Critical drainage and nitrate leaching losses from manures applied to freely draining soils in Great Britain

Abstract. Pig slurry was applied by open-slot injection to experimental plots on a sandy loam site at ADAS Gleadthorpe, Nottinghamshire. Volume and distribution of over-winter drainage were adjusted through the use of rainfall exclusion covers or irrigation. The resultant slurry N leaching over the range of drainage values tested (up to 300 mm) could be satisfactorily described by curve-fitting, using a quadratic or exponential function. Initial simulations of slurry N leaching using the manure nitrogen decision support system manner (v. 3.0) compared poorly with the experimental data, predicting both earlier and greater amounts of nitrate leaching. However, the lack of fit could be explained by consideration of the likely ammonia emissions following slurry injection, the actual volumetric soil moisture capacity at the experimental site and the likely time delay for the nitrification of slurry N following application. Good agreement between modelled and observed data was achieved when these factors were taken into account. The manner model was used to simulate nitrate leaching beyond the range of drainage treatments tested in the experiments and the anticipated sigmoidal relationship between nitrate leaching and drainage was observed. The model was then used to study the effects of manure application timing and the likely impact on nitrate leaching, across the range of rainfall conditions found in Great Britain. Simulations for a range of manure types were undertaken, with manures applied at rates up to the limit of permitted N loading on freely draining sandy loams. Rainfall inputs for these simulations were based on long-term average climatic data. Results are presented for two contrasting manure types, cattle slurry and poultry manure, both of which are subject to controls in Nitrate Vulnerable Zones (NVZs) in Great Britain.     

A linear functional relationship model for circular data with an application to the assessment of ocean wave measurements

This article suggests a linear functional relationship model for comparing two sets of circular data subject to unobservable errors. Unlike the corresponding and relatively well-studied model for linear data, maximum likelihood estimation for this model is very complicated and no explicit solutions are possible. Using a numerical approximation, we are able to solve the likelihood equations approximately, and to obtain good approximations to the likelihood estimates of the parameters. The quality of our estimates and the feasibility of the estimation method are illustrated via simulation. By establishing a parallel with the model for linear data, we are able to explain the various problems occurring in the process of estimation and to substantiate our numerical results. The interest in the model arose in connection with the study of ocean wave data; an application to such data is also given.     

Technique to Measure Surface‐Fouling Tendencies of Steepwater from Corn Wet Milling

Surface‐fouling tendencies of raw light steepwater (LSW) and membrane‐filtered light steepwater (FSW) from corn wet‐milling were studied using an annular fouling probe. The probe contained a heated surface to simulate the surface temperature of an evaporator. The heated region caused a fraction of solids in the steepwater to adhere to the surface, thus fouling the probe over time. FSW samples were prepared by filtering LSW using a microfiltration membrane with a nominal pore size of 0.1 μm. Fouling tendencies of both samples were established at an initial probe wall temperature of 99°C. Batches (30 L) were circulated through the fouling probe until the inner surface temperature of the probe reached 200°C. Temperature and power supplied to the probe were measured over time and used to calculate fouling resistance and rate of fouling. Measurement of maximum fouling resistance and fouling rate had a coefficient of variation (COV) of 5.1 and 7.4%, respectively. Maximum fouling resistances attained over a 12‐hr period were 0.36 and 0.049 m² °C/kW for LSW and FSW, respectively. Average rates of fouling were 4.53 × 10^‐4 and 0.82 × 10^‐4 m² °C/kW/min for LSW and FSW, respectively, showing an 80% decrease in fouling rate using microfiltration to remove 19% of solids.     

Genetic diversity assessment of Ethiopian tetraploid wheat landraces and improved durum wheat varieties using microsatellites and markers linked with stem rust resistance

A set of 77 markers was used to describe the genetic diversity in a group of 58 tetraploid wheat accessions. Analysis was performed using 31 neutral SSR markers, 31 SSR/STS markers linked with reported major stem rust resistance genes and 15 SSR markers linked with QTL identified for resistance to Ethiopian stem rust races of Puccinia graminis Pers. f. sp. tritici Eriks. et E. Henn. (Pgt),including Ug99. The material consisted of 32 (Triticum durum s.l. incl. T. aethiopicum Jakubz., Triticum turgidum and Triticum polonicum) landraces and 22 registered T. durum varieties from Ethiopia that were released 1966–2009 and four T. durum varieties from ICARDA. A total of 720 alleles were detected. Considering the three marker sets, the mean number of alleles was higher for major stem rust resistance gene linked markers (9.9) followed by neutral SSR markers (9.2) and markers linked with QTL for stem rust resistance (8.5). Dendrograms derived from UPGMA analysis grouped the accessions into two major clusters. The principal component analysis based on the combination of the three marker sets formed three groups. The 1st group was composed of all the improved varieties, whereas the 2nd and the 3rd group contained the landraces. All the landraces that formed the 3rd group were susceptible to Ethiopian stem rust races of Pgt including Ug99. The information on the extent of the genetic diversity of the improved varieties obtained in this investigation will be helpful for developing appropriate breeding strategies to broadening the genetic base of durum wheat varieties in further breeding programmes.     

