Methane emissions from stems of Fraxinus mandshurica var. japonica trees in a floodplain forest

We measured methane (CH₄) emissions from the stem surfaces of mature Fraxinus mandshurica var. japonica trees in a floodplain forest. Flux measurements were conducted almost monthly from May to October 2005, and positive CH₄ fluxes were detected throughout the study period, including the leafless season. The mean CH₄ flux was 176 and 97 μg CH₄ m⁻² h⁻¹ at the lower (15 cm above the ground) and upper (70 cm above the ground) stem positions, respectively. The CH₄ concentration was lower in soil gas than in ambient air to a depth of at least 40 cm. One possible source of CH₄ emitted from the stems might be the dissolved CH₄ in groundwater; maximum concentrations were 10,000 times higher than atmospheric CH₄ concentrations. Our results suggest that CH₄ transport from the submerged soil layer to the atmosphere may occur through internal air spaces in tree bodies.     

农业机械全方位视觉定位系统的定位算法

农业机械全方位视觉定位系统根据标识方位角角度估算传感器相对于标识坐标系的绝对位置,包括系统校正、除噪、标识特征提取、方位角度估算和定位算法,其中定位算法是实现农业机械全方位视觉定位系统的关键部分。该文主要研究了4个标识和3个标识的定位算法,并通过室外30m×30m平地上的定点试验和传感器倾斜试验验证定位精度及传感器倾斜对定位精度的影响。试验结果表明,试验点坐标的估算值与实测值之间距离的均方根误差与平均绝对误差分别为14.75和14.06cm,最大绝对误差为25.72cm;倾斜角度越大,对定位精度的影响越大。研究表明本文定位算法是可行的,且算法简单、运行速度快;实用中当传感器倾斜角度大于5°或者凹凸不平明显的作业环境中,有必要考虑传感器倾斜造成的定位误差的补偿。     

Separation of sardine oil without heating from surimi waste and its effect on lipid metabolism in rats

Sardine oil was obtained by centrifugation of surimi wastewater without heating or chemical refining. This oil (CE) showed light yellow color and the peroxide value was less than 1.0 meq/kg. The main lipid class of CE was triacylglycerol (TG) (>99%). These features indicate that CE can be directly used as food materials without further purification. Commercial sardine oil (CO) is usually prepared via some kind of refining process with high temperature (250 degrees C) and chemical treatment. The comparative study on the physiological effects of these sardine oils (CE and CO) revealed that the dietary sardine oils were more effective in reducing abdominal fat pads, plasma total cholesterol, and TG levels of rats than was a soybean oil diet (control). Furthermore, these effects were greater in CE than CO, although there was little difference in the fatty acid composition of both oils. Although the main lipid class of CE was TG (>99%), CE was prepared by centrifugation from surimi waste and directly used as dietary fat without further purification. Therefore, CE may contain some kinds of minor components, which could be attributed to the higher physiological activity of CE. To reveal the involvement of the minor compounds in CE, we prepared TG from CE by column chromatography and measured its effect on lipid metabolism of rats. TG from CE also showed the reducing effects on abdominal fad pads and plasma lipid levels. The effect of TG from CE was almost the same as that of original CE, suggesting that the higher nutritional activity of CE than CO may not be due to the minor compounds in CE.     

Novel flavonol glycoside, 7-O-methyl mearnsitrin, from Sageretia theezans and its antioxidant effect

A novel flavonol glycoside, 7-O-methylmearnsitrin (7,4'-O-dimethylmyricetin 3-O-alpha-L-rhamnopyranoside), and myricetrin, kaempferol 3-O-alpha-L-rhamnopyranoside, europetin 3-O-alpha-L-rhamnoside, and 7-O-methyl quercetin 3-O-alpha-L-rhamnopyranoside were isolated from the leaves of Sageretia theezans, and their chemical structures were identified by spectroscopic analyses including two-dimensional NMR (HSQC, HMBC). Whereas myricetrin, europetin 3-O-alpha-L-rhamnoside, and 7-O-methylquercetin 3-O-alpha-L-rhamnopyranoside showed stronger activities than ascorbic acid and alpha-tocopherol, 7-O-methylmearnsitrin showed very weak antioxidant activities by ESR and LDL oxidation inhibition tests.     

Influence of surface printing materials on the degradability of biodegradable plastic films in soil

Effect of surface printing on the biodegradability of plastic films was studied. Biodegradable films (polybutylene-succinate (PBS)) printed with four kinds of gravure inks were placed in soil for 1 year. The inks consisted of carbon black-pigment with four kinds of resins: poly-(ε-caprolactone) (PCL), nitrocellulose-polyamide blended resin (NT), polyvinyl chloride-vinyl acetate copolymer (V), and nitrocellulose (NC). Degradation of film specimens printed on one side and both sides as well as the control film without printing was monitored every 3 months by collecting sample specimens for the measurement of weight loss. No appreciable degradation was observed until 6 months after placement in soil for the control specimens and until 9 months for the printed specimens. And the degradation of the PCL- and NC-printed specimens with one-side printing and V-printed specimens with both-side printing was significantly slower than that of the control specimens without printing after 9-month placement at p < 0.05. Only after 12 months of placement, was the degradation significantly faster for the specimens printed on one side than for those printed on both sides except of the specimens printed with NC. There was no difference in biodegradability among PCL, NT, NC, and V resins. Specimens printed on both sides did not show any appreciable weight loss after 1 year in soil (percentage of maintenance of weight exceeding 98%). Microscopic observation indicated that the degradation mainly proceeded from the non-printed side to the printed side cross-sectionally.     

