Reduced efficacy and enhanced degradation of carbetamide after repeated application in Australia

Following reports of poor weed control, the effectiveness of repeated applications of carbetamide atid propyzamide in controlling Lolium rigidum Gaud, (annual ryegrass) was examined under field conditions. Repeated applications of carbetamide or propyzamide were less effective in controlling L. rigidum than an initial application. A single application of carbetamide or propyzamide was sufficient approximately to halve the efficacy of a subsequent treatment with the satne herbicide. Laboratory incubations of soil linked the poor performance of carbetamide upon repeated application to an enhanced deg-radation rate. We conclude that the repeated application of carbetamide or propyzamide results in less effective weed control under field conditions and that this can be partially avoided by rotation between carhetamide and propyzamide.     

Effects of some nonionic polyoxyethylene surfactants on uptake of ethirimol and diclobutrazol from suspension formulations applied to wheat leaves

The influence of a number of commercial nonionic polyoxyethylene surfactants on the foliar penetration and movement of two systemic fungicides, ethirimol and diclobutrazol, was studied in outdoor-grown wheat plants at different growth stages and post-treatment temperatures in two consecutive growing seasons. Both fungicides were applied as ca 0·2 μl droplets of aqueous suspension formulations containing 0·5 g litre^?1 of ¹⁴C-labelled active ingredient; surfactants were added to these suspensions at concentrations ranging from 0·2-10 g litre^?1. To achieve optimum uptake of each fungicide the use of surfactants with different physicochemical properties was required. For diclobutrazol, a lipophilic compound, uptake of radiolabel was best with surfactants of low mean molar ethylene oxide (E) content (5-6) but it was necessary to use concentrations of ca 5 g litre^?1 to attain this. The surfactant threshold concentration for uptake enhancement of radiolabel from ethirimol formulations (< 2 g litre^?1) was much lower than that for diclobutrazol but surfactants with E contents > 10 induced the greatest amount of uptake. For both fungicides, surfactants with an aliphatic alcohol hydrophobe were generally more efficient in promoting their uptake than those with a nonylphenol moiety. The sorbitan-based surfactant ‘Tween 20’ proved to be an effective adjuvant only for the ethirimol formulation; the uptake enhancing properties of the block copolymer ‘Synperonic PE/F68’ were weak. Uptake performance could not be related to the spreading properties of the respective formulations on the wheat leaf surface or to differences in solubilisation of the two fungicides by the surfactants. Although surfactants could substantially increase the amount of acropetal transport of radiolabel from both fungicides, none of those tested specifically promoted it; a constant proportion of the radioactive dose absorbed by a treated leaf was usually exported away from the site of application. The results are discussed in the light of current theories about the mode of action of surfactants as spray adjuvants.     

Effect of liming on extractable Zn, Cu, Fe and Mn in selected Scottish soils

Ten naturally acidic Scottish soils have been limed with CaCO₃ at 0,0.25, 0.50, 0.75, 1.00 and 1.25 times the recommended lime requirement, and then subjected to three cycles of alternate wetting to field capacity at 20°C for 1 month and drying for 1 month. The Zn, Cu, Fe and Mn extracted by DTPA solution, both at pH 7.3 and also after adjustment to match the final soil pH, were measured by flame AAS. The same elements were determined in ammonium acetate extracts, for extractants buffered at pH 4.8, pH 7.0 or at the final soil pH. The effect of extractant pH upon the amounts of trace elements removed is discussed for the two extractants, with particular reference to Zn. The influence of soil pH upon the amounts of trace elements extracted is also considered. There appears to be a distinct relationship between rate of decrease of DTPA-extractable Fe with increasing soil pH and the effect of pH upon DTPA-extractable Zn, high rates of decrease of extractable Fe being associated with a more continuous decline in extractable Zn with increasing soil pH. Possible reasons for this relationship are discussed, in the light of an experiment conducted to examine the effect of Fe and A1 on loss of Zn from solution at high pH. DTPA-extractable Cu varied little with increasing soil pH.     