Multiple domestications of the Mesoamerican gene pool of lima bean (Phaseolus lunatus L.): evidence from chloroplast DNA sequences

The Mesoamerican (MA) gene pool of lima bean (Phaseolus lunatus L.) is widely distributed from northern Mexico to northern Argentina in its wild forms and from the southern United States to the east coast of Brazil in its domesticated forms. This broad distribution and lack of wild accessions of the MA gene pool in many areas of its natural distribution has impeded determining its center of domestication and establishing whether it has a single or multiple centers. To answer these questions, we evaluated 262 accessions of P. lunatus using two intergenic spacers of chloroplast DNA: atpB-rbcL and trnL-trnF. The data were analyzed using a maximum likelihood tree (ML), a haplotype network and two estimators of genetic differentiation (N _ST and G _ST). Nucleotide diversity (π) and haplotype (Hd) were quantified to estimate the percentage of reduction in genetic diversity (%r) as a founder effect. The ML tree and haplotype network indicated the existence of three groups (AI, MI and MII), which was supported by the high values of N _ST (0.61–0.80). Values for %r were high (58.67–60.83 %). Existence of Mesoamerican and Andean gene pools was confirmed, with two genetically and geographically distinct groups (MI and MII) within the MA gene pool. We present the first evidence for multiple origins of domestication for the MA gene pool. For MI, we propose western central Mexico as the domestication area and between Guatemala and Costa Rica for MII. We observed a founder effect in the MA gene pool as a result of domestication.     

Modern forestry vehicles and their impacts on soil physical properties

“Close-to-nature forest stands” are one central key in the project “Future oriented Forest Management” financially supported by the German Ministry for Science and Research (BMBF). The determination of ecological as well as economical consequences of mechanized harvesting procedures during the transformation from pure spruce stands to close-to-nature mixed forest stands is one part of the “Southern Black Forest research cooperation”. Mechanical operations of several typical forest harvesting vehicles were analysed to examine the actual soil stresses and displacements in soil profiles and to reveal the changes in soil physical properties of the forest soils. Soil compaction stresses were determined by Stress State Transducer (SST) and displacement transducer system (DTS) at two depths: 20 and 40 cm. Complete harvesting and trunk logging processes accomplished during brief 9-min operations were observed at time resolutions of 20 readings per second. Maximum vertical stresses for all experiments always exceeded 200 kPa and at soil depths of 20 cm for some vehicles and sequences of harvesting operations approached ≥500 kPa. To evaluate the impacts of soil stresses on soil structure, internal soil strengths were determined by measuring precompression stresses. Precompression stress values of forest soils at the field sites ranged from 20 to 50 kPa at soil depths of 20 cm depth and from 25 to 60 kPa at soil depths of 40 cm, at a pore water pressure of −60 hPa. Data obtained for these measured soil stresses and their natural bearing capacities proved that sustainable wheeling is impossible, irrespective of the vehicle type and the working process. Re-occurring top and subsoil compaction, increases in precompression stress values in the various soil horizons, deep rut depths, vertical and horizontal soil displacements associated with shearing stresses, all affected the mechanical strengths of forest soils. In order to sustain naturally “unwheeled” soil areas with minimal compaction, it is recommended that smaller machines, having less mass, be used to complete forest harvesting in order to prevent or at least to maintain currently minimal-compacted forest soils. Additionally, if larger machines are required, permanent wheel and skid tracks must be established with the goal of their maximum usefulness for future forest operations. A first step towards accomplishing these permanent pathways requires comprehensive planning with the Federal State Baden-Württemberg. The new guideline for final opening with skid tracks (Landesforstverwaltung Baden-Württemberg, 2003) proposes a permanent skid track system with a width of 20–40 m.     

