reduced to 1 mm, the internal bond strength increased to 0.44 MPa. A high air-injection pressure of 0.55 MPa also resulted in improved board properties over those for boards manufactured at lower pressures. This was probably because a large amount of binder was released from boards through the 5-mm holes, together with water vapor, during air injection; the small-diameter holes reduced the release of binder, resulting in better board properties.     

Effects of sealed press on improving the properties of particleboard

To improve the properties of particleboard, boards were produced using a sealed press. With the sealed press, boards were processed under high-temperature and high-pressure steam. This increased the saturation temperature, causing a dramatic rise in temperature inside the board, faster curing of the binder, and a shorter pressing time. The boards were bonded with urea formaldehyde resin, melamine urea formaldehyde resin, or poly(methylene diphenyl diisocyanate) (PMDI). The sealed press improved the internal bond strength and thickness swelling of boards regardless of the binder used during the reduced pressing time. The increased bonding strength improved the board properties, allowing PMDI with a lower resin content to be used for bonding the boards.