Chlamydial infection in a colony of captive koalas

Forty three koalas in a captive colony were investigated for the presence of Chlamydia psittaci infection and associated disease. Swabs were taken from conjunctivae and urogenital sites for cell culture isolation of C psittaci and for cytological examination (direct smears) for chlamydial inclusions and evidence of inflammation. On the basis of cell culture isolation, 28 samples from 25 koalas were positive for C psittaci (that is, infected). Three koalas were positive from both sites, 5 from conjunctivae alone and 17 from urogenital sites alone. Seven of the 8 koalas with positive conjunctival swabs had overt signs of conjunctivitis, but only 3 of the 20 koalas with positive urogenital swabs had overt signs of 'wet bottom' (continual urine soiling due to cystitis) or purulent discharge. However, 5 of the 20 with positive urogenital swabs had past episodes of 'wet bottom'. Moreover, examination of direct cytological smears showed evidence of inflammation (neutrophils) in 7 of 8 koalas with positive conjunctival swabs and 17 of 20 with positive urogenital swabs. Chlamydial inclusions were rarely identified with surety on direct cytological smears. In the 18 koalas without chlamydia, one had overt conjunctivitis while 2 had past episodes of conjunctivitis. The koala with conjunctivitis at the time of sampling had a prior history of 'wet bottom'. Examination of direct cytological smears revealed 2 of the chlamydial negative koalas had high numbers of neutrophils in urogenital smears. It was concluded that C psittaci infection may cause overt or sub-clinical disease, with the former developing when the koalas were stressed through management procedures or concomitant disease.     

Assessment of the potential toxicity of a poison for rabbits, pindone (2-pivalyl 1, 3 indandione), to domestic animals

The toxicity of pindone, a rabbit poison, to horses, cattle, goats, chickens, dogs and cats was investigated, using extension of prothrombin time (PT) as an index of poisoning. The daily dose of pindone, administered for 5 days, ranged from 0.3 mg/kg for dogs to 2.5 mg/kg for chickens. This range of dose rates was considered to be indicative of the worst possible case that could arise following a campaign of baiting for rabbits. Although significant elevations in PT (more than double baseline values) were noted in all species other than horses, clinical signs of anticoagulant poisoning were not observed in any of the species tested. From the observed PT, cattle and cats appeared to be the most susceptible, and horses the least susceptible, to pindone toxicity. The half-lives of the elevated PT were calculated as 3.1 days for cattle, 2.8 days for goats and chickens, 1.9 days for horses and dogs and less than one day for cats. It is proposed that these half-lives can be used as a guide for determining the duration of treatment of pindone-affected animals.     

Failure of a single treatment with ivermectin to control sheep scab (Psoroptes ovis) on artificially infested sheep

Ivermectin at 200 micrograms/kg bodyweight given either as a single subcutaneous injection or as an oral drench failed to eradicate Psoroptes ovis from artificially infested sheep. The oral drench reduced the mite populations by 43 per cent within 24 hours but no further significant decline was recorded over 38 days. The subcutaneous injection reduced the mite populations by 90 per cent after 10 days but live P ovis were present on all the treated animals 84 days after treatment. The efficacy of treatment was less the higher the initial mite burden. The injection had no effect on clinical sheep scab, and the disease continued to progress despite the mite mortality.     

The serological responses of chickens to mass vaccination with a live V4 Newcastle disease virus vaccine in the field and in the laboratory 2. Layer pullets

Layer chickens on a commercial started pullet farm were vaccinated once at 31 to 52 days of age by drinking water or aerosol with live V4 Newcastle disease virus (NDV) vaccine. Flockmates which had been rehoused in laboratory isolation pens shortly beforehand were similarly vaccinated. Samples of birds were bled at intervals and the serums tested for haemagglutination inhibiting antibody to NDV. Log2 mean titres of up to 4.88 and assumed protection levels (based on the percentage of birds with log2 titres of 4 or greater) of up to 81%, were obtained in the field trials within 4 weeks of vaccination. A subsequent laboratory trial further compared the response of different breeds of chicken to different routes of vaccination. Differences were observed between breeds, routes of vaccination, and parallel field and laboratory trials. The results show that this V4 vaccine can produce an adequate serological response following mass vaccination of Australian layer pullets housed under commercial conditions, and that care should be exercised in extrapolating results obtained under laboratory conditions.     