Soil phosphorus fractions after 111 years of animal manure and fertilizer applications

Accumulated soil P in agricultural soils is a major source of soluble and particulate forms of P entering water resources and degrading water quality. However, few research sites are currently available to evaluate the long-term effects of different cropping systems and fertility practices on soil inorganic and organic P accumulation. The objectives of this study were: (1) to compare the forms and quantity of different inorganic and organic soil P fractions in plots on Sanborn Field, which has been cultivated for 111 years; and (2) to assess the use of standard soil test P extractants for determining changes in soil P dynamics over time. A modified sequential P extraction procedure was used to separate labile and stable inorganic and organic P pools from surface soils collected on Sanborn Field in 1915, 1938, 1962, and 1999 from plots in continuous corn, continuous wheat, continuous timothy, and a corn-wheat-clover rotation amended with either manufactured fertilizers, horse or dairy manure or receiving no fertilization since 1888. Additional samples were collected from a native grass prairie site of a similar soil series to estimate soil characteristics at Sanborn Field before initial cultivation in 1888. Observed accumulation of Bray-1 P among fertilizer and manure treatments was attributed to over-application of P due to unrealistically high yield goals for each cropping system. Long-term cultivation of Sanborn Field increased soil bulk density and lowered soil pH and total organic C compared with native prairie. Fertilization either by addition of manufactured fertilizer or manure significantly increased inorganic resin-P and inorganic NaOH-extractable P. Applications of animal manure also significantly increased most organic P fractions compared with the unfertilized treatment. The native prairie had a larger proportion of total P in organic forms compared with cultivated plots, especially in organic NaOH-extractable P, but no significant decreases in either residual or total P were observed due to cultivation. This study confirms that soil P availability in cropping systems that are amended with predominantly organic P amendments may differ from conventional cropping systems relying on manufactured P fertilizers. However, no direct evidence was found to support the hypothesis that any individual inorganic or organic soil P fraction has a better relationship than conventional soil test P extractants with plant P uptake under contrasting organic and conventional fertility practices.     

Lepidium latifolium: plant nutrient competition-soil interactions

Exotic weeds are invading rangelands of the western United States at unprecedented rates. Understanding plant-soil relationships and competitive interactions of invasive weeds is crucial in long-term control strategies. In a greenhouse experiment, we investigated the influence of soil nutrient depletion on plant growth and plant competition between the exotic invasive weeds, Lepidium latifolium (invading wetlands) and Bromus tectorum (invading a multitude of habitats). Plants were grown individually and in combination until L. latifolium flowered, then roots and aboveground mass were harvested. Soil in individual pots was homogenized, subsamples collected for nutrient analyses, and the soil was re-planted to the same species, grown, and harvested twice more for a total of three growth cycles. As nutrient supplying capacity of the soil declined through growth cycles, aboveground mass of L. latifolium decreased significantly (PА.05) and growth potential of B. tectorum surpassed that of L. latifolium. Only bicarbonate-extractable soil ortho-P positively correlated with plant mass of L. latifolium. A separate experiment demonstrated that L. latifolium has a narrow window of soil water potentials for optimal growth; greatest growth at -20 kPa with significantly declining growth at saturation and -400 kPa. Our data suggest that L. latifolium primarily invades wetlands because the high soil water content reduces tortuosity and allows efficient transport of nutrients to this sparsely rooted species. When soil moisture and/or the nutrient supplying capacity of the soil declines, plants with greater root density can out-compete L. latifolium. Monocultural stands of L. latifolium may be self-limiting in time as available nutrients, particularly P, are biocycled to drier upper soil layers.     

Heavy metal, total arsenic, and inorganic arsenic contents of algae food products

The total arsenic, inorganic arsenic, lead, cadmium, and mercury contents of 18 algae food products currently on sale in Spain were determined. The suitability of the analytical methodologies for this type of matrix was confirmed by evaluating their analytical characteristics. The concentration ranges found for each contaminant, expressed in milligrams per kilogram of dry weight, were as follows: total arsenic, 2.3-141; inorganic arsenic, 0.15-88; lead, < 0.05-1.33; cadmium, 0.03-1.9; and mercury, 0.004-0.04. There is currently no legislation in Spain regarding contaminants in algae food products, but some of the samples analyzed revealed Cd and inorganic As levels higher than those permitted by legislation in other countries. Given the high concentrations of inorganic As found in Hizikia fusiforme, a daily consumption of 1.7 g of the product would reach the Provisional Tolerable Weekly Intake recommended by the WHO for an average body weight of 68 kg. A more comprehensive study of the contents and toxicological implications of the inorganic As present in the algae food products currently sold in Spain may be necessary, which might then be the basis for the introduction of specific sales restrictions.