轴流泵叶轮进出口流场的测量

为了获得轴流泵内部流动的真实情况,设计了内部流动测量装置.运用五孔球形探针,对高效轴流泵在0.8Qopt,1.0Qopt和1.2Qopt工况下的叶轮进口和出口速度矢量分布、静压分布和总压分布进行了测量,并分析了不同工况下的轴面速度、环量、圆周方向分速度和压力分布等.测量结果表明：轴流泵模型进口在0.8Qopt至1.2Qopt工况范围内,流动稳定,进口轴向速度从轮毂到轮缘逐渐减小,且进口预旋很小,不同径向位置的静压基本相等.在最优工况下,轮毂与可调叶片间无间隙时,轴流泵叶轮出口基本呈现等环量流型,轴面速度呈现抛物线分布,且效率高.若轮毂侧存在间隙,间隙处的环量、轴面速度、压力和效率均明显下降.     

基于特征线方程N—S方程非增量型分离算法

为克服传统有限元方法求解流场时由于对流项占优而引起的求解振荡和基函数选择困难的问题,推导了基于特征线方程的粘性不可压N-S方程的增量型和非增量型分离算法的公式及求解步骤,并讨论了两者的Babuska-Brezzi条件.沿着特征线方向,N-S方程的对流项消失,方程矩阵是自伴随矩阵,可以自动满足有限单元法中能量泛函最小的要求,并可以给出合理的粘性耗散项.动量方程的求解采用非增量型分离算法,压力和速度可以采用任意阶次的插值函数,离散后的方程自动满足Babuska-Brezzi条件.为验证算法的可靠性,采用T3P3空间等阶次U-p单元计算了方柱绕流.结果表明：基于特征线方程的非增量型分离算法可以很好地应用于粘性不可压流场的计算,与目前流行的其它方法相比,该算法有明显的优势.     

Transpositional feeding rhythm of loach <Emphasis Type="Italic">Misgurnus anguillicaudatus</Emphasis> from larvae to juveniles and its ontogenesis under artificial rearing conditions

The diel feeding rhythm and ontogenesis during early life stage of loach Misgurnus anguillicaudatus were investigated under experimental conditions (light: L 06:00–18:00, D 18:00–06:00 h). Morphological and behavioral developments of loach from newly hatched to 40 days after hatching were observed. Larvae were able to prey on daphnia 3–4 days after hatching at 23 ± 0.5°C. As the larvae grew, they showed an increasing feeding capacity and a distinct feeding rhythm. Feeding intensity and incidence for day-4 larvae were highest at 10:00 and 16:00 h. The highest levels of feeding intensity for day-12 larvae occurred at 08:00, 12:00, and 18:00 h as did feeding incidence. By day 20, when the larvae metamorphosed, the highest levels of feeding intensity occurred at 06:00, 18:00, and 24:00 h and were concurrent with the highest feeding incidence. After metamorphosis, feeding capacity had again increased considerably and, in contrast to the earlier stages before day 20, feeding intensity for day-30 juveniles peaked at 05:00 and 20:00 h, about 1–2 h after the maximum feeding incidence. The feeding rhythm of loach juveniles at day 40 was almost the same as the day-30 juveniles. The estimated maximum daily feeding rates were 43.1%, 33.4%, 19.0%, 12.8%, and 5.8% of body weight on days 4, 12, 20, 30, and 40, respectively. Thus, loach was found to have different feeding rhythms in the pre- and post-metamorphosis stages, with the highest feeding activity in daytime during the larval planktonic stage before metamorphosis, and intensely nocturnal feeding behavior during the juvenile benthic stage after metamorphosis.     

海水育苗锅炉的节能降耗

海水养殖业中耗能较大的环节是海水育苗,因为育苗企业鼓风机天天转、锅炉天天烧、水泵天天抽,既是耗煤大户又是耗电大户,所以海水育苗行业如何在保证正常生产的前提下把能耗降下来是今后育苗生产中的一个重要工作。在此,笔者就本行业锅炉的一些使用方法略做说明。     

Preparation of PHEMA/nHAP nanocomposites via <Emphasis Type="Italic">in situ</Emphasis> polymerization in supercritical carbon dioxide for biomedical applications

Poly(2-hydroxyethylmethacrylate) (PHEMA)/hydroxyapatite (HAP) nanocomposites were synthesized through a new route involving nano-sized HAP (nHAP) particles or modified nHAP mixed with monomer 2-hydroxyethylmethacrylate via in situ polymerization in supercritical carbon dioxide (scCO₂). Fourier-transform infrared spectroscopy showed phosphate peak increased with nHAP content in composite. X-ray diffraction patterns of PHEMA/nHAP revealed the presence of crystallized nHAP. Thermogravimetric analysis showed that the ultimate nHAP content in PHEMA/nHAP composites is consistent with its initial amount. Scanning electron microscopy revealed that nanocomposite particles are much smaller than PHEMA particles. PHEMA/nHAP composites with average diameter of approximately 600 nm were obtained in scCO₂ with 94 % yield. Mechanical properties of PHEMA/nHAP nanocomposites were better than those of PHEMA, and compressive modulus and strength of composites with 30 wt.% nHAP were 193 and 29 MPa, respectively. Nanocomposite adsorption toward bovine serum albumin was evaluated, and results indicated that analyte adsorption amount can reach up to 282 mg/g.     