Overwintering of Frankliniella fusca (Thysanoptera: Thripidae) on Winter Annual Weeds Infected with Tomato spotted wilt virus and Patterns of Virus Movement Between Susceptible Weed Hosts

ABSTRACT Overwintering of tobacco thrips, Frankliniella fusca, was investigated on common winter annual host plants infected with Tomato spotted wilt virus (TSWV). Populations of tobacco thrips produced on TSWV-infected plants did not differ from those produced on healthy plants, whereas populations varied greatly among host plant species. The mean per plant populations of F. fusca averaged 401, 162, and 10 thrips per plant on Stellaria media, Scleranthus annuus, and Sonchus asper, respectively, during peak abundance in May. Adult F. fusca collected from plant hosts were predominately brachypterous throughout the winter and early spring, but macropterous forms predominated in late spring. Weed hosts varied in their ability to serve as overwintering sources of TSWV inoculum. Following the initial infection by TSWV in October 1997, 75% of Scleranthus annuus and Stellaria media retained infection over the winter and spring season, whereas only 17% of Sonchus asper plants remained infected throughout the same interval. Mortality of TSWV-infected Sonchus asper plants exceeded 25%, but mortality of infected Stellaria media and Scleranthus annuus did not exceed 8%. TSWV transmission by thrips produced on infected plants was greatest on Stellaria media (18%), intermediate on Scleranthus annuus (6%), and lowest on Sonchus asper (2%). Very few viruliferous F. fusca were recovered from soil samples collected below infected wild host plants. Vegetative growth stages of Stellaria media, Sonchus asper, and Ranunculus sardous were more susceptible to F. fusca transmission of TSWV than flowering growth stages, whereas both growth stages of Scleranthus annuus were equally susceptible. In a field study to monitor the spatial and temporal patterns of virus movement from a central source of TSWV-infected Stellaria media to adjacent plots of R. sardous, the incidence of infection in R. sardous plots increased from <1% in March to >42% in June 1999. Infection levels in the Stellaria media inoculum source remained high throughout the experiment, averaging nearly 80% until June 1999 when all Stellaria media plants had senesced. Dispersal of TSWV from the inoculum source extended to the limits of the experimental plot (>37 m). Significant directional patterns of TSWV spread to the R. sardous plots were detected in April and May but not in June. R. sardous infections were detected as early as March and April, suggesting that overwintering inoculum levels in an area can increase rapidly during the spring in susceptible weed hosts prior to planting of susceptible crops. This increase in the abundance of TSWV inoculum sources occurs at a time when vector populations are increasing rapidly. The spread of TSWV among weeds in the spring serves to bridge the period when overwintered inoculum sources decline and susceptible crops are planted.     

Determining optimal primary sawing and ripping machine settings in the wood manufacturing chain

for wood manufacturers around the world, the single biggest cost factor is known to be its raw material. Maximum volume recovery of this raw material is, therefore, of key importance for the industry. The wood products industry consists of several interrelated manufacturing steps for converting trees into logs and logs into finished lumber. Each operation usually optimises its functionality in isolation from the preceding and following operations. It is a well documented fact that the optimisation of decisions through the whole chain of operations is considerably more profitable than the optimisation of individual operations. The objective of this study was to determine the optimal machine settings for two interrelated operations, namely the sawing and ripping operations which have tradition? ally been optimised individually. A model, having two decision variables, was developed which aims to satisfy market demand at a minimal cost. The first decision was how to saw the log supply into different thicknesses by choosing specific sawing patterns. The second was to decide on a rip saw's priority value settings, which determines how the products from the primary sawing operation are ripped into products of a certain thickness and width. The techniques used to determine the machine settings included static simulation with the SIMSAW software to represent the sawing operation and mixed integer programming to model the ripping operation. A metaheuristic, namely the Population Based Incremental Learning algorithm, was used to link the simulation and mixed integer models and to determine the optimal settings for the combined process. The model's objective function was to minimise the cost of production. This cost included the raw material waste cost and the over or under production cost. The over production cost included the stock keeping costs and the under production cost was estimated as the buy?in cost of under supplied products from another wood supplier. The model performed well against current decision software available, namely the Sawmill Production Planning System package, which combines simulation and mixed integer programming techniques to maximise profit. The model added further value by modelling and determining the ripping priority settings in addition to the primary sawing patterns.