Effects of Coconut Husk and Sphagnum Moss-Based Media on Growth and Yield of Romaine and Buttercrunch Lettuce (Lactuca Sativa) in a Non-Circulating Hydroponics System

A comparison was made to investigate the effects of two potting methods: coconut husk/ sphagnum moss and a plastic forestry tube with a peat-based medium (Sunshine® mix #1, Sungro Horticulture, Agawam, MA, USA), on the growth and yield of Romaine ‘Ridgeline’ and Buttercrunch ‘UH Manoa’ lettuce (Lactuca sativa) using a non-circulating hydroponics system. Two-week old lettuce seedlings were transplanted into 5 cm holes, 20 × 30 cm apart on polystyrene bead boards fitted on top of a 0.6 m wide, 1.2 m long and 25 cm deep hydroponics tanks. A standard hydroponics nutrient solution was prepared using Chem Gro® (Hydro-Gardens, Colorado Springs, CO) (8-15-36 + micronutrients), calcium nitrate [Ca(NO₃)₂] and magnesium sulfate (MgSO₄). Each tank contained either one lettuce variety, replicated 12 times in completely randomized design. Growth and yields significantly increased in both lettuce varieties grown in coconut husk/sphagnum moss plugs which were attributed by their relatively greater water holding capacities and a more favorable media that allowed better root growth.     

Nutrient limitations to bacterial and fungal growth during cellulose decomposition in tropical forest soils

Nutrients constrain the soil carbon cycle in tropical forests, but we lack knowledge on how these constraints vary within the soil microbial community. Here, we used in situ fertilization in a montane tropical forest and in two lowland tropical forests on contrasting soil types to test the principal hypothesis that there are different nutrient constraints to different groups of microorganisms during the decomposition of cellulose. We also tested the hypotheses that decomposers shift from nitrogen to phosphorus constraints from montane to lowland forests, respectively, and are further constrained by potassium and sodium deficiency in the western Amazon. Cellulose and nutrients (nitrogen, phosphorus, potassium, sodium, and combined) were added to soils in situ, and microbial growth on cellulose (phospholipid fatty acids and ergosterol) and respiration were measured. Microbial growth on cellulose after single nutrient additions was highest following nitrogen addition for fungi, suggesting nitrogen as the primary limiting nutrient for cellulose decomposition. This was observed at all sites, with no clear shift in nutrient constraints to decomposition between lowland and montane sites. We also observed positive respiration and fungal growth responses to sodium and potassium addition at one of the lowland sites. However, when phosphorus was added, and especially when added in combination with other nutrients, bacterial growth was highest, suggesting that bacteria out-compete fungi for nitrogen where phosphorus is abundant. In summary, nitrogen constrains fungal growth and cellulose decomposition in both lowland and montane tropical forest soils, but additional nutrients may also be of critical importance in determining the balance between fungal and bacterial decomposition of cellulose.     

Comparison of effects of high-pressure processing and heat treatment on immunoactivity of bovine milk immunoglobulin G in enriched soymilk under equivalent microbial inactivation levels

Immunoglobulin-rich foods may provide health benefits to consumers. To extend the refrigerated shelf life of functional foods enriched with bovine immunoglobulin G (IgG), nonthermal alternatives such as high-pressure processing (HPP) may offer advantages to thermal processing for microbial reduction. To evaluate the effects of HPP on the immunoactivity of bovine IgG, a soymilk product enriched with milk protein concentrates, derived from dairy cows that were hyperimmunized with 26 human pathogens, was subjected to HPP or heat treatment. To achieve a 5 log reduction in inoculated Escherichia coli 8739, the HPP or heat treatment requirements were 345 MPa for 4 min at 30 degrees C or for 20 s at 70 degrees C, respectively. To achieve a 5 log reduction in natural flora in the enriched soymilk, the HPP or heat treatments needed were 552 MPa for 4 min at 30 degrees C or for 120 s at 78.2 degrees C, respectively. At equivalent levels for a 5 log reduction in E. coli, HPP and heat treatment caused 25% and no detectable loss in bovine IgG activity, respectively. However, at equivalent levels for a 5 log reduction in natural flora, HPP and heat resulted in 65 and 85% loss of bovine IgG activity, respectively. Results of combined pressure-thermal kinetic studies of bovine milk IgG activity were provided to determine the optimal process conditions to preserve product function.     

The genetic relationship between popping expansion volume and two yield components in popcorn using unconditional and conditional QTL analysis

Popping expansion volume (PEV) is the most important quality trait in popcorn, while its germplasm is inferior to normal dent/flint corn in yield. In this study, 259 F_2:3 families, developed from the cross between a dent corn inbred Dan232 and a popcorn inbred N04, were evaluated for their PEV, grain weight per plant (GWP) and 100-grain weight (100 GW) in two environments. The genetic relationship between PEV and GWP, and 100 GW on individual gene loci were evaluated using unconditional and conditional QTL mapping methods. In total, five, one and three unconditional QTL were identified for PEV, GWP, and 100 GW, respectively. The positive alleles of all QTL for PEV were from N04, while positive alleles of all QTL for GWP and 100 GW were from Dan232. In conditional mapping, one and two QTL failed to be detected, and all four additional QTL were detected. Nevertheless, three QTL were identified, which controlled PEV independently from GWP/100 GW. They seemed to be potential candidates in popcorn breeding to increase PEV without decreasing GWP/100 GW. The results suggested that for significantly correlated traits, the conditional QTL mapping method could be used to dissect the genetic interrelationship between traits at the level of individual QTL, as well as reveal additional QTL that were undetectable by unconditional mapping.     

