Estimating reference evapotranspiration with atmometers in a semiarid environment

Reference evapotranspiration (ET₀) estimations require accurate measurements of meteorological variables (solar radiation, air temperature, wind speed, and relative humidity) which are not available in many countries of the world. Alternative approaches are the use of Class A pan evaporimeters and atmometers, which have several advantages compared to meteorological stations: they are simple, inexpensive and provide a visual interpretation of ET₀. The objectives of the study were to compare the evaporation from atmometers (ET_gage) with the evapotranspiration estimated by the FAO-56 Penman-Monteith equation (ET_0PM) and to evaluate the variability between three modified atmometers of a commercial model. Comparison between daily ET_gage measured by the atmometer and ET_0PM showed a good correlation. However, ET_gage underestimated ET_0PM by approximately 9%. Differences between ET_gage and ET_0PM ranged from −2.4 to 2.2 mm d⁻¹ while the mean bias error was −0.41 mm d⁻¹. Underestimations occurred more frequently on days with low maximum temperatures and high wind speeds. On the contrary, atmometer overestimations occurred on days with high maximum temperatures and low wind speeds. Estimates of ET₀ using the atmometer appeared to be more accurate under non-windy conditions and moderate temperatures as well as under windy conditions and high temperatures. Atmometers 2 and 3 overestimated the evaporated water by atmometer 1 with a maximum variability of cumulative water losses of 4.5%. A temperature-based calibration was performed to improve the atmometer accuracy, using maximum temperature as an independent variable, with good results.     

Prediction of irrigation return flows through a hierarchical modeling approach

The quantity of water available for irrigation is getting scarce in many countries and it assumes great importance for assured crop production, especially in view of the erratic behavior of the monsoon. Thus, there is a pressing need to improve the water efficiency of irrigation systems. One-way of improving the efficiency of the irrigation system is reusing the return flow from the irrigation system. This task requires quantification of return flow, which still remains as a grey area in irrigation water management. The estimation of return flow from the irrigation system is usually obtained using thumb rules depending upon the site-specific conditions like command area conditions and soil properties. In this paper, a hierarchical modeling technique, namely, regression tree is developed for return flow estimation. Regression tree is built through binary recursive partitioning. The effective rainfall, inflow, consumptive water demand, and percolation loss are taken as predictor variables and return flow is treated as the target variable. The applicability of the hierarchical model is demonstrated through a case study of Periyar-Vaigai Irrigation System in Tamil Nadu, India. The model performance shows a good match between the simulated and the field measured return flow values. Results of statistical analysis indicated that the correlation coefficients are high for both single as well as double crop seasons.     

Subsurface drip irrigation of corn in the United States Mid-South

Although rainfall in the United States Mid-South is sufficient to produce corn (Zea mays L.) without irrigation in most years, timely irrigation has been shown to increase yields. The recent interest in ethanol fuels is expected to lead to increases in US corn production, and subsurface drip irrigation (SDI) is one possible way to increase application efficiency and thereby reduce water use. The objective of this study was to determine the response of SDI-irrigated corn produced in the US Mid-South. Field studies were conducted at the University of Arkansas Northeast Research and Extension Center at Keiser during the 2002-2004 growing seasons. The soil was mixed, with areas of fine sandy loam, loamy sand, and silty clay. SDI tubing was placed under every row at a depth of approximately 30 cm. Three irrigation levels were compared, with irrigation replacing 100% and 60% of estimated daily water use and no irrigations. The split plot treatment was hybrid, with three hybrids of different relative maturities. Although the 3-year means indicated significantly lower yields for a nonirrigated treatment, no significant differences were observed among the treatments in 2003 or 2004. A large difference was observed in 2002, the year with the least rainfall during the study period, but no difference was detected between the two irrigated treatments in any year. The treatment with the lower water application had the higher irrigation water use efficiency. Although the results of this study suggested that replacing 60% of the estimated daily evapotranspiration with SDI is sufficient for maximum corn yields, additional observations will be needed to determine whether corn production with SDI is feasible in the region and to develop recommendations for farmers choosing to adopt the method. Improved weather forecasting and crop coefficient functions developed specifically for the region should also contribute to more efficient irrigation management.     

