The use of midday leaf water potential for scheduling deficit irrigation in vineyards

Midday leaf water potential (Ψ_md) was monitored for 3 years at a commercial vineyard (cv. Pinot Noir) under four irrigation strategies. Three treatments were established based on irrigating vines with 4–6 mm/day, when daily measured Ψ_md was more negative than the pre-defined threshold. After the first experimental year, thresholds were adjusted for each treatment as: (1) Control (C), irrigated when Ψ_md was less than −0.6 MPa at the beginning of the season and gradually fell to −0.8 MPa at about mid-June, after which the threshold was maintained at −0.8 MPa until harvest. (2) Control–Deficit (CD), irrigated as C from bud-break to mid-June (around the middle of Stage II of fruit growth), and from then until harvest when Ψ_md decreased below −1.2 MPa. (3) Deficit–Deficit (DD), irrigated when Ψ_md was less than −1.0 from bud break to mid-May (about the middle of fruit growth Stage I), and after that time the Ψ_md threshold became −1.2 MPa until harvest. A fourth treatment was applied following a soil water budget approach (WB). All treatments were replicated five times but irrigation in the Ψ_md-based treatments were independently applied to each of the replicate plots, whereas irrigation for WB was applied equally to all replications. The more site-specific information obtained from Ψ_md thresholds in C provided substantial advantages for yield homogeneity and repeatability of results with respect to WB, thus demonstrating the method’s greater ability to account for spatial variability. Average applied water for the 3 years in C, CD, and DD was 374, 250, and 178 mm, respectively, while the yields were 11.8, 9.2, and 6.1 kg/vine, respectively. The CD treatment produced better juice quality than C, and was superior in other quality parameters to both C and DD. However, over the study period, an important carryover effect was observed in the yields and the grape size of CD, which tended to diminish from year to year relative to C.     

Simulation of drainage water quality with DRAINMOD

The design and management of drainage systems should consider impacts on drainage water quality and receiving streams, as well as on agricultural productivity. Two simulation models that are being developed to predict these impacts are briefly described. DRAINMOD-N uses hydrologic predictions by DRAINMOD, including daily soil water fluxes, in numerical solutions to the advective-dispersive-reactive (ADR) equation to describe movement and fate of NO₃-N in shallow water table soils. DRAINMOD- CREAMS links DRAINMOD hydrology with submodels in CREAMS to predict effects of drainage treatment and controlled drainage losses of sediment and agricultural chemicals via surface runoff. The models were applied to analyze effects of drainage intensity on a Portsmouth sandy loam in eastern North Carolina. Depending on surface depressional storage, agricultural production objectives could be satisfied with drain spacings of 40 m or less. Predicted effects of drainage design and management on NO₃-N losses were substantial. Increasing drain spacing from 20 m to 40 m reduced predicted NO₃-N losses by over 45% for both good and poor surface drainage. Controlled drainage further decreases NO₃-N losses. For example, predicted average annual NO₃-N losses for a 30 m spacing were reduced 50% by controlled drainage. Splitting the application of nitrogen fertilizer, so that 100 kg/ha is applied at planting and 50 kg/ha is applied 37 days later, reduced average predicted NO₃-N losses but by only 5 to 6%. This practice was more effective in years when heavy rainfall occurred directly after planting. In contrast to effects on NO₃-N losses, reducing drainage intensity by increasing drain spacing or use of controlled drainage increased predicted losses of sediment and phosphorus (P). These losses were small for relatively flat conditions (0.2% slope), but may be large for even moderate slopes. For example, predicted sediment losses for a 2% slope exceeded 8000 kg/ha for a poorly drained condition (drain spacing of 100 m), but were reduced to 2100 kg/ha for a 20 m spacing. Agricultural production and water quality goals are sometimes in conflict. Our results indicate that simulation modeling can be used to examine the benefits of alternative designs and management strategies, from both production and environmental points-of-view. The utility of this methodology places additional emphasis on the need for field experiments to test the validity of the models over a range of soil, site and climatological conditions.     

How to assess the temporal dynamics of landscape connectivity in ever-changing landscapes: a literature review

Landscape Ecology - Landscape connectivity plays a key role in determining the persistence of species inhabiting fragmented habitat patches. In dynamic landscapes, most studies measure connectivity...     

Landscape composition is the major driver of the taxonomic and functional diversity of tropical frugivorous birds

Landscape Ecology - Anthropogenic land use and cover changes impact biodiversity worldwide. However, ecological groups are differently affected by landscape composition and configuration....     

Planning wetland protection and restoration for the safeguard of ecosystem service flows to beneficiaries

Landscape Ecology - Human activities have led to the degradation of wetlands, impinging on their capacity to deliver essential ecosystem services to society. Wetland restoration now appears an...     

Gene Discovery and Characterization from Non-sequenced Medicinal Plants

Plant-derived secondary metabolites still constitute important resources for currently prescribed drugs and for the discovery of active principles which are effective in new indication areas. Promising compounds are often exclusively found in wild medicinal plants and the classical plant-based pharmaceutical production approach has been hampered by low yields, lack of reproducibility and the high complexity of plant extracts （Rischer and Oksman-Caldentey, 2005）. Influencing the accumulation of target compounds by breeding or genetic engineering is greatly impeded because in most cases the general biosynthetic routes are incompletely understood.     

