Effects of Zeolite on Soil Nutrients and Growth of Barley Following Irrigation with Saline Water

ABSTRACT

Soil salinity is a major abiotic factor limiting crop production but an amendment with synthetic zeolite may mitigate effects of salinity stress on plants. The objective of the study was to determine the effects of zeolite on soil properties and growth of barley irrigated with diluted seawater. Barley was raised on a sand dune soil treated with calcium type zeolite at the rate of 1 and 5% and irrigated every alternate day with seawater diluted to electrical conductivity (EC) levels of 3 and 16 dS m^?1. Irrigation with 16 dS m^?1 saline water significantly suppressed plant height by 25%, leaf area by 44% and dry weight by 60%. However, a substantial increase in plant biomass of salt stressed barley was observed in zeolite-amended treatments. The application of zeolite also enhanced water and salt holding capacity of soil. Post-harvest soil analysis showed high concentrations of calcium (Ca^{2 +}), magnesium (Mg^{2 +}), sodium (Na⁺), and potassium (K⁺) due to saline water especially in the upper soil layer but concentrations were lower in soils treated with zeolite. Zeolite application at 5% increased Ca^{2 +} concentration in salt stressed plants; concentrations of trace elements were also increased by 19% for iron (Fe^{2 +}) and 10% for manganese (Mn^{2 +}). The overall results indicated that soil amendment with zeolite could effectively ameliorate salinity stress and improve nutrient balance in a sandy soil.     

ROOT ZONE TEMPERATURE INFLUENCES ZINC REQUIREMENT OF MAIZE CULTIVARS ON A CALCAREOUS LOAM SOIL

The zinc (Zn) requirement of a maize (Zea mays L.) hybrid (‘FHY-396’) and an indigenous variety (‘EV-7004’) was measured at low (22.4 ± 5°C) and high (28.8 ± 5°C) root-zone temperatures (RZT). Four Zn rates (0, 3, 9 and 27 mg kg^?1 soil) were applied to a calcareous loam soil in pots for the glasshouse study. Shoot and root dry matter yields were significantly more at the higher RZT. Regardless the RZT, maximum relative shoot dry matter yield in hybrid and variety was produced, respectively, at 9 and 3 mg Zn kg^?1 soil. Zinc concentration in roots and shoots of both the cultivars increased with Zn rates and it was significantly more at the higher RZT. Cultivars differed in critical Zn concentration (C_ZnC) required for maximum shoot dry matter yield. The C_ZnC ranged from 25 to 39 μg Zn g^?1 plant tissue for optimum growth of both the cultivars at low and high RZT.     

Evaluation of cell wall preparations for proteomics: a new procedure for purifying cell walls from Arabidopsis hypocotyls

Background  

The ultimate goal of proteomic analysis of a cell compartment should be the exhaustive identification of resident proteins; excluding proteins from other cell compartments. Reaching such a goal closely depends on the reliability of the isolation procedure for the cell compartment of interest. Plant cell walls possess specific difficulties: (i) the lack of a surrounding membrane may result in the loss of cell wall proteins (CWP) during the isolation procedure, (ii) polysaccharide networks of cellulose, hemicelluloses and pectins form potential traps for contaminants such as intracellular proteins. Several reported procedures to isolate cell walls for proteomic analyses led to the isolation of a high proportion (more than 50%) of predicted intracellular proteins. Since isolated cell walls should hold secreted proteins, one can imagine alternative procedures to prepare cell walls containing a lower proportion of contaminant proteins.     

Kinetic and Equilibrium Modeling for Cr(III) and Cr(VI) Removal from Aqueous Solutions by Citrus reticulata Waste Biomass

The pulp left after the extraction of juice from Citrus reticulate (kinnow), is a waste material, which was used as a potential sorbent for Cr(III) and Cr(VI) in the present study. The effect of experimental parameters such as pH, biosorbent dosage, biosorbent particle size, initial metal concentrations, temperature, shaking speed and sorption time on the Cr removal is apparent from the obtained results. The Freundlich isotherm and pseudo second order kinetic models fitted well to the data of Cr(III) and Cr(VI) biosorption by Citrus reticulata waste biomass. Effect of several pretreatments such as gases, natural coagulant and many other chemicals on Cr(III) and Cr(VI) sorption capacity of Citrus reticulata waste biomass was first time analyzed in the present study. The metal sorption capacity of Citrus reticulata waste biomass after a specific pretreatment was not only related to the nature of chemical but also strongly dependent on the oxidation state of the metal.     

