Summer drought decreases Leymus chinensis productivity through constraining the bud,tiller and shoot production

Extreme drought events can directly decrease productivity in perennial grasslands. However, for rhizomatous perennial grasses it remains unknown how drought events influence the belowground bud bank which determines future productivity. Ninety‐day‐long drought events imposed on Leymus chinensis, a rhizomatous perennial grass, caused a 41% decrease in the aboveground biomass and a 28% decrease in belowground biomass. Aboveground biomass decreased due to decrease in both the parent and the daughter shoot biomass. The decreases in daughter shoot biomass were due to reductions in both the shoot number and each individual shoot weight. Most importantly, drought decreased the bud bank density by 56%. In addition, drought induced a bud allocation change that decreased by 41% the proportion of buds that developed into shoots and a 41% increase in the buds that developed into rhizomes. Above results were supported by our field experiment with watering treatments. Thus, a 90‐day‐long summer drought event decreases not only current productivity but also future productivity, because the drought reduces the absolute bud number. However, plasticity in plant development does partly compensate for this reduction in bud number by increasing bud development into rhizomes, which increases the relative allocation of buds into future shoots, at the cost of a decrease in current shoots.     

Does sand content in spawning substrate result in early larval emergence? Evidence from a lithophilic cyprinid fish

The spawning success of lithophilic salmonids is strongly influenced by the fine sediment content (“fines”) of spawning substrates, yet knowledge on the impacts of fines on the spawning of non‐salmonid lithophiles remains limited, despite their ecological and socio‐economic importance in European rivers. Consequently, the aim here was to use an ex‐situ experiment to investigate the impact of sand content on egg survival and timing of larval emergence of the surface‐spawning cyprinid European barbel Barbus barbus. Thirty incubator boxes within a recirculating system were filled with one of five experimental sediment mixtures (0%–40% sand by mass) that each contained 300 fertilised eggs at a depth of 50 mm. Emerged, free‐swimming larvae were captured and counted daily to assess grain‐size effects on larval survival and emergence. Specifically, total proportion of emerged larvae, cumulative daily proportion of emerged larvae and time required to reach 50% emergence were measured during the study. Whilst the proportion of sand in the sediments did not have a significant impact on egg‐to‐emergence survival (mean survival per treatment 75%–79%), it significantly affected the timing of larval emergence to the water column; early emergence was detected in treatments with elevated sand content (on average, 50% emergence after 12–13 days versus 19 days in the control). Similar to findings from salmonid studies, these results suggest high sand content in spawning gravels can influence timing of larval emergence and potentially cyprinid lithophilic fish survival.     

Cross‐linked polyacrylates in post‐mining substrates: persistence and effects on plant growth

Application of hydrophilic polymers composed of cross‐linked polyacrylate can improve soil water‐holding capacity and accelerate the restoration of post‐mining substrates. In this work, we studied the persistence of a polyacrylate polymer incorporated into a soil and its impact on plant nutrients at a reclamation site of former lignite mining in Lusatia (Germany). In contrast to autumn application, the incorporation of the polymer enhanced the sequestration of plant‐derived carbon in the soil, which was reflected by a significant increase in the concentration of a lignin marker. Attenuated total reflexion–Fourier transform infrared spectra (ATR‐FTIR) and total elemental contents in the applied polymer suggested an intensive cation exchange between the polymer framework and the soil‐forming substrate. In addition, there was an enrichment of carbonaceous material, which seems to reduce the swelling and thus the water‐holding capacity of the cross‐linked polyacrylate. Conversely, this process protected the polymer structure from rapid decomposition.     

Comparison of Salt and Drought‐Stress Effects on Maize Growth and Yield Formation with Regard to Acid Invertase Activity in the Kernels

The long‐term effects of salt stress (11 dS m^?1) and drought stress (35 % WHC) were investigated for two maize genotypes, focusing on the relation between metabolic changes around the time of pollination and the impact on yield determinants at maturity. The relatively salt‐resistant hybrid Pioneer 3906 and the relatively drought‐resistant hybrid Fabregas were compared. The experiments were conducted in large plastic containers in a vegetation hall in two consecutive years (2011 and 2012). Plant height and leaf area were significantly reduced under both stress conditions. The transpiration rate was only slightly reduced under drought stress; but under salt stress, a significant reduction occurred 40–53 days after sowing. As a significant increase in sucrose concentrations was observed in the salt‐treated maize kernels 2 days after pollination, the availability of assimilates was not limiting and the plants could afford to save water by reduced stomatal opening. Although under both stress conditions the soluble acid invertase activity was reduced 2 days after pollination, concomitantly, an increase in hexose concentrations was observed. Thus, in these experiments, the delivery of hexoses by acid invertase activity did not limit kernel development. Differences in grain yield at maturity between salt and drought stress were most likely caused by salt‐specific effects (Na⁺ toxicity), Fabregas being more affected than Pioneer 3906.     

How to characterize ‘good’ and ‘greening’ in the EU Common Agricultural Policy (CAP): the case of clay soils in the Netherlands

The change in the Common Agricultural Policy (CAP) of the European Union from product to producer support, including requirements for ‘good agricultural and environmental conditions’ and ‘greening’, is excellent. However, these requirements are now defined in rather general terms. Questions can be raised about suitable indicators, and there is a recognized need for effective management recommendations to support farmers in achieving the required ‘good’ conditions. These recommendations are bound to be quite different for different soils in different countries. A study of Dutch clay soils was based on a storyline describing current problems and management options for improvement, which were quantified using a soil–water–crop simulation model. Indicators were defined for agricultural conditions and suggestions made for the use of the model in a predictive mode to help farmers improve their soil management. Environmental conditions were judged by current environmental guidelines for water and air. When modelling, implicit assumptions that soils are homogeneous were shown to be unrealistic for these clay soils, requiring development of innovative methods and procedures, presenting a challenge for soil research.     