Water production functions of wheat (Triticum aestivum L.) irrigated with saline and alkali waters using double-line source sprinkler system

Expected yield losses as a function of quality and quantity of water applied for irrigation are required to formulate guidelines for the effective utilisation of marginal quality waters. In an experiment conducted during 2004-2006, double-line source sprinklers were used to determine the separate and interactive effects of saline and alkali irrigation waters on wheat (Triticum aestivum L.). The study included three water qualities: groundwater (GW; electrical conductivity of water, ECw 3.5 dS m⁻¹; sodium adsorption ratio, SAR 9.8 mmol L⁻¹; residual sodium carbonate, RSC, nil) available at the site, and two synthesized waters, saline (SW; ECw 9.4 dS m⁻¹, SAR 10.3 mmol L⁻¹; RSC nil) and alkali (AW; ECw 3.7 dS m⁻¹, SAR 15.1 mmol L⁻¹; RSC 9.6 meq. L⁻¹). The depths of applied SW, AW, and GW per irrigation ranged from 0.7 to 3.5 cm; the depths of applied mixtures of GW with either SW (MSW) or AW (MAW) ranged from 3.2 to 5 cm. Thereby, the water applied for post-plant irrigations using either of GW, SW or AW ranged between 15.2 and 34.6 cm and 17.1 and 48.1 cm during 2004-2005 and 2005-2006, respectively and the range was 32.1-37.0 and 53.1-60.0 cm for MSW or MAW. Grain yields, when averaged for two years, ranged between 3.08 and 4.36 Mg ha⁻¹, 2.57 and 3.70 Mg ha⁻¹ and 2.73 and 3.74 Mg ha⁻¹ with various quantities of water applied using GW, SW and AW, respectively, and between 3.47 and 3.75 Mg ha⁻¹ and 3.63 and 3.77 Mg ha⁻¹ for MSW and MAW, respectively. The water production functions developed for the two sets of water quality treatments could be represented as: RY = 0.528 + 0.843(WA/OPE) − 0.359(WA/OPE)² − 0.027ECw + 0.44 × 10⁻²(WA/OPE) × ECw for SW (R² = 0.63); RY = 0.446 + 0.816(OPE/WA) − 0.326(WA/OPE)² − 0.0124RSC − 0.55 × 10⁻⁴(WA/OPE) × RSC for AW (R² = 0.56). Here, RY, WA and OPE are the relative yields in reference to the maximum yield obtained with GW, water applied for pre- and post-plant irrigations (cm), and open pan evaporation, respectively. Crop yield increased with increasing amount of applied water for all of the irrigation waters but the maximum yields as obtained with GW, could not be attained even with increased quantities of SW and AW. Increased frequency of irrigation with sprinklers reduced the rate of yield decline with increasing salinity in irrigation water. The sodium contents of plants increased with salinity/alkalinity of sprinkled waters as also with their quantities. Simultaneous decrease in potassium contents resulted in remarkable increase in Na:K ratio.     

Irrigation scheduling strategies for cotton to cope with water scarcity in the Fergana Valley, Central Asia

The Central Asian countries face high water scarcity due to aridity and desertification but excess water is often applied to the main irrigated crops. This over-irrigation contributes to aggravate water scarcity problems. Improved water saving irrigation is therefore required, mainly through appropriate irrigation scheduling. To provide for it, after being previously calibrated and validated for cotton in the Fergana region, the irrigation scheduling simulation model ISAREG was explored to simulate improved irrigation scheduling alternatives. Results show that using the present irrigation scheduling a large part of the applied water, averaging 20%, percolates out of the root zone. Several irrigation strategies were analyzed, including full irrigation and various levels of deficit irrigation. The analysis focused a three-year period when experiments for calibration and validation of the model were carried out, and a longer period of 33 years that provided for an analysis considering the probabilities of the demand for irrigation water. The first concerned a wet period while the second includes a variety of climatic demand conditions that provided for analyzing alternative schedules for average, high and very high climatic demand. Results have shown the importance of the groundwater contribution, mainly when deficit irrigation is applied. Analyzing several deficit irrigation strategies through the respective potential water saving, relative yield losses, water productivity and economic water productivity, it could be concluded that relative mild deficits may be adopted. Contrarily, the adoption of high water deficit that produce high water savings would lead to yield losses that may be economically not acceptable.     