Genetic variation in radish (Raphanus sativus L.) germplasm from Pakistan using morphological traits and RAPDs

Genetic diversity of 30 radish (Raphanus sativus L.) accessions was investigated at the phenotypic level with morphological characters and at the DNA level using the random amplified polymorphic DNA (RAPD) technique. Thirty-six morpho-physiological traits were recorded from seedling stage to harvest. The 31 primers used generated 202 RAPD bands, of which 158 (78.2%) were polymorphic. Multivariate procedures were used to classify the germplasm on the basis of phenotypic traits and RAPD fragments. Dendrograms were generated for the Euclidean distance from the morphological data and the Nei's genetic distance from the RAPD markers. Phenotypically, all the accessions were classified into four major groups corresponding to the different forms of cultivated radish. The morphological diversity existing within each of these groups suggested that they should be discriminated into the three botanical convarieties, sativusT (large-rooted), caudatus (pod-type) and oleifer (oilseed-type). Clustering of the accessions did not show any pattern of association between the morphological characters and the collection sites. Instead, landrace groups were associated with their morphological similarities and horticultural uses. On the other hand, the intra-specific genetic relationships of several accessions based on RAPD analysis were related primarily to their collection sites rather than to their phenotypic affinities. The level of polymorphism exhibited by the various convarieties could be exploited in genetic mapping populations to tag economically important traits. These genotypes also could serve as a useful germplasm source for root, leaf, pod and seed. This preliminary study of traditional radish landraces from Pakistan provides useful information regarding their horticultural potential.     

Modeling of Solute Transport with Bioremediation Processes using Sawdust as a Matrix

Hg and As are widespread contaminants globally and particularly in Asia. We conducted a field study in Baiyangdian Lake, the largest lake in the North China Plain, to investigate bioaccumulation and trophic transfer of potentially toxic metals (total mercury and arsenic) in sites differing in proximity from the major point sources of nutrients and metals. Hg concentrations in fish and As concentrations in water are above critical threshold levels (US Environmental Protection Agency based) considered to pose some risk to humans and wildlife. Hg concentrations in biota are within the range of concentrations in lakes in the Northeast US despite the high levels of Hg emission and deposition in China whereas As concentrations are much higher. Dissolved concentrations of both Hg and As decrease with increasing chlorophyll concentrations suggesting that there is significant uptake of metal from water by algae. These results provide evidence for algal blooms controlling dissolved metal concentrations and potentially mitigating the trophic transfer of Hg to fish. This study also underscores the need for further investigation into this contaminated ecosystem and others like it in China that are an important source of fish and drinking water for consumption by local human populations.     

Measurement of suspended sediment for model experiments using general-purpose optical sensors

A specialized measurement system for measuring suspended sediment concentration in model experiments was developed; it utilizes general-purpose optical sensors to perform measurements. A photoelectric sensor was used for measuring the transmitted light, and a fiber optic sensor was used for measuring the backscattered light. The values of the light absorbance and intensity of backscattered light for turbid standard solutions measured with these sensors show a linear relationship with the turbidity. The calibration lines for sand particles with a large settling velocity were established by using a calibration tank containing upwelling water. The vertical profiles of the sediment concentration measured with the photoelectric sensor corresponded well to those of the sediment concentration measured with a water sampler in an artificial channel. This result suggests that the measurement system using a photoelectric sensor functions satisfactorily. The sediment concentrations measured using the fiber optic sensor correlate well with the concentrations measured through siphon sampling; however, the values measured with the fiber optic sensor are approximately 25% larger than those measured with the siphon. This disagreement may result from the differences in the optical conditions between the calibration tank and the actual channel. Thus, it may be possible to utilize fiber optic sensors calibrated on the basis of siphon sampling for the measurement of sediment concentration.     

Geographic distribution of Waxy gene SNPs and indels in foxtail millet, Setaria italica (L.) P. Beauv.

To elucidate diversity and evolution of the Waxy gene in foxtail millet, Setaria italica, we analyzed sequence polymorphism of Waxy gene in 83 foxtail millet landraces collected from various regions covering the entire geographical distribution of this millet in Europe and Asia. We found a unique geographic distribution pattern at the sequence level of gene haplotypes and also found a large diversity in East Asian landraces. We also found a higher degree of genetic polymorphism in a non-waxy phenotype than in other low amylose types, supporting the hypothesis that low amylose types recently originated from non-waxy type.