一株曲霉的一种中温糖化酶的纯化及其部分酶学特性

本研究从广西花坪自然保护区采集的土壤中筛选获得了一株产糖化酶丝状真菌菌株57-45,通过形态学观察和真菌内转录间隔区（internal transcribed spacer,ITS）序列比对分析,将其初步鉴定为曲霉属（Aspergillus sp.）的一个种。纯化真菌57-45所产的一种胞外糖化酶经过硫酸铵分级沉淀、疏水层析和阴离子交换层析三步蛋白质纯化步骤,得到在SDS-PAGE上约60kD的单一蛋白质条带,薄层层析分析表明该纯化的蛋白质水解可溶性淀粉的产物只有葡萄糖,证明该纯化的蛋白质为糖化酶。纯化的糖化酶Km值为1.9mg/mL,Vmax为4148μmol/（min·mg）,最适作用pH5.5,最适作用温度50℃,在同步糖化发酵中有应用的潜力。金属离子Fe3＋、Zn2＋、Cu2＋对酶活有较强的抑制作用,EDTA对酶活有较强的促进作用。本文结果将为进一步研究曲霉糖化酶的酶学特性提供新的材料。     

Molecular characterization and PCR detection of a nitrogen-fixing Pseudomonas strain promoting rice growth

Nitrogen-fixing plant growth-promoting rhizobacteria (PGPR) from the genus Pseudomonas have received little attention so far. In the present study, a nitrogen-fixing phytohormone-producing bacterial isolate from kallar grass (strain K1) was identified as Pseudomonas sp. by rrs (16S ribosomal RNA gene) sequence analysis. rrs identity level was high with an uncharacterized marine bacterium (99%), Pseudomonas sp. PCP2 (98%), uncultured bacteria (98%), and Pseudomonas alcaligenes (97%). Partial nifH gene amplified from strain K1 showed 93% and 91% sequence similarities to those of Azotobacter chroococcum and Pseudomonas stutzeri, respectively. The effect of Pseudomonas strain K1 on rice varieties Super Basmati and Basmati 385 was compared with those of three non-Pseudomonas nitrogen-fixing PGPR (Azospirillum brasilense strain Wb3, Azospirillum lipoferum strain N4 and Zoogloea strain Ky1) used as single-strain inoculants. Pseudomonas sp. K1 was detected in the rhizosphere of inoculated plants by enrichment culture in nitrogen-free growth medium, which was followed by observation under the microscope as well as by PCR using a rrs-specific primer. For both rice varieties, an increase in shoot biomass and/or grain yield over that of noninoculated control plants was recorded in each inoculated treatment. The effect of Pseudomonas strain K1 on grain yield was comparable to those of A. brasilense Wb3 and Zoogloea sp. Ky1 for both rice varieties. These results show that nitrogen-fixing pseudomonads deserve attention as potential PGPR inoculants for rice.     

Soybean glycinin subunits: Characterization of physicochemical and adhesion properties

Soybean proteins have shown great potential for applications as renewable and environmentally friendly adhesives. The objective of this work was to study physicochemical and adhesion properties of soy glycinin subunits. Soybean glycinin was extracted from soybean flour and then fractionated into acidic and basic subunits with an estimated purity of 90 and 85%, respectively. Amino acid composition of glycinin subunits was determined. The high hydrophobic amino acid content is a major contributor to the solubility behavior and water resistance of the basic subunits. Acidic subunits and glycinin had similar solubility profiles, showing more than 80% solubility at pH 2.0-4.0 or 6.5-12.0, whereas basic subunits had considerably lower solubility with the minimum at pH 4.5-8.0. Thermal analysis using a differential scanning calorimeter suggested that basic subunits form new oligomeric structures with higher thermal stability than glycinin but no highly ordered structures present in isolated acidic subunits. The wet strength of basic subunits was 160% more than that of acidic subunits prepared at their respective isoelectric points (pI) and cured at 130 degrees C. Both pH and the curing temperature significantly affected adhesive performance. High-adhesion water resistance was usually observed for adhesives from protein prepared at their pI values and cured at elevated temperatures. Basic subunits are responsible for the water resistance of glycinin and are a good starting material for the development of water-resistant adhesives.     