Hexavalent Chromium Removal by Candida sp. in a Concentric Draft-Tube Airlift Bioreactor

The main purpose of this work was to conduct a kinetic study on cell growth and hexavalent chromium [Cr(VI)] removal by Candida sp. FGSFEP in a concentric draft-tube airlift bioreactor. The yeast was batch-cultivated in a 5.2-l airlift bioreactor containing culture medium with an initial Cr(VI) concentration of 1.5 mM. The maximum specific growth rate of Candida sp. FGSFEP in the airlift bioreactor was 0.0244 h^?1, which was 71.83% higher than that obtained in flasks. The yeast strain was capable of reducing 1.5 mM Cr(VI) completely and exhibited a high volumetric rate [1.64 mg Cr(VI) l^?1 h^?1], specific rate [0.95 mg Cr(VI) g^?1 biomass h^?1] and capacity [44.38 mg Cr(VI) g^?1 biomass] of Cr(VI) reduction in the airlift bioreactor, with values higher than those obtained in flasks. Therefore, culture of Candida sp. FGSFEP in a concentric draft-tube airlift bioreactor could be a promising technological alternative for the aerobic treatment of Cr(VI)-contaminated industrial effluents.     

Atmospheric Mercury Fluxes in a Southern Boreal Forest and Wetland

Total gaseous mercury (TGM) fluxes from the forest floor and a boreal wetland were measured by a flux chamber technique coupled with an automatic mercury vapour analyser. The fluxes were measured at three sampling sites in southern Finland, 61°14′ N, 25°04′ E in summer 2007, with additionally in situ TGM concentrations in the air at one of the sites and mercury bulk deposition at another. Most of the flux data were collected during the daytime. At one of the sites, diurnal flux behaviour was studied, and a clear cycle with an afternoon maximum and a night minimum was observed. The highest emissions (up to 3.5 ng m⁻² h⁻¹) were observed at the forest floor site having a moss and grass cover. At the wetland and litter-rich forest floor sites, the emissions were below 1 ng m⁻² h⁻¹ and sometimes negative (down to −1.0 ng m⁻² h⁻¹), indicating mercury uptake. The measured average fluxes in August were 0.9 ± 1.1 and 0.2 ± 0.3 ng m⁻² h⁻¹ for the forest floor sites and wetland sites, respectively. The flux data were compared with the mercury bulk deposition, which proved to be of the same magnitude, but opposite in sign. At the mossy forest floor site, the extrapolated TGM emissions were 130% of the Hg deposition in August 2007. Comparison with other studies showed that the fluxes in background areas are relatively uniform, regardless of measurement site location and method used. Airborne TGM remained at the background level during the study, with an average value of 1.3 ± 0.2 ng m⁻³; it frequently showed a diurnal cycle pattern.     

Effects of Broomrape Parasitism on Sunflower Plants: Growth,Development, and Mineral Nutrition

Sunflower broomrape (Orobanche cumana Wallr.) is a parasitic plant that infects sunflower (Helianthus annuus L.) plants. In this work, sunflower plants were grown under greenhouse conditions in pots with the substrate infested or non-infested with broomrape seeds. At different numbers of days after sowing, plant height, internode lengths, number of leaves, head diameter, mineral composition of leaves, and potassium (K) concentration in stem were measured. The negative effects of broomrape parasitism were assessed from 57 d after sowing, when broomrape started to emerge. Parasitized plants exhibited lower shoot dry weight, height, and head diameter than control plants. The reduction in internode lengths was associated with a decrease in the gradient of K concentration from basal to apical stem. The mineral composition of leaves was also affected in parasitized plants. The concentrations of calcium (Ca), magnesium (Mg), manganese (Mn), and zinc (Zn) in leaves of parasitized plants were lower than those of the control plants, while there were few differences for K, phosphorus (P), iron (Fe), and copper (Cu). The effects of parasitism are discussed in relation to their competition for resources and to perturbations of the host physiology such as hormonal and water balance.     

Herbivory of an invasive slug in a model grassland community can be affected by earthworms and mycorrhizal fungi

Invasion of non-native species is among the top threats for the biodiversity and functioning of native and agricultural ecosystems worldwide. We investigated whether the herbivory of the slug Arion vulgaris (formerly Arion lusitanicus; Gastropoda), that is listed among the 100 worst alien species in Europe, is affected by soil organisms commonly present in terrestrial ecosystems (i.e. earthworms—Annelida: Lumbricidae and arbuscular mycorrhizal fungi—AMF, Glomerales). We hypothesized that slug herbivory would be affected by soil organisms via altered plant nutrient availability and plant quality. In a greenhouse experiment, we created a simple plant community consisting of a grass, a forb, and a legume species and inoculated these systems with either two earthworm species and/or four AMF taxa. Slugs were introduced after plants were established. Earthworms significantly reduced total slug herbivory in AMF-inoculated plant communities (P?=?0.013). Across plant species, earthworms increased leaf total N and secondary metabolites, AMF decreased leaf thickness. Mycorrhizae induced a shift in slug feeding preference from non-legumes to legumes; the grass was generally avoided by slugs. AMF effects on legume herbivory can partly be explained by the AMF-induced increase in total N and decrease in C/N ratio; earthworm effects are less clear as no worm-induced alterations of legume plant chemistry were observed. The presence of earthworms increased average AMF colonization of plant roots by 140 % (P?<?0.001). Total shoot mass was significantly increased by AMF (P?<?0.001). These data suggest that the feeding behavior of this invasive slug is altered by a belowground control of plant chemical quality and community structure.