Evaluation of Sperm-Activating Solutions in Atlantic Salmon Salmo salar Fertilization Tests

The use of saline solutions was tested to determine their efficacy as replacements for ovarian fluid as sperm activators and to eliminate variability encountered with the use of Ovarian fluid. We tested fertilization rate of semen from eight males on Atlantic salmon Salmo salar eggs after five sperm-activating solutions and a non-activating saline were substituted for ovarian fluid. We used solutions shown acceptable for use with other salmonid species. The six solutions tested were a non sperm-activating phosphate-buffered saline (PBS, 7.2 g/L NaCl, 1.48 g/L Na₂HPO₄, 0.43 g/L K H₂PO₄), a Tris buffer (6.99 g/L NaCl, 3.63 g/L Tris and 2.42 g/L glycine), a Borax buffer (12.2 g boric acid/L in solution 1, 76 g disodium tetraborate/L combined 100:118, then 1 L combined with 3.7 L water and 18 g NaCl), and three solutions of 9.25 g/L (125 mM) NaCl buffered to pH 6.0, 7.5, and 8.9. The latter five solutions activated sperm immediately on contact, while PBS required additional water to activate sperm. The PBS solution was the least effective (mean percent eyed eggs 37.6%) for egg fertilization. The mean percent eyed eggs for the other five saline solutions (range 78% to 86%) were not significantly different. Sperm from one male provided significantly lower egg fertilization (39.6%) when compared with the other seven males (67.2–87.4% egg fertilization). Percent egg fertilization was not related to number of live sperm cells per egg. Our results show that osmotically-balanced sperm-activation solutions, even those with a pH range from 6.0 to 8.9 provide adequate media for fertilization of Atlantic salmon eggs. Fertilization in a deactivation saline and water reactivation of sperm resulted in low egg fertilization.     

Feline struvite crystalluria: a comparison of some commercially available dry cat diets in New Zealand

Thirteen adult cats were each fed consecutively five test diets: firstly a complete canned diet, and then four commercially available dry cat diets (New Formula Biscats, Cat Chow, Go-Cat and Whiskettes) for 7,13, 5, 4 and 4 weeks respectively. Urine samples were tested for pH and presence of struvite crystals. Body weight was recorded weekly. Urine pH was ranked from acid to alkaline as follows: Whiskettes (pH 5.8), canned diet (pH 5.9), Biscats (pH 6.1), Cat Chow (pH 6.45) and Go-Cat (pH 6.5). The pH of urine when cats were fed Whiskettes, Biscats and canned diet was not significantly different. Biscats produced a urine pH significantly higher than Whiskettes but, in each case, these three diets produced a significantly lower urine pH than Cat Chow and Go-Cat. Struvite crystals occurred spontaneously in 9% of urine samples from cats when fed Whiskettes and Biscats, 71% when fed Cat Chow and 38% when fed Go-Cat: spontaneous struvite was not seen in any cat fed CX9. Haematuria was seen in 2.9% (2/69) urine samples from cats fed Cat Chow. One tom cat had a blocked urethra after 24 days on Go-Cat. No abnormalities were observed in any cat when fed canned diet, Biscats or Whiskettes. It was concluded that of the four dry cat diets tested only Biscats and Whiskettes produce urine with an acceptably low rate of spontaneous struvite crystalluria.     

Thermodynamic efficiency of brittle frictional mountain building

An active fold-and-thrust belt in unchanging tectonic and climatic conditions attains a dynamic steady-state in which the influx of accreted material at the toe is balanced by the erosive efflux off the top. The overall balance of energy in such a steady-state fold-and-thrust belt is described by the equation E = W(G) + Q, where E is the rate at which both mechanical and heat energy are added from external sources, W(G) is the rate of work performed against gravitational body forces, and Q is the rate at which waste heat flows out of the upper and lower boundaries. The total amount of power being supplied to the active Taiwan fold-and-thrust belt by the subducting Eurasian plate and in situ radioactivity is 4.2 gigawatts. Because only 0.5 gigawatts are expended in doing useful work against gravity and the remaining 3.7 gigawatts are ejected as heat, the efficiency of brittle frictional mountain building in Taiwan is 11 percent.