盐水鹅辐照保质试验研究

鹅是食草家禽,鹅肉属现代健康食品。盐水鹅在20℃的贮存条件下仅36h就会出现异味变质。介绍了通过用不同包装材料、不同辐照剂量保质处理以及对盐水鹅氨基酸影响的研究,探讨了盐水鹅辐照保质的方法,为延长盐水鹅货架期提供新途径。     

玉米o2、o16和wx基因不同组合类型近等基因系品质分析

为评价o2、o16和wx基因不同组合类型近等基因系的品质,以玉米o2、o16和wx基因不同组合类型近等基因系BC 6 F 4家系及其轮回亲本为试材,利用近红外分析仪和氨基酸全自动分析仪对籽粒油分、淀粉、蛋白质和氨基酸含量进行分析。结果表明,与轮回亲本CML 539相比,o2o16wx-NIL、o2o16-NIL、o2wx-NIL和o2-NIL籽粒油分含量分别提高了11.37%、8.86%、17.53%和11.95%。o2wx-NIL和o2-NIL籽粒淀粉含量分别降低了0.71%和1.00%。o16wx-NIL和wx-NIL蛋白质含量分别提高了9.91%和10.22%,o2wx-NIL、o16wx-NIL和o16-NIL蛋白质含量分别降低了6.03%、6.05%和5.87%。o2o16wx-NIL,o2o16-NIL,o2wx-NIL,o16wx-NIL,o2-NIL、wx-NIL和o16-NIL氨基酸含量均发生不同程度变化,其中,Lys分别增加了111.22%、109.53%、91.22%、34.40%、79.93%、29.69%和70.11%。可见,o2、o16和wx基因不同组合类型近等基因系是品质基因遗传研究和育种应用的重要材料。     

烤烟EMS诱变后代高香气突变体筛选

为筛选高香气且品质较优的烤烟后代,以中烟100为材料,采用EMS诱变技术对中烟100种子进行处理,筛选出2个叶面腺毛密度大的突变体材料,通过田间试验,对其叶面腺毛密度、叶面化学成分、烤后化学成分、香气物质含量和感官质量评吸等指标进行评估,并与正常中烟100后代和NC89进行对照。研究结果表明,EMS-2诱变株系腺毛密度最大,为65.55个/mm ²,分别是中烟100（37.19个/mm ²）和NC89（56.06个/mm ²）的1.8和1.2倍;叶面化学成分分析结果表明,EMS-1诱变株系西柏烷类和烷烃类含量最多,分别为57.18、5.16mg/m ²,EMS-2突变株系蔗糖酯类物质分泌较旺盛,含量最多,为0.33mg/m ²;烤后样化学成分分析结果表明,EMS-2突变株系化学成分含量较协调,且香气成分含量最多,达到890.32μg/g,分别比中烟100和NC89增加34.5%和29.0%;结合对诱变后代的感官评价,得出结论：诱变株系综合品质较好,可提高烟叶质量,EMS-2综合品质最好,可以作为待选株系进行下一步品种选育。     

青贮玉米品质性状遗传变异及主成分分析

为了鉴定青贮玉米品质性状间的相关和依附关系,对14份青贮玉米材料的22个品质性状检测分析,并进行一般描述统计、遗传变异、相关性及主成分分析。结果表明,参试青贮玉米各品质性状中,脂肪、钾、木质素、淀粉含量的变异系数较大,分别为0.20、0.19、0.17和0.16,表明这些性状在品种遗传选育进程中有较大的改良空间;消化率及能量品质相关性状的变异系数介于0.03~0.08,表明这部分性状难以得到遗传改良;青贮玉米品质性状间相关性较大,适宜采用主成分分析保留品质性状的最重要方面。对测试的22个品质性状进行主成分提取,前3个主成分的累积贡献率达到91.29%,分别代表了青贮玉米的饲用价值、微量元素及粗蛋白成分。     

A data transfer method for improving seed identification of maize (Zea mays) haploid breeding based on genetic similarity

Maize haploid breeding technology is able to identify haploid seeds non‐destructively, rapidly and at low cost with the help of Near‐infrared (NIR) spectral analysis. However, due to the hybridization of numerous parents and the low production rate of haploid, the haploid data collection becomes a burden for engineering this technology. Biologically, there are considerable similarities between the progeny of the same female parent and different male parents. Based on this advantage, similar spectral data can be transferred when the NIR technology is employed. A revised method of Transfer adaptive boost (TrAdaBoost) is proposed to improve identifying for the backpropagation neural network (BPNN) classifier. To avoid the negative transfer, a screening thresh is used to select out similar data, and the amount of these data are limited to join current training. The results show that the identification performances are improved significantly when the data amount is small. This method shows a high ability to make the seed identification more convenient for engineering maize haploid breeding.     

促芽肥与杂交中稻再生力关系及其作用机理

１９９１－１９９３年以２个杂交中稻品种为材料，研究了促芽肥与杂交中稻再生力关系及其作用机理。结果表明，促芽肥不能提高到２、倒３节位活芽率，可提高倒４、５位活芽率。促芽肥对再生力的效果与母茎 鞘干物质重有关，当母茎鞘干物质过大或过小时，促芽肥的作用极小。     

硼对小麦生殖器官形态及解剖结构的影响

用溶液培养方法研究硼对小麦生殖器官形态及解剖结构的影响. 结果表明: (1)缺硼严重影响小麦穗的分化, 在一定施硼范围内, 总小穗数和有效小穗数随硼施用量增加而增多; (2)缺硼严重影响小麦雄蕊发育. 无硼(B0处理)条件下, 少数雄蕊不发育, 多数虽发育, 但体积极小, 造孢细胞有丝分裂阶段出现异常, 细胞内有多核现象, 减数分裂     

矮败小麦群体改良的方法与技术

矮败小麦是具有矮秆基因标记的太谷核不育小麦. 根据轮回选择的基本原理和方法, 结合矮败小麦的特点, 我们逐步建立起一套简单易行的群体改良方法. 其主体技术包括组建一个好的基础群体, 利用控制授粉向群体引进优良基因, 通过开花前不良可育株的淘汰提高优良基因的频率, 借助于可育株与不育株的异交使基因重组, 以及正确地选     

Performance of Drainage Reuse as Waterscape Treated by Combinational Technique of Biologic Contact Oxidation and Constructed Wetland

The high grade gray water was pre treated by biologic contact oxidation on load of 0.72 KgBOD5·m-3·d-1, and then post treated by constructed wetland. On the basis of experiment, it was found that: Totle nitrogen (TN) was the restrictive index of the combinational technique. To meet the reclaimed water quality standard and reuse for waterscape, the peak hydraulic load of constructed wetland was 0.50 m·d-1 in summer (30~36 ℃), and 0.33 m·d-1 in winter (8~12 ℃). And the load ratio of the peak hydraulic under the summer and winter conditions was 3:2. With the experimental results and reclaimed water quantity requirements in different seasons of buildings, treatment scale can be determined.     

Application of Fractals in Architectural Shape Design

A computer aided method for architectural shape design was developed based on the L systems algorithm, the shape grammar and the space surface equation theory. Various 3D entities such as building grounds, building walls and building domes with fractal characteristics could be generated in a short time by using the computer program. These generative 3D entities were saved in a component database which could help to accumulate design knowledge through continuous expansion. A building could successfully be formed by the designers through selecting proper building grounds, walls and domes from this database. The effectiveness of the proposed method was approved with a case study.