基于动态特性的甘蔗收获机切割器拓扑优化设计

根据甘蔗收获机切割器动态分析结果中应力集中区域较多、振动较大的问题,针对减小甘蔗破头率和能耗及提高整体刚度的需求,在满足工作条件的情况下,以最小柔度为优化目标,对切割器结构进行拓扑优化设计,以优化所得构型为基础,提取并建立切割器新模型。最后,对新模型进行有限元分析,结果表明:优化后的切割器的1阶固有频率提高了10.05%,2阶固有频率提高了15.15%,Z向位移和综合位移分别减少了55.58%和44.58%,质量也减少了3.37%,应力集中区域刚性得到明显提升,为同类甘蔗收获机切割器的优化设计提供了参考和理论依据。     

基于鼹鼠多趾结构特征的仿生切土刀片设计与试验

为降低土壤耕作阻力,分析了鼹鼠前肢手掌的多趾组合结构特征,得到鼹鼠多趾组合结构是一种多窄齿组合结构,且相邻齿间间距可调整,最终确定了多趾组合结构的数学模型。基于该模型,设计了具有仿生结构特征的切土刀片。通过土槽试验,采用四因素三水平的二次正交回归试验方法,分析仿生结构元素m和n、土壤含水率和切土倾角对水平阻力的影响,得到土壤含水率和切土倾角对水平阻力的影响更显著,最优仿生结构元素m为5、n为1.75。通过比较传统和仿生刀片在切土倾角10°~90°和土壤含水率10%~30%下的水平阻力,得到仿生几何结构对刀片切土的临界倾角无显著影响,但土壤含水率对其有显著影响：当土壤含水率为10%和20%时,临界倾角均为30°左右;当土壤含水率为30%时,临界倾角均在40°~50°之间。然而,仿生几何结构对刀片所受的水平阻力有显著影响,在相同的土壤含水率下,仿生刀片的水平阻力总小于传统刀片的水平阻力：当土壤含水率为10%、20%、30%时,仿生刀片的水平阻力分别减小11.48%~39.16%、17.81%~28.00%和11.19%~33.26%。此外,水平阻力的变化与土壤内聚力具有极大的相关性,研究表明土壤含水率为10%~20%时,仿生刀片具有更好的切土性能。     

我国龙眼产业化进程中的问题与对策

我国龙眼在产业化进程中,存在着种植品种结构发展不平衡,生产经营规模化、标准化程度低;品牌未形成、市场建设滞后、缺乏行业自律和深加工比例少;科研投入不足,技术力量薄弱,缺乏整体布局等问题。提出采用调整优化龙眼品种结构,培育“龙头企业”,组建龙眼产业协会与合作社,严格企业自律,建设集散市场;实行标准化生产,树立品牌;实施冷链流通,建设完整的物流系统;加大龙眼采后深加工研发投入,促进产业结构优化;按ISO、HACCP等国际认证体系规范我国龙眼产业,建立高效联动的信息发布和预警预报机制等对策。     

几种新型木本切花在昆明的引种试种试验初报

定期观测所引进的银叶树（Leucadendron）、风轮花(Leucospermum)和风蜡花(Chamelaucium)各个品种的株高并记录物候、病虫害发生情况及越冬表现。结果表明：银叶树7月份生长量最大,11月停止,“旅途落日”比“纯金”早开始生长,且年生长量大于后者;风轮花的生长量在7—8月是高峰,平均每月长高5cm,但年生长量较小;风蜡花全年都在生长,7—8月是“粉色骄傲”的生长高峰,平均每月增高约20cm,“紫色骄傲”没有显著的生长高峰期。银叶树的抗病虫害能力和抗寒性较强,几个风轮花品种在抗病性及抗寒性方面的表现各不相同,风蜡花的抗寒性较强,“粉色骄傲”抗根茎部病害的能力强于“紫色骄傲”。     

不同砧木嫁接对西瓜抗病性及主要经济性状的影响

将引进的日本强势葫芦、勇士野生西瓜等7个西瓜嫁接砧木分别与本地主栽的西瓜品种早佳84-24进行嫁接试验。通过对嫁接亲和力,嫁接苗的抗枯萎病能力、产量和品质等主要性状的考查分析,结果表明以日本强势葫芦作砧木的嫁接苗综合性状表现最佳。     

甘蓝型油菜杂交种混播制种效应

利用甘蓝型油菜隐性无蜡粉遗传标记杂交组合对混播制种效应进行了研究。2002、2003、2004和2007共4个年度的研究结果表明,混播制种比行播制种产量年度平均高18．7％,杂种率高5．1％,纯杂种产量高20．1％。混播制种的增效主要得益于父本植株在田间均衡的分布和良好的个体发育。混播制种法在油菜遗传标记杂种、抗除草剂杂种、掺合杂种等方向上具有潜在应用价值。     

齿果酸模种子发芽研究

通过在不同温度、不同浸种时间和温度、光照与黑暗等处理对齿果酸模进行发芽试验,测定不同条件对发芽势和发芽率的影响,探讨齿果酸模种子发芽最佳条件。结果表明:在15℃条件下种子的发芽率和发芽势达到最大,分别为92%和78%,然后随温度增加逐渐降低;浸种24 h发芽率和发芽势达到最大,达77.5%,浸种6 h与12 h对种子发芽率较低;20℃浸种处理发芽率和发芽势达到最大,分别达78.5%和73.5%,浸种温度过高或过低都不利于种子萌发。光照与黑暗对发芽率影响差异不显著,对发芽势影响显著。齿果酸模发芽最适合条件:20℃浸种24 h,15℃光照培养。