Effects of CO2 Enrichment and Drought on Photosynthesis,Growth and Yield of an Old and a Modern Barley Cultivar

Susceptibility of crops to drought may change under atmospheric CO₂ enrichment. We tested the effects of CO₂ enrichment and drought on the older malting barley cultivar Golden Promise (GP) and the recent variety Bambina (BA). Hypothesizing that CO₂ enrichment mitigates the adverse effects of drought and that GP shows a stronger response to CO₂ enrichment than BA, plants of both cultivars were grown in climate chambers. Optimal and reduced watering levels and two CO₂ concentrations (380 and 550 ppm) were used to investigate photosynthetic parameters, growth and yield. In contrast to expectations, CO₂ increased total plant biomass by 34 % in the modern cultivar while the growth stimulation was not significant in GP. As a reaction to drought, BA showed reduced biomass under elevated CO₂, which was not seen in GP. Grain yield and harvest index (HI) were negatively influenced by drought and increased by CO₂ enrichment. BA formed higher grain yield and had higher water‐use efficiency of grain yield and HI compared to GP. CO₂ fertilization compensated for the negative effect of drought on grain yield and HI, especially in GP. Stomatal conductance proved to be the gas exchange parameter most sensitive to drought. Photosynthetic rate of BA showed more pronounced reaction to drought compared to GP. Overall, BA turned out to respond more intense to changes in water supply and CO₂ enrichment than the older GP.     

Differences in Ion Accumulation and Salt Tolerance among Glycine Accessions

Salinity reduces crop yield by limiting water uptake and causing ion‐specific stress. Soybean [Glycine max (L.) Merr.] is sensitive to soil salinity. However, there is variability among soybean genotypes and wild relatives for salt tolerance, suggesting that genetic improvement may be possible. The objective of this study was to identify differences in salt tolerance based on ion accumulation in leaves, stems and roots among accessions of four Glycine species. Four NaCl treatments, 0, 50, 75 and 100 mm , were imposed on G. max, G. soja, G. tomentella and G. argyrea accessions with different levels of salinity tolerance. Tolerant genotypes had less leaf scorch and a greater capacity to prevent Na⁺ and Cl^? transport from soil solution to stems and leaves than sensitive genotypes. Magnitude of leaf injury per unit increase in leaf Na⁺ or Cl^? concentrations was lower in tolerant than in susceptible accessions. Also, plant injury was associated more with Na⁺ rather than with Cl^? concentration in leaves. Salt‐tolerant accessions had greater leaf chlorophyll‐meter readings than sensitive genotypes at all NaCl concentrations. Glycine argyrea and G. tomentella accessions possessed higher salt tolerance than G. soja and G. max genotypes.     

Gas chromatography for detection of citrus infestation by fruit fly larvae (Diptera: Tephritidae)

Tephritid fruit flies are serious economic pests worldwide. As larvae, they feed and develop within the pulp of host fruits, making infestation difficult to detect by visual inspection. At U.S. ports of entry, incoming produce shipments are checked for infestation by manually cutting open a small sample of fruit and searching for tephritid larvae. Consequently, there is a need for more sensitive, high-throughput screening methods. This study evaluated gas chromatography (GC) as a potential technology for improved detection of hidden infestation. Grapefruits (Citrus × paradisi Macfad.) infested with immature stages of the Caribbean fruit fly Anastrepha suspensa (Loew) (Diptera: Tephritidae) were examined to determine if infested fruit emitted a chemical profile distinct from that of non-infested fruit. Peaks identified by GC analysis were grouped into three classes. Chemicals detected in similar quantities in all samples, or slightly elevated in infested samples, were regarded as non-diagnostic background volatiles. Chemicals highly elevated after oviposition, during the last instar exit stage, and in experimentally-pierced fruit were interpreted to be indicators of citrus peel injury, and included d-limonene and β-ocimene. Chemicals elevated exclusively in the larval infestation stages were considered indicators of feeding damage and potentially diagnostic of infestation, and included hexyl butanoate and an unidentified compound. The peaks associated with injury and feeding were also detectable with a portable ultra-fast GC analyzer that required less than 80 s per sample. Further studies will investigate the potential application of these results for development of a rapid, non-destructive screening method for detection of tephritid infestation.     

Estimation of Crown Temperature of Winter Wheat and the Effect on Simulation of Frost Tolerance

Accurate estimation of winter wheat frost kill in cold‐temperate agricultural regions is limited by lack of data on soil temperature at wheat crown depth, which determines winter survival. We compared the ability of four models of differing complexity to predict observed soil temperature at 2 cm depth during two winter seasons (2013‐14 and 2014‐15) at Ultuna, Sweden, and at 1 cm depth at Ilseng and Ås, Norway. Predicted and observed soil temperature at 2 cm depth was then used in FROSTOL model simulations of the frost tolerance of winter wheat at Ultuna. Compared with the observed soil temperature at 2 cm depth, soil temperature was better predicted by detailed models than simpler models for both seasons at Ultuna. The LT50 (temperature at which 50 % of plants die) predictions from FROSTOL model simulations using input from the most detailed soil temperature model agreed better with LT50 FROSTOL outputs from observed soil temperature than what LT50 FROSTOL predictions using temperature from simpler models did. These results highlight the need for simpler temperature prediction tools to be further improved when used to evaluate winter wheat frost kill.