Neonatal calf mortality is a major concern to livestock sector worldwide. Neonatal calf diarrhoea (NCD), an acute severe condition causes morbidity and mortality in calves. Amongst various pathogens involved in NCD, E. coli is considered as one of the major causes. The study was targeted to characterize E. coli isolates from neonatal calves for diarrhoeagenic Escherichia coli (DEC) types (pathotyping), antimicrobial resistance (AMR) profiling and to correlate with epidemiological parameters. From neonates, a total of 113 faecal samples were collected, out of that 308, lactose fermenting colonies were confirmed as E. coli. Pathotypable isolates (12.3%) were represented by STEC (6.1%), EPEC (2.9%), ETEC (1.9%), EAEC (0.9%) and EHEC (0.3%). Occurrence of STEC was more in non-diarrhoeic calves, whereas ETEC was observed more in diarrhoeic calves. EPEC occurrence was observed in both diarrhoeic and non-diarrhoeic calves. Fishers extract test showed no significant association for occurrence of DEC types to type of dairies, health status, species, breed, age and sex of neonatal calves. Two hundred and eighty isolates were tested for antimicrobial susceptibility. The isolates showed maximum resistance towards ampicillin (55.4%) followed by tetracycline (54.3%), while minimum resistance was observed towards meropenem (2.5%). Multidrug resistant E. coli isolates were found to be 139 (49.6%), and Extended-spectrum beta-lactamase (ESBL) producers were 120 (42.9%). DEC pathotypes like STEC, ETEC, EHEC and EAEC that are also multidrug resistant present in neonatal calves have zoonotic potential and hence are of public health significance.
We investigated carbon (C) uptake and respiratory losses of an adult Pinus cembra tree at the alpine timberline throughout an entire year by means of an automated, multiplexing gas exchange system. These chamber measurements were then combined with biomass data for scaling up the C budget to the tree level. Integrated over an entire year, the cumulative C gain of the tree under study was 23.5 kg of C in 2002. The daily C balance was negative for 5 months and the estimated total wintertime respiratory losses were 9% of the amount of C fixed during the growing season. The total annual C loss of the tree consumed 55% of the annual net C gain and the remaining surplus was stored in new tissues (36%) and used for fine root growth (9%). Thus, the overall C budget of P. cembra at the upper timberline is balanced fairly well, although the C sink strength in fine roots is strongly limited owing to low root zone temperatures when compared to conifers at lower elevation sites. 相似文献
Variation of infiltration rates with landscape position influences the amount, distribution, and routing of overland flow. Knowledge of runoff patterns gives land managers the opportunity to affect changes that optimize water use efficiency and reduce the risk of water quality impacts. The objective of this study was to assess the effect of landscape position and associated soil properties on infiltration in a small (147 ha) forest/pasture watershed in the Ozark Highlands. Three previously reported studies measured infiltration rates using double ring, sprinkling, single ring, and tension infiltrometers on soils at varying landscape positions. Although large variation in infiltration rates was observed among measurement techniques, upland and side slope soils (Nixa and Clarksville) had consistently lower infiltration rates compared to the soil in the valley bottom (Razort). A conceptual understanding of watershed runoff is developed from these data that includes infiltration excess runoff from the Nixa and Clarksville soils and saturation excess runoff on the Razort soil. Management of the soil water regime based on this understanding would focus on increasing infiltration in upland soils and maintaining the Razort soil areas in forest. Forest productivity would be enhanced by increasing plant-available water in upland soils and decreasing flooding on the Razort soil. Surface water quality would be improved by reducing the transport of potential water contaminants from animal manure applied to upland pastures. 相似文献
Because the rate of isoprene (2-methyl-1,3-butadiene) emission from plants is highly temperature-dependent, we investigated natural fluctuations in leaf temperature and effects of rapid temperature change on isoprene emission of red oak (Quercus rubra L.) leaves at the top of the canopy at Harvard Forest. Throughout the day, leaves often reached temperatures as much as 15 degrees C above air temperature. The highest temperatures were reached for only a few seconds at a time. We compared isoprene emission rates measured when leaf temperature was changed rapidly with those measured when temperature was changed slowly. In all cases, isoprene emission rate increased with increasing leaf temperature up to about 32 degrees C and then decreased with higher temperatures. The temperature at which isoprene emission rates began to decrease depended on how quickly measurements were made. Isoprene emission rates peaked at 32.5 degrees C when measured hourly, whereas rates peaked at 39 degrees C when measurements were made every four minutes. This behavior reflected the rapid increase in isoprene emission rate that occurred immediately after an increase in leaf temperature, and the subsequent decrease in isoprene emission rate when leaf temperature was held steady for longer than 20 minutes. We concluded that the observed temperature response of isoprene emission rate is a function of measurement protocol. Omitting this parameter from isoprene emission models will not affect simulated isoprene emission rates at mild temperatures, but can increase isoprene emission rates at high temperatures. 相似文献
Wood from Norway spruce (Picea abies L. Karst.) is biologicallydegraded in exposed conditions. It also has anatomical featuresthat make it difficult to impregnate with preservatives by currentlyavailable industrial processes. In the study reported here,we used the new Linotech process to impregnate Norway sprucewood with hydrophobic linseed oil and then quantified its uptakeand dispersal in anatomically distinct wood tissues. We alsoinvestigated the effects of the wood moisture content on theresults of the impregnation. Samples (500 x 25 x 25 mm) weretaken from 15 trees in a coniferous forest in northern Sweden(64° 10' N, 160320 m a.s.l.). The parameters forthe Linotech process were 23 h treatment time at 0.81.4MPa and 60140°C. To determine the level of uptake,the linseed oil was extracted from the impregnated wood usingmethyl-tertiary-butyl-ether. The uptake was quantitatively analysedby comparing X-ray microdensitometry values obtained followingimpregnation both before and after oil removal. In earlywood,initial moisture content had an obvious effect on the impregnationresult. Six times more oil was taken up when the moisture contentwas greater than ~150 per cent than when it was less than 30per cent. Theoretical calculations, based on density levels,suggest that the water-filled porosity of the wood (water volumedivided by porosity volume) was positively correlated with thelinseed oil uptake, and more strongly correlated in earlywoodthan in latewood. There were also significant differences inuptake between different wood tissues; heartwood/mature woodand heartwood/juvenile wood showed 1020 per cent weightincreases due to linseed oil uptake, compared with 3050per cent in sapwood/mature wood. Examination by scanning electronmicroscopy confirmed these uptake patterns. The moisture contentafter impregnation was about 5 per cent, irrespective of theLinotech process parameters, tissue type and initial moisturecontent. In conclusion, the impregnation process used here resultsin high levels of well-dispersed linseed oil uptake and shouldfacilitate drying. 相似文献