Reduced tillage in north-west Europe—A review

The main features of the climate and soils of the main crop production areas of different countries in north-west Europe are outlined, and the main crops grown are summarised. The need for tillage is considered; provided that suitable conditions exist for germination, root growth is most likely to be influenced by mechanical impedance and aeration. Traditional tillage may not always be necessary and may hinder timely sowing of crops. Shallow tillage can facilitate planting a larger area of crops closer to the optimum dates in autumn and in spring, which also saves energy and labour.Research experience with reduced tillage over the last 20–25 years is reviewed. Shallow tillage has been as good as mouldboard ploughing at the traditional depth in most countries on a wide range of soil types, if weed control was satisfactory. Direct drilling has often proved satisfactory in the absence of crop residues for autumn sown crops (wheat, barley, oil-seed rape and beans) where drainage (and therefore soil aeration) was not limiting. Direct drilling has not generally been successful for spring sown crops. Direct drilling is inappropriate for root crops, but strip tillage for sugar beet may become practicable. Some research on soil conditions associated with these experiments is considered.Crop residues are a major constraint to shallow tillage or direct drilling of autumn sown crops. The limitations of reduced tillage due to inadequate weed control, wheel-traffic damage and unsatisfactory drainage are reviewed. The need for occasional deep loosening is also discussed. Where the amount of residues is small, much tillage may be unnecessary, except to relieve compaction by wheels; bed systems or wide-span gantries to avoid wheel damage could become practical developments for some crops.     

Aggregates and gel network structure of globin hydrolysates

A gel with excellent functional properties was prepared successfully using the hydrolysates of globin. In the present study, the structures of intermediate aggregates and gel network were observed directly with an electronic microscope. It was shown clearly that the intermediate aggregates were in a thin rod shape with a length of 130--140 nm, which was in good accordance with the results of the light scattering obtained in a previous study. The diameter of intermediate aggregates was 4--5 nm. Each unit of the intermediate aggregate was composed of beta-chain and peptide beta-1 in a ratio of 1:1. Its molecular weight was 26922 Da, and it had a diameter of 4.1 nm. The thin rod-shaped aggregates were formed with units through the hydrophobic interaction. The length of intermediate aggregate was >30--33 times the diameter. Furthermore, the cross-linked structure formed by peptide alpha-1 and the thin rod-shaped aggregates was also confirmed by the photography of the electronic microscope. These results supported the model proposed in previous papers as proper to depict exactly the formation and structure of the gel network of globin hydrolysates.     

Short term soil priming effects and the mineralisation of biochar following its incorporation to soils of different pH

The aim of this work was to determine the magnitude of the priming effect, i.e. short-term changes in the rate (negative or positive) of mineralisation of native soil organic carbon (C), following addition of biochars. The biochars were made from Miscanthus giganteus, a C4 plant, naturally enriched with ¹³C. The biochars were produced at 350 °C (biochar350) and 700 °C (biochar700) and applied with and without ryegrass as a substrate to a clay-loam soil at pH 3.7 and 7.6. A secondary aim was to determine the effect of ryegrass addition on the mineralisation of the two biochars.After 87 days, biochar350 addition caused priming effects equivalent to 250 and 319 μg CO₂-C g⁻¹ soil, in the low and high pH soil, respectively. The largest priming effects occurred at the start of the incubations. The size of the priming effect was decreased at higher biochar pyrolysis temperatures, which may be a way of controlling priming effects following biochar incorporation to soil, if desired. The priming effect was probably induced by the water soluble components of the biochar. At 87 days of incubation, 0.14% and 0.18% of biochar700 and 0.61% and 0.84% of biochar350 were mineralized in the low and high pH soil, respectively. Ryegrass addition gave an increased biochar350 mineralisation of 33% and 40%, and increased biochar700 at 137% and 70%, in the low and high pH soils, respectively. Certainly, on the basis of our results, if biochar is used to sequester carbon a priming effect may occur, increasing CO₂-C evolved from soil and decreasing soil organic C. However, this will be more than compensated for by the increased soil C caused by biochar incorporation. A similar conclusion holds for accelerated mineralisation of biochar due to incorporation of fresh labile substrates. We consider that our results are the first to unequivocally demonstrate the initiation, progress and termination of a true positive priming effect by biochar on native soil organic C.     

大熊猫主食竹种的研究与进展

回顾了大熊猫主食竹种的研究历史，并着重从主食竹种的分类与分布、生理生化特征、生态生物学特性、营林技术、大熊猫对主食竹种的食用、主食竹种病虫害以及高新技术在竹类研究中的应用等7个方面综述了自20世纪70年代以来的研究成果，最后提出了今后的发展趋势。     

Nonparametric phenotypic stability analysis in advanced barley (<Emphasis Type="Italic">Hordeum vulgare</Emphasis> L.) genotypes

The development of genotypes with adaptation to a wide range of environments is one of the most important goals of plant breeding programs. In order to compare nonparametric stability measures and to identify promising high-yield and stable barley (Hordeum vulgare L.), 20 barley genotypes selected from the Iran/ICARDA joint project and grown in nine environments during 2009-11 in Iran. Four nonparametric statistical tests of significance for genotype × environment (GE) interaction and 10 nonparametric measures of stability were used to identify stable genotypes in nine environments. Results of nonparametric tests of G×E interaction (Kubinger, Hildebrand, and Kroon/ Laan) and a combined ANOVA across environments, indicated the presence of both crossover and non-crossover interactions. Also, only TOP and rank-sum values were positively associated with high yield. Thus, in the simultaneous selection for high yield and stability, only the rank-sum and TOP methods were useful in terms of the principal component analysis results, and correlation analysis of nonparametric stability statistics and yield. According to these stability parameters (TOP and rank-sum), three genotypes (G13, G12, and G17) were the most stable for grain yield. The results also revealed that based on nonparametric test results, stability could be classified into three groups, according to agronomic and biological concepts of stability.