Design of the PC/104 Bus Mode Multi-channel Analyzer

This paper expatiates on the bus structure and develop the bus mode Multi-Channel Analyzer (MCA). The nucleus of this MCA is the PC/104 embedded computer, and it introduces the bus communication to realize system and data communication. It may realize data collecting and showing in the field, because the bus mode is rapid. At first, on the hardware we introduce CMOS components, this reduces power, volume and weight. These make it adapts to use in the field; besides, on the software we adopt C and assembly language to program in order to improve conversion speed. At the same time, single-task DOS operating system is infroduced, which makes the software run more steadily, operate more simply. By means of testing on the spot it can normally work, so it suitable to work in the field.     

One-cycle Technique Based Adjustable Ac Source

By using one-cycle control theory, a novel voltage source inverter is proposed. The conventional one-cycle control technique needs that the integrator is reset instantaneously. But it is very difficult to realize with hardware due to the finite time constant of the reset circuitry. Therefore, based on the one-cycle technique, the paper gives a new control scheme to resolve the problem with dual switched integrator, and the performance of the integrators is close to ideal. The paper also uses the dc offset to implement the voltage measurement. Furthermore, the amplitude and frequency of the output voltage are effectively adjustable. The one-cycle control technique not only provides fast dynamic response, but also can admirably suppress the perturbation yielded by dc source and abate the undesired harmonic contents. Simulation studies were performed to prove the proposed scheme. The results show that the one-cycle control based voltage source inverter makes good use of dc source that is 92.8% and THD is only O. 255 9%.     

Nonlinear FEM Analysis of RC Staggered Joint by Using APDL Language

In order to settle some problems involved in applying ANSYS into nonlinear Finite Element Analysis of RC structure,this paper discusses the nonlinear FEM method for staggered joint,incorporating its experimental result.The main solved problems are as follows:(1) The fundamental process of nonlinear FEM analysis;(2) How to model the behaviors of reinforcement and concrete respectively;(3) How to model the bond-slip relationship between reinforcement and concrete.     

农业合作社发展中的问题和对策

农业专业合作社是农民,实现自我发展的有效形式之一,目前一些政府部门中仍然存在对农业合作社认识不清、扶持不力的状况,农业合作社在发展中存在诸多障碍。必须加强政府对农业合作社的领导和扶持,适时进行制度创新,规范合作社内部运行机制,积极探索工业“反哺”农业,城市“反哺”农村的途径和方法,把中央政策落到实处。     

棉田膜内与膜间土壤溶液含盐量的变化

用定期取表层土样测定其电导率和在不同深度埋设盐分传感器探头的方法 ,在作物生长季节内 ,监测了棉田膜内和膜间不同深度的土壤溶液含盐量变化。结果为 :1棉田膜内与膜间表层土壤和 1 0 cm、30 cm深土壤溶液含盐量变化较大 ,且规律相同。未灌水时上升 ,灌水后迅速下降。膜间未灌水期间的含盐量上升幅度大于膜内 ,灌水对膜内和膜间表土洗盐、1 0 cm、30 cm深土壤溶液含盐量的降低作用没有差别。降雨可引起膜内和膜间 1 0 cm深土壤溶液电导率的变化 ,这个影响也是膜间大于膜内。 2 60 cm深的土壤溶液不存在明显的盐分累积现象 ,灌水可使这里的土壤溶液含盐量缓慢降低 ,膜间的降低过程快于膜内     

南方平原灌区渠道防渗工程规划方案决策分析

针对目前灌区防渗渠道规划的局限性，引入价值工程的概念，并根据南方平原地区灌区的特点，应用计算机模拟技术，通过对渠道的衬砌费用和节水量的模拟计算，得出更为切合实际的灌区防渗渠道投资效益评价指标，从而确定防渗工程的最优布局以及工程实施的先后顺序。     

农村小水电站机组增容改造的方法

我国在20世纪70年代兴建的小水电站已运行了几十年，随着新技术与新材料的应用，对老电站进行增容改造，提高电站的调峰能力是提高电站和县电网经济效益的关键措施之一。介绍了机组增容改造的方法和实际应用中应注意的问题。     

低压电力系统配电母线N级联锁的算法

在电力系统中，由于开关容量及运行方式限制，通常在低压系统中多采用1段母线、1台变压器运行方式。为了避免这种运行方式在母线检修、故障时可能造成停电的缺点，因此可用断路器将单母线分段。母线经断路器分段后。对重要用户可以从不同段引出两个回路，有两个电源供电。母线分段的数目。可以根据电源数目和容量来分．段数越多，停电的范围越小，所需电气设备越多．一般以4～6段为宜。本文对此配电母线进行N级联锁推导其算法．有利于今后解决多级联锁的问题。     

今年我国进口木材仍将以俄罗斯北洋材为主

尽管近年来俄罗斯政府林业部门及普京总统本人多次施以政策手段或公开讲话强调,为保护本国森林资源,大幅度提高原木出口关税,并且限制未加工木材出口,增加深加工后的木材出口量,以保证木材工业的经济效益。然而今年以来,我国进口木材的主要品种原木和锯材中,仍是从俄罗斯进口的北洋材再唱主角。     

褐土区氮磷在土壤发生层中淋溶的差异性

农业氮磷淋溶已经成为地下水污染最普遍和突出的问题。为揭示氮磷在包气带不同土层的淋溶特征,以典型褐土的5个土壤发生层（耕层、淋溶层、钙积层、黏化层和母质层）为研究对象,采用室内土柱模拟淋溶试验,在施肥量相同的条件下分析不同形态氮磷淋溶量,研究氮磷在不同土壤发生层中的迁移特征及其影响因素。结果表明：1）进行5次淋溶,耕层、淋溶层、钙积层、黏化层和母质层淋溶液中可溶性总氮总量分别为2412.63 mg·L^-1、3028.94 mg·L^-1、244.16 mg·L^-1、3648.99 mg·L^-1和3356.51 mg·L^-1,淋溶层、黏化层和母质层可溶性总氮淋溶量显著高于耕层,而钙积层可溶性总氮淋溶量较耕层显著减少;耕层淋溶液中可溶性总磷总量为0.52 mg·L^-1,且显著高于其他4层。2）在试验初期,耕层、淋溶层的硝态氮、可溶性总氮和正磷酸盐淋溶量显著高于黏化层和母质层,进行到第4、5次淋溶,黏化层、母质层的硝态氮和可溶性总氮淋溶量显著高于其他3层,而各发生层间正磷酸盐淋溶量无显著差异;单次淋溶黏化层和母质层铵态氮淋溶量均显著高于其他3层,而耕层可溶性总磷淋溶量始终显著高于其他各层。3）耕层和钙积层的淋溶液中硝态氮是氮素淋溶的主要形态,占可溶性总氮比例分别为69.0%和85.4%,而在淋溶层、黏化层和母质层中分别为41.3%、5.1%和4.6%;在可溶性磷中,以无机态正磷酸盐为主,最高占可溶性总磷的75.9%。4）土壤有机质含量、阳离子交换量、黏粒含量对土壤氮磷的迁移转化有明显主导作用。有机质与氮磷淋溶量呈显著正相关关系,有机质含量高,会增加淋溶初期氮磷的淋溶风险;而阳离子交换量和黏粒含量则与氮磷淋溶呈显著负相关关系,阳离子交换量大和黏粒多能减少氮磷素的淋溶风险。该试验结果说明,由于5种发生层土壤理化性质不同,各发生层氮磷淋溶特征及其淋溶形态也有差异,并且氮磷的淋溶受土壤本身阳离子交换量、黏粒和有机质含量的影响。