Genetic improvement of the Pacific oyster Crassostrea gigas (Thunberg) in Australia

The Pacific oyster industry in Australia is derived from importations from Japan in the late 1940s and early 1950s to Tasmania and is almost completely hatchery based. This makes it a good target for developing and deploying genetically improved strains. An allozyme survey comparing hatchery stocks with self‐recruiting Tasmanian stocks and with two collections from Japan found abundant variation and no significant evidence of allele loss. The subsequent selection programme (initiated in the summer of 1996/97) had several strands. We wanted to take advantage of the increased power that marker‐assisted selection could bring and, therefore, needed to develop a linkage map and isolate flanking markers around quantitative trait loci (QTLs). Several types of markers (allozymes, microsatellites and AFLPs) were used, and single‐pair crosses were set up; QTLs have been detected. Conventional selection programmes, one based on mass selection and one on family selection, have been established. Triploid Pacific oysters produced via chemical means have been available for several years, but rates of triploidy achieved by such means are usually less than 100%. In 1999, we will assess whether our tetraploid 2‐year‐old broodstock can be crossed with diploids to give 100% triploid offspring.     

Transpiration-induced axial and radial tension gradients in trunks of Douglas-fir trees

We determined the axial and radial xylem tension gradients in trunks of young Douglas-fir (Pseudotsuga menziesii (Mirb.) Franco) trees. Axial specific conductivity (k(s-a)) and sap flux density (Js) were measured at four consecutive depths within the sapwood at a stem height of 1 m. By definition, at a given position in the bole, Js is a function not only of k(s-a) but also of the driving force for water movement. The Js:k(s-a) ratio was therefore used to estimate axial tension gradients and the radial gradients at a stem height of 1 m were calculated from the differences in axial tension gradients at each depth. Tracheid lumen diameter and tracheid length were used to predict differences in k(s-a) and its divergence from the theoretical k(s-a) determined by the Hagen Poisseuille equation. The ratio of k(s-a) (determined in the laboratory) to Js (measured in the field) varied with depth in the sapwood, resulting in non-uniform axial and radial tension gradients from inner to outer sapwood. Transpiration-induced axial tension gradients were in the range of 0.006-0.01 MPa m(-1) excluding the gravitational tension gradient. At a stem height of 1 m, radial tension gradients were in the range of 0.15-0.25 MPa m(-1) and were lower in the middle sapwood than in the inner or outer sapwood. Axial tension gradients were 44-50% higher in the outer sapwood than in the inner sapwood. At a stem height of 1 m, radial Js, calculated on the basis of radial tension gradients and measured radial specific conductivity (k(s-r)), was about two orders of magnitude smaller than axial Js. Our findings indicate that large radial tension gradients occur in the sapwood and clarify the role played by xylem k(s-a) and k(s-r) in determining in situ partitioning of Js in the axial and radial directions.     

Characterization ofSolanum tuberosum simple sequence repeats and application to potato culiwar identification

With the continued introduction of new potato cultivars, accurate identification is becoming difficult but is essential for maintaining cultivar integrity and Plant Breeders’ Rights. Hypervariable DNA sequences, referred to as simple sequence repeats (SSRs) or microsatellites, have been reported to be an excellent source of genetic markers. To determine the abundance, distribution, and composition of SSRs withinSolanium tuberosum, 252 sequences were searched for tetranucleotide and smaller SSRs with a minimum length of 20 nucleotides and a maximum discrepancy of two nucleotides. In total, 40 unique SSRs were observed in the 252S. tuberosum sequences examined and occurred at a frequency of one SSR every 8.1 kb. To assess the ability of site-specific amplified SSRs to identify potato cultivars, a simple (TCAC)_m and compound (TCAC)_m ? (CTT)_n SSR 5’ to the starch synthase gene and a compound (C)_p ? (CT)_q ? (AT)_r ? (G)_s SSR 5’ to the sequence encoding mature proteinase inhibitor I, were examined and shown to produce unique DNA profiles for 73 of 95 tetraploid cultivars. In total, 24 alleles were observed at these loci and the accurately sized amplified DNA products can be used to establish a database for cultivar identification. Site-specific amplified alleles were somatically stable and have been conserved in clonal variants of Russet Burbank independently maintained for almost seven decades, a characteristic essential for cultivar identification. As genetic markers, the abundant, informative, and easily examined site-specific amplified alleles of SSRs are ideal for quickly and accurately determining cultivar identity of S.tuberosum ssp.tuberosum.