防御酶活性、木质素和总酚含量与 辣椒抗黄瓜花叶病毒的关系

（1中国农业大学农学与生物技术学院蔬菜系，北京 100094； 2山东省烟台农业学校，烟台 264002）     

Using midday stem water potential for scheduling deficit irrigation in mid–late maturing peach trees under Mediterranean conditions

Irrigation techniques that reduce water applications are increasingly applied in areas with scarce water resources. In this study, the effect of two regulated deficit irrigation (RDI) strategies on peach [Prunus persica (L.) Batsch cv. “Catherine”] performance was studied over three growing seasons. The experimental site was located in Murcia (SE Spain), a Mediterranean region. Two RDI strategies (restricting water applications at stage II of fruit development and postharvest) based on stem water potential (Ψ_s) thresholds (?1.5 and ?1.8 MPa during fruit growth and ?1.5 and ?2.0 MPa during postharvest) were compared to a fully irrigated control. Soil water content (θ_v), Ψ_s, gas exchange parameters, vegetative growth, crop load, yield and fruit quality were determined. RDI treatments showed significantly lower values of θ_v and Ψ_s than control trees when irrigation water was restricted, causing reductions in stomatal conductance and photosynthesis rates. Vegetative growth was reduced by RDI, as lower shoot lengths and pruning weights were observed under those treatments when compared to control. However, fruit size and yield were unaffected, and fruit quality was slightly improved by RDI. Water savings from 43 to 65 % were achieved depending on the year and the RDI strategy, and no negative carryover effect was detected during the study period. In conclusion, RDI strategies using Ψ_s thresholds for scheduling irrigation in mid–late maturing peach trees under Mediterranean conditions are viable options to save water without compromising yield and even improving fruit quality.     

Effect of irrigation on tillering in wheat,triticale and barley in a water-limited environment

Summary The effect of irrigation on tillering and tiller mortality in varieties of wheat (Triticum aestivum and T. durum), triticale and barley was studied under field conditions. Low temperature in the early stages of growth promoted production of tillers whereas increase in temperature during extension growth phase increased tiller mortality. More than 1000 tillers m^–2 were produced with five irrigations but 40% or more died. With limited water availability tiller production was reduced but so was their mortality. Grain yield in wheat and triticale was positively correlated with productive tillers and negatively correlated with the maximum number of tillers produced in wheat and barley grown under limited irrigation conditions. Varieties with a capacity to produce fewer tillers were identified. Some of them proved more stable in yield. No correlation was found between tiller number and grain yield in the frequently irrigated treatment.     

Dimensional analysis in surface irrigation

The surface-irrigation design process requires multiple analyses of surface irrigations to test tentative values of design parameters in the search for an optimum. Preparation of general design charts can aid the design process if the users' test cases fall within the scope of the charts. The large number of independent variables in surface irrigation preclude the generation of charts covering the practical range of all independent variables, when these are in dimensioned form. Dimensionless formulations allow significant reductions in the amount of data generated and presented, without loss of generality. Relationships pertinent to surface-irrigation analyses and design are reviewed in dimensionless terms. Dimensionless forms are developed primarily from an examination of the equations governing surface-irrigation phenomena. Additionally, dimensionless forms are derived from a study of the dimensions of the pertinent variables, without recourse to the governing equations. The Buckingham Pi Theorem is derived in the context of surface irrigation. Different choices for reference variables, leading to different meanings for the resulting dimensionless parameters, have advantages and disadvantages for analysis and design of surface irrigation systems. The different systems developed in the past for border irrigation are reviewed and their consequences noted; new systems with potential for future studies are suggested. Particular attention is devoted to those dimensionless representations useful in design.     

Design and evaluation of an irrigation system for creating water gradients under an automatic rain shelter

Summary This paper reports on the design and performance of an irrigation system associated with a rain shelter. The shelter is used in the closed position as a platform for multiple spray lines. This system automatically supplies, at a specified time, water of specified depth and delivery rate, either uniformly or on a specified gradient across the sheltered area. Variations in crop water deficits and yields have conformed closely to imposed water gradients.     