Conferring resistance to pre-harvest sprouting in durum wheat by a QTL identified in <Emphasis Type="Italic">Triticum spelta</Emphasis>

Pre-harvest sprouting (PHS) causes significant yield loss and degrade the end-use quality of wheat, especially in regions with prolonged wet weather during the harvesting season. Unfortunately, the gene pool of Triticum durum (tetraploid durum wheat) has narrow genetic base for PHS resistance. Therefore, finding out new genetic resources from other wheat species to develop PHS resistance in durum wheat is of importance. A major PHS resistance QTL, Qphs.sicau-3B.1, was mapped on chromosome 3BL in a recombinant inbred line population derived from ‘CSCR6’ (Triticum spelta), a PHS resistant hexaploid wheat and ‘Lang’, a PHS susceptible Australian hexaploid wheat cultivar. This QTL, Qphs.sicau-3B.1, is positioned between DArT marker wPt-3107 and wPt-6785. Two SCAR markers (Ph3B.1 and Ph3B.2) were developed to track this major QTL and were used to assay a BC₂F₈ tetraploid population derived from a cross between the durum wheat ‘Bellaroi’ (PHS susceptible) and ‘CSCR6’ (PHS resistant). Phenotypic assay and marker-assisted selection revealed five stable tetraploid lines were highly PHS resistant. This study has successfully established that PHS-resistance QTL from hexaploid wheat could be efficiently introgressed into tetraploid durum wheat. This tetraploid wheat germplasm could be useful in developing PHS resistant durum cultivars with higher yield and good end-use quality.     

高强钢焊接薄腹工形截面双向压弯构件的稳定性

应用ANSYS有限元,分析了Q460高强钢焊接薄腹工形截面双向压弯构件的稳定性能,提出了可供实际应用参考的设计公式。分析中考虑的主要参数有腹板高厚比,构件长细比,翼缘宽厚比及荷载偏心率。结果表明,对受压为主的构件,腹板局部屈曲对构件稳定承载力影响较大,而对受弯为主的构件,这一因素对构件稳定承载力影响较小。有限元分析结果与现行规范方法计算结果比较表明,目前规范方法尚不能较好地计算高强钢焊接薄腹工形截面双向压弯构件的稳定承载力,因而提出了修正直接强度法,该法精度较好且偏于安全。     

钾硅钙微孔矿物肥对水稻重金属镉的降阻效果研究

为了探明钾硅钙微孔矿物肥对污染稻田土壤重金属镉(Cd)有效性的影响,弄清其对稻谷中Cd含量的降低效果。采用田间小区试验和室内分析测定方法进行研究,试验设5个处理,处理1:对照(CK),常规施肥(40%复合肥450 kg/hm2);处理2:钾硅钙微孔矿物肥600 kg/hm2+常规施肥;处理3:钾硅钙微孔矿物肥750 kg/hm2+常规施肥;处理4:钾硅钙微孔矿物肥1125 kg/hm2+常规施肥;处理5:钾硅钙微孔矿物肥1425 kg/hm2+常规施肥。结果表明:钾硅钙微孔矿物肥可以显著提高水稻穗总粒数、穗实粒数和结实率,提高水稻产量,增产率达到7.5%~16.0%;增加土壤碱解氮、有效磷和速效钾含量,提高土壤pH值,降低土壤有效Cd含量,从而降低稻谷Cd的积累,最大降低稻谷Cd含量达到38.6%。钾硅钙微孔矿物肥要达到降阻水稻重金属Cd的最佳效果,施用量不能低于1425 kg/hm2。     

浅圆仓膜下氮气气调膜上控温储粮试验

通过改造浅圆仓测温电缆,实现了浅圆仓膜下充氮气调和膜上中央空调控温,提高了卸粮口、大门口、通风口等死角的害虫致死率。将浅圆仓氮气气调杀虫与控温储粮相结合,实现了储粮安全度夏。     

2018年我国农药进出口特点与2019年趋势分析

Li Lin;Jin Hejiang;Huang Xinhe;Cao Bingwei;Wu Lihui;Liu Pingping;Qu Mengmeng;Wu Houbin(The Institute for the Control of Agrochemicals,Ministry of Agriculture and Rural Affairs,Beijing 100125,China)