Heating performance analysis of multi-nozzle water-jet steam ejector

Abstract:This paper developes a heating coefficient model to study the heating performance of multi-nozzle water-jet steam ejector. It analyzes the factors of heating performance, and explores the relationships between the heating performance and different operating parameters theoretically and experimentally. The results show that the heating performance of multi-nozzle water-jet steam ejector is very good. The heating coefficient decreases with the increase of the inlet water temperature, and increases with the increase of the steam pressure and ejecting coefficient. The relationships between heating performance of ejector and different operating parameters by calculation and experiment are in good agreement.     

Image denoising using HMT in PDTDFB domain

Based on the dependency of the PDTDFB coefficients across the interscale and interdirection and the statistical properties of HMT for the correlation properties, a new HMT in PDTDFB domain was put forward. Compared with the other typical denoising methods, the experimental results demonstrate that the proposed method shows better performance in image denoising, especially in edge maintenance.     

Application of time-frequency distribution correlating and matching method in signal extraction

The time-frequency coupling relation between useful non-stationary components and noises bring great difficulties to the realization of de-noising for non-stationary signals,which can not be solved by classic de-noising method in time or frequency domain. The principles of short time Fourier transform(STFT),Wigner-Ville transform,Chirplet adaptive decomposition are analyzed,and then a novel de-noising method for non-stationary based on joint time-frequency distribution is proposed. In this method,the analyzed signal WVD is seen as the combination of auto-WVD and cross-term WVD. Firstly,STFT energy spectrum of the analyzed signal is used as template to cross-correlate with its corresponding WVD in order to obtain the satisfactory time-frequency distribution with high time-frequency resolution and without cross-term interferences. Secondly,the useful components are decomposed as Chirplet function using the two-dimension least square fitting method,and then are extracted out to reconstruct for noise suppression. Finally,the computer simulation results verify the effectiveness of this proposed method. Its application in gearbox fault diagnosis indicates that with the method the extracted cycle of the gearbox vibration impulses has a good consistency with the corresponding fault frequency.     

Effect of cooling rate on high temperature mechanical properties of weathering steel

High temperature mechanical properties are key factors which affect fracture production during deforming process of continuous casting. High temperature properties of weathering steel Q450NQR1 are tested in 3 cooling rates (1.65, 5, 10 ℃/s) using Gleeble thermo-mechanical simulator. Specimens appear austenite dynamic recrystallization at 1 050 ℃, and the ductility reaches the lowest point and the reduction of area approaches 23% at 850 ℃ in 3 cooling rates. As the cooling rate increases, the low ductility area where cracks are easy to be produced in slabs is enlarged and extended towards low temperature, and the ductility troughs are deepened. The increase of the cooling rate decreases the tensile stress and yield stress, while when the cooling rate increases to some degree, it doesn’t affect the stress. The low cooling rate decreases the film or network ferrite producing in austenite grain boundary, and the carbonitride of microalloy is enwrapped in matrix, which is helpful to improve the ductility of steel.     

Input-output budgets for nitrogen in a typical purple soil sloping ploughland in Three Gorges areas

The Xinzheng watershed in Zhongxian county, Chongqing, is a typical purple soil sloping ploughland in the Three Gorges areas. In 2009, the input-output budgets in this watershed is investigated and the results indicate that the nitrogen input is 918.26 kg/(hm2·a) and the output are 569.46 kg/(hm2·a). Furthermore, chemical fertilizer nitrogen is the main input source, accounting for 57.63%, and the main output track is nitrogen in crops, accounting for 36.22%. In this small watershed, the nitrogen loss load is 258.77 kg/(hm2·a). And the primary lost nitrogen is gaseous species, which is approximately 65.11% of the total lost nitrogen. In addition, nutrient nitrogen balance index is 3.4 in this watershed and the nitrogen surplus load is 348.80 kg/(hm2·a), much higher than the risk value, indicating potential occurrence pollution in ploughland.     

Stiffness optimization of vehicle engine magneto-rheological fluids mounts

As important tool for engine semi-automatic isolation system, the magneto-rheological fluids (MRC) can’t achieve tunable stiffness but damping. Therefore, the MRC’s initial stiffness affects the performance of isolation system. To obtain the better isolation effect of MRC in wide frequency, it is necessary to optimize the initial stiffness. As motor unbalanced force and isolation damping are not considered in traditional mount optimization, the feature of semi-automatic control can not be reflected. For a four-cylinder four-cycle in-line diesel engine, a new method which is suitable for stiffness optimization on vehicle engine isolation is presented by using Genetic Algorithm. The optimal isolation system has small absolute force transmissibility in abroad frequency range and small vibration intensity with impact load by using the new method.     

基因型及外源因子对小麦花药培养一步成苗的影响

研究了不同基因型及几种外源因子在小麦花药培养一步成苗中的效应。结果表明 ,花药培养一步成苗的愈伤组织诱导率、绿苗分化率、白苗分化率及绿苗产量存在基因型间的差异。高蔗糖浓度有利于获得高频率的花药愈伤组织 ,但同时又提高了花药培养中白化苗频率。动力精 (KT)对花药愈伤组织诱导率影响的差异不大 ,但对绿苗分化率、绿苗产量及绿苗 /白苗 (G/ W)均有显著影响。在试验浓度范围内 ,随 KT浓度的增大 ,绿苗产量提高 ,绿苗分化率明显增加 ,而白苗分化率下降 ,因而 G/ W值明显增大。说明 KT主要是通过提高绿苗分化率和降低白苗分化率 ,增大 G/ W而提高花培一步成苗效率的。在与 KT的配合使用中 ,2 ,4 - D比 NAA更有利于提高小麦花药培养中的愈伤组织诱导率和苗分化频率     

肉鸽营养需要与饲料研究进展

概述了近年来我国肉鸽的能量、蛋白质等营养需要与饲料研究进展，提出了建立攻关协作网络和研究、制定、颁布肉鸽饲养标准的建议，期望对肉鸽的科研、生产及发展有所帮助。     

Using of AFLP Marker to Predict the Hybrid Yield and Yield Heterosis in Rice

利用AFLP分子标记对46个水稻品种进行遗传多样性分析,继而研究分子标记遗传距离与按照NC设计获得的195个杂交组合的产量及特殊配合力的相关性,探讨预测杂种优势的可能性。结果表明:(1)通过UPGMA聚类分析(图3),可将供试材料分为16个类群,并把来源不明的品种(系)划分到相应类群中,从而对这些材料进行初步鉴定。可见,AFLP分子标记是检测类内品种间遗传差异的有效方法,为水稻品种(系)亲本选配提供理论依据。(2)分子标记遗传距离与杂种产量优势、F1产量、特殊配合力之间都呈显著正相关,相关系数介于0.3235-0.7713之间。但相关程度还不足以预测杂种优势。增效座位和减效座位以及使用与杂种优势有关的QTL连锁标记位点可能提高杂种优势的预测能力,但最终解决,将依赖于杂种优势遗传机理的研究。     

猕猴桃果醋的研制

初步探讨了以榨汁后的猕猴桃果渣、玉米粉、麸皮为原料 ,经酒精发酵和醋酸发酵酿制猕猴桃果醋的生产工艺。结果表明 :猕猴桃鲜果渣与淀粉质原料以质量比 1∶ 1混合 ,添加 3g/ kg混合发酵剂和 1g/ kg醋酸菌 ,在 30～ 35℃下酒精发酵 6～ 9d,然后在 35～ 4 5℃下醋酸发酵 10～ 12 d,酿制出色泽棕红 ,果香突出 ,口味柔和协调的猕猴桃保健果醋