辣椒热泵干燥特性及工艺参数优化

为了提高干制辣椒品质,降低干燥能耗,该文应用热泵干燥技术干燥辣椒。首先探究干燥温度和铺料厚度对干燥特性的影响,绘制出含水率和干燥速率变化曲线。在此基础上,将分阶段控温和改变铺料厚度结合起来对辣椒进行热泵干燥,运用响应面法中的Box-Behnken设计,考察第一阶段温度、第二阶段温度、铺料厚度和三者的交互作用对品质得分、单位能耗、干燥时间的影响,并建立回归方程,得出最佳工艺参数。结论如下:温度越高,干燥速率越大,含水率下降越快;铺料厚度越大,干燥速率越小,含水率下降越慢;第一阶段温度是影响单位能耗的主要因素(P0.05),较低的第一阶段温度能降低单位能耗;第二阶段温度对品质得分影响显著(P0.05),对干燥时间影响极显著(P0.01),第二阶段温度在60℃左右时能得到品质较佳的干辣椒,且在一定程度上提高了干燥效率;铺料厚度对品质得分、干燥时间的影响极显著(P0.01),对单位能耗的影响显著(P0.05),铺料厚度在45 mm左右干燥获得的辣椒品质较佳,而且能节约能耗,提高干燥效率。综合优化参数为:第一阶段温度48℃、第二阶段温度61℃、铺料厚度44 mm,在此工艺条件下获得的干燥辣椒品质得分为8.64,单位能耗为92.05 k J/kg,干燥时间为896.02 min。研究结果为热泵干燥技术应用于辣椒干制提供参考。     

Boron fertilization improves seed yield and harvest index of Camelina sativa L. by affecting source-sink

The impact of soil (1, 2 kg ha^?1) and foliar (100, 200 mg L^?1) boron (B) with control (no B) was evaluated on phenology and yield formation of Camelina each applied at stem elongation and flowering stages. Foliar (200 mg L^?1) or soil B (2 kg ha^?1) resulted in earlier flowering and maturity, increased fruit bearing branches (19.68%), number of siliqua, seeds per siliqua (4.6%), biological yield (15%), seed yield (24%), harvest index (11.4%) and oil contents (23%) than no B. Increased fruit bearing branches, seed filled siliqua or seed numbers, harvest index and oil quality can be attributed to changes in dry matter accumulated of stem with simultaneous increase in siliqua dry weight with foliar or soil applied B. In crux, foliar (200 mg L^?1) or soil applied (2 kg ha^?1) B seems promising to improve seed and oil yield, harvest index of Camelina sativa under B deficient condition.     

Perspectives of folate biofortification of cereal grains

One sixth of the world’s population is suffering from hidden hunger that indicates a gross malnutrition particularly among children and women of third world countries. The deficiency of micro nutrients, especially iron (Fe) causes a number of ailments such as megaloblastic anemia and neural tube defects in poor population. There is a dire need to supplement iron in the diet. Current efforts implicate fortification of wheat flour and other grains with different iron formulations such as ethylenediaminetetraacetic acid (EDTA), FeSO₄ and elemental iron. However, all such interventions are not sustainable due to logistic and quality assurance problems in resource-limited settings. For a long term solution, development of crop plants with increased micronutrients and iron bioavailability is essential. Therefore, biofortification of cereal grains using translational genomics approaches for enhancement of folate through genome editing in cereals is inevitable to mitigate the folate deficiency in poor remote population in a cost effective manner.     

Wheat Seed Presoaking for Improved Germination

Seed presoaking improves wheat germination under marginal moisture conditions. The duration of seed presoaking was studied at The University of Arid Agriculture, Rawalpindi, using 10 wheat varieties. Seed presoaking beyond 12 h does not improve germination further, and beyond 21 h, germination rate is drastically reduced.