Determination of soil water content by X-ray computed tomography and magnetic resonance imaging

Summary Experiments were conducted to compare the use of X-ray computed tomography (CT) and magnetic resonance imaging (MRI) methods for determining water content in soil. Soil cores of Mexico silt loam packed at bulk densities of 1.2, 1.3, 1.4, and 1.5 Mg/m³ and Crider silty clay packed at bulk densities of 1.3, 1.4, 1.5, and 1.6 Mg/m³ were evaluated using a CT scanner. Results indicate that the X-ray CT explained 98% of the variation in water content over a range from air-dry to saturation. Three attempts were made to obtain MRI scans of soil cores varying in soil water content. Two of these attempts were made with contrasting agents. No images were obtained of the soil cores during all three attempts. It is suggested that the failure to obtain images of soil cores is closely related to the settings of the pulse repetition time and the spin echo time on the MRI unit. The range in settings for these two parameters on the commercial MRI unit used in this study did not allow short increments to be selected and therefore it was not possible to obtain reconstructed images of the soil cores for this experiment. However accessibility to a prototype MRI unit should allow more conclusive work to determine the full capabilities of MRI for determining soil water content.Contribution from the Missouri Agricultural Experiment Station Journal No. 10424, Department of Agronomy, University of Missouri, Columbia, MO 65211, USA     

Irrigation scheduling in a mature peach orchard using tensiometers and dendrometers

Three trickle irrigation schedules, two of which were scheduled according to soil water potential ( soil) (tensiometer method) and daily stem contraction (DSC) (dendrometer method) respectively and the other one was a schedule of restricted water supply, were applied to a mature peach orchard.The annual water application based on soil was greater than that based on DSC. However, tree growth, fruit size and leaf water potential (leaf) on the trees in the dendrometer scheduling plot did not differ from those in the tensiometer scheduling plot while the premature fruit drop and fruit bud initiation were greatly different. The restricted water supply treatment limited significantly both tree and fruit growth. In addition, the lower leaf was observed on the trees in this plot.Further study shows that use of the dendrometer method for scheduling irrigation satisfies the water needs of the plant and that the tensiometer method is less accurate.Abbreviations leaf leaf water potential - soil soil water potential - DSC daily stem contraction - LVDT linear variable displacement transducer - PET potential evapotranspiration     

Soil water potential measurement: An overview

Summary Soil water potential is measured either by measuring some property of the soil which changes with the water potential, or by equilibrating the liquid or gas phase of the water in some reference medium with the liquid phase of the soil and measuring some property of the water in the reference medium. Devices commonly used to measure soil water potential are tensiometers, thermocouple psychrometers, electrical resistance sensors, thermal conductivity sensors, and correlations with water contents of the soil or of filter paper which has been equilibrated with the soil. The principles governing the operation of each of these devices will be discussed.     

Measuring yield-reducing plant water potential depressions in wheat by infrared thermometry

Summary Measurements of foliage and air wet- and dry-bulb temperatures were made over six differentially irrigated plots of Produra wheat grown at Phoenix, Arizona, in the spring of 1976. These data were used to evaluate a newly developed plant water stress index each day from the initiation of heading to the commencement of senescence. Daily measurements on total plant water potential were also obtained over this period; and after demonstrating how the atmospheric-induced component can be removed from these data, the resultant soil-induced component was plotted as a function of the new water stress index. The result was a simple linear relationship, which was found to be identical to one previously derived for alfalfa. Finally, it was shown that grain yield was directly related to the mean plant water stress index over the reproductive growth period from heading to senescence.Contribution from Agricultural Research, Science and Education Administration, US Department of AgricultureResearch physicist, soil scientist, research physicist, and research entomologist, respectively     

Kinematic-wave model for soil-moisture movement with plant-root extraction

A kinematic-wave model is developed for simulating the movement of soil moisture in unsaturated soils with plants. The model involves three free boundaries. Analytical solutions are derived when the plant roots are assumed to extract moisture at a constant rate and the upstream boundary condition is independent of time. Numerical solutions are the only resort when the moisture extraction and the upstream boundary condition both depend on time.