牧场土壤含水率与坚实度空间变异与相关性分

利用土壤水分/圆锥指数复合测量装置,应用精细农作技术体系网格定点测量与GPS定位,在一块面积约1.27 hm2的草地上获取了土壤含水率与坚实度空间分布基础数据,并针对采样过程中出现的数据缺失,用偏最小二乘法对数据进行修补.然后运用克里格插值法进行数字化成图,并在此基础上分别对含水率与坚实度的空间变异性及两者的相关性做了分析.     

Predicting the age of fish using general and generalized linear models of biometric data: A case study of two estuarine finfish from New South Wales, Australia

Direct ageing of fish can be a laborious and expensive task when age estimates from a large population are required, and often involves a degree of subjectivity. This study examined the application of general and generalized linear models that predict the age of fish from a range of efficiently and objectively measured covariates. The data sampled were from yellowfin bream (Acanthopagrus australis (Sparidae) (Owen, 1853)) and sand whiting (Sillago ciliata (Sillaginidae) Cuvier, 1829) populations from New South Wales, Australia. The covariates evaluated in the models were fish length, otolith weight, sex and location (the estuary from which the fish were sampled). Akaike Information Criteria were used for model selection and residual plots of the final models revealed a satisfactory fit to the observations. The best fitting model for each species included all covariates. An additional investigation considered whether general and generalized linear models that predict age from two different categories of biometric information outperform age-length keys with respect to subsequent estimates of total mortality from catch-curve analysis. The two categories of biometric information differed in the ease and cost with which the information could be collected. The first category only included fish length and location as covariates, whilst the second category also included otolith weight and sex. It was found that traditional age-length keys outperformed the predictive models that estimated age from only fish length and location, because the results from the models were prone to significant bias. However, when otolith weight and sex were added as covariates to the predictive models, some of them, including a generalized linear model with a Poisson-distributed response variable, performed similarly to the age-length key. Given that otolith weight and the sex of fish are cheaper to quantify than age from a sectioned otolith in many situations, general or generalized linear models may represent a cheaper and faster method of estimating mortality compared to age-length keys. Such models can also easily incorporate the influence of spatial, temporal and demographic variation.     

Dietary Lipid Utilization by White Sea Bream (Diplodus sargus) Juveniles

Abstract.— A 8-wk trial was performed with white sea bream, Diplodus sargus , juveniles (17.3 g initial weight) to evaluate the effect of dietary lipid levels on growth performance and whole-body composition. Six experimental diets were formulated to be isoproteic (45% protein) and to contain from 9 to 24% dietary lipid levels (dry matter basis). Fish meal and fish oil were used as the main protein and lipid sources, respectively. At the end of the trial, there were no significant differences ( P  > 0.05) among groups in fish performance or in whole-body composition. From the results of this trial, it is concluded that, within the range of values tested, increasing dietary lipid levels above 9% has no advantage as it does not promote growth or spare protein for growth purposes.     

Variation in growth and aggression of juvenile brown trout (Salmo trutta) from upstream and downstream reaches of the same river

Abstract –  To investigate differences in behaviour and growth between juvenile brown trout from spatially separated reaches, fish were collected from above and below a weir in Silverstream, New Zealand. Population level differences in mass-specific growth rates and aggression level were examined in tank experiments. Monitoring of mass-specific growth rates found that relative growth rates between fish of different sizes varied between fish from the upstream reach but not between fish from the downstream reach. Large individuals grew faster than smaller individuals from the upstream reach but no effect of relative fish size on growth was found among fish from the downstream population, indicating that social organisation in the two populations differed. When tested in pairs, juvenile brown trout from the downstream population were found to be more aggressive than those from the upstream population. Differences in the allometric relationship between growth rate and fish size and in the levels of aggressiveness appear to be related to the failure to form dominance hierarchies among fish from the downstream reach, a fixed behavioural trait most likely related to prior experience of crowding or different genetic backgrounds.