The Public Participation in the Urban Planning

The policy of public participation in urban planning was first practiced in Europe in the 1960s. After 40 years of development, the policy has become the essential step of city planning in Western countries where as is just at the elementary step in China. For the purpose of knowing the situation about the policy performing in local cities and discussing the feasibility of public participation in urban planning, several kinds of investigation have been done. From the investigation, it is found that although the public participation has already been the important step of urban planning in some city during just several years,there are still many problems. This paper shows a panorama view of this issue. Th describe the future of public participation in e authors will offer some solutions according to the problems and the urban planning.     

Voltage Fluctuation and Flicker Mitigation Using STATCOM

Voltage fluctuation and flicker is one of the main causation that imperils reliability of power supply. Steelmaking EAF with large load of distribution network produces large impact and interference on the public electric network in operation. So it is very important to control reactive power for voltage fluctuation and flicker mitigation. STATCOM possessing high response speed is an effective measure to mitigate voltage fluctuation and flicker of distribution network. Here, comparing to static var compensation, many advantages of STATCOM are analyzed. Operation principles COM mitigating voltage fluctuation and flicker, general control strategies and control method are introduced cussed. The researching pivot and trend in the future are also discussed. of STAT- and discussed. The researching pivot and trend in the future are also discussed.     

Detecting System of the Dielectric Loss in Capacitive Equipment Based on Virtual Instruments

A digital detecting system of the dielectric loss in the capacitive equipment is introduced based on virtual instruments.This system can real-time collect,analyze,process and storage electrical signals with National Instruments' program LabVIEW and ADLINK,s DAQ board.Through the simulation test in lab and the real test in electric substation,it is shown that this system has high accuracy on testing the dielectric loss in the capacitive equipment,the real test data is stable and the relative error of real dielectric loss is less than 5%.It is to say that this system can meet the requirement of the real on-line monitoring.     

发动机用平板型空滤器流动阻力特性分析和改进

为减小平板型空滤器流动阻力以增大进气量,对平板型空滤器流动阻力特性开展了实验研究,获得了空滤器流动阻力随流量变化的规律和阻力构成成分。阻力随流量的增大而加速增大,滤芯阻力约占整个空滤器阻力的一半,入口流量为120 m 3/h时,总阻力为915.3 Pa,滤芯阻力为426.4 Pa。在实验获得滤芯阻力参数的基础上,提出采用多孔介质跃升模型对平板型空滤器内部流场开展三维数值仿真分析,结果表明,仿真结果与实验结果比较吻合,最大误差为5.67%。滤芯阻力同样约占整个阻力的一半,另一半阻力主要为出口处阻力,其余壁面阻力约占15%。最后,在实验和仿真分析的基础上,提出了改进模型并进行了仿真分析。结果表明,改进模型阻力有较大程度的下降,入口流量为120 m 3/h时,总阻力为588.2 Pa,较原始模型下降了32.2%;增大空滤器流通横截面积是减小阻力以增大进气量的有效手段,改进空滤器壁面的平滑性是补充措施。     

各向异性砂土剪切带角度的理论分析

针对平面应变条件下各向异性砂土剪切带角度的试验规律,采用传统的3种理论和分叉理论进行对比分析。将平面应变条件下剪切带角度的试验结果按照传统3种理论整理发现,尽管传统3种理论可以估算同种砂剪切带角度的极小、中间和极大值,但无法解释其各向异性规律。砂土在平面应变条件下破坏时会产生明显的剪切带,当剪切带方向和砂土沉积面方向接近时,会较早诱发剪切带的产生,使材料强度降低,造成了平面应变条件下各向异性强度规律明显不同于常规三轴条件下的试验规律,采用分叉理论结合各向异性模型则可以有效解释这个规律。随砂土沉积面角度的变化,模型可以从细观角度解释常规三轴条件下剪切带角度的单调变化的试验规律,结合分叉理论可以描述平面应变条件下其先减小然后增大的规律。通过几种理论对比分析表明,模型结合分叉理论不但能够描述多种应力状态下的平面应变和常规三轴应力条件下剪切带角度表现的不同规律,而且能够从细观角度解释其各向异性成因。     

The Monitoring Measurements and Country Rock Control of NATM in Tunnel of Express Road during Construction

In this paper the author' s study on the monitoring measurement technique of NATM,the regularity and conditions of the country rock deformation are analysed based on the site measurement data in the west section of Zhongliangshan tunnel. The regression analysis of measure data for different measure lines of vavious country rock is done by the use of self-compiled CRAP program. The stability criterion for various rockmass and optimum time for primary and permanent support are provided. The conclusion available could conduct the theoretical research of NATM deeply as well as tunnel design and construction.     

A NEW APPROACH OF OPTIMIZATION

In this paper, a necessary optimality condition of problems with equality constraints is investigated by the implicit function theorem in n-dimensional Euclidean space. A new approach solving these problems is obtained. The number of dimensions of corresponding system of equations is less than the classic Lagrangian multiplier method.