Respiration pattern and microbial use of field-grown transgenic Bt-maize residues

A 49-day incubation experiment was carried out with the addition of field-grown maize stem and leaf residues to soil at three different temperatures (5, 15, and 25 °C). The aim was to study the effects of two transgenic Bt-maize varieties in comparison to their two parental non-Bt varieties on the mineralization of the residues, on their incorporation into the microbial biomass and on changes in the microbial community structure. The stem and leaf residues of Novelis-Bt contained 3.9 μg g⁻¹ dry weight of the Bt toxin Cry1Ab and those of Valmont-Bt only 0.8 μg g⁻¹. The residues of the two parental non-Bt varieties Nobilis and Prelude contained higher concentrations of ergosterol (+220%) and glucosamine (+190%) and had a larger fungal C-to-bacterial C ratio (+240%) than the two Bt varieties. After adding the Bt residues, an initial peak in respiration of an extra 700 μg CO₂-C g⁻¹ soil or 4% of the added amount was observed in comparison to the two non-Bt varieties at all three temperatures. On average of the four varieties, 19-38% of the maize C added was mineralized during the 49-day incubation at the three different temperatures. The overall mean increase in total maize-derived CO₂ evolution corresponded to a Q₁₀ value of 1.4 for both temperature steps, i.e. from 5 to 15 °C and from 15 to 25 °C. The addition of maize residues led to a strong increase in all microbial properties analyzed. The highest contents were always measured at 5 °C and the lowest at 25 °C. The variety-specific contents of microbial biomass C, biomass N, ATP and adenylates increased in the order Novelis-Bt ? Prelude<Valmont-Bt ? Nobilis. The mineralization of Novelis-Bt residues with the highest Bt concentration and lowest N concentration and their incorporation into the microbial biomass was significantly reduced compared to the parental non-Bt variety Nobilis. These negative effects increased considerably from 5 to 25 °C. The transgenic Bt variety Valmont did not show further significant effects except for the initial peak in respiration at any temperature.     

Effect of forest structure and health on the relative surface temperature captured by airborne thermal imagery – Case study in Norway Spruce-dominated stands in Southern Finland

The effect of forest structure and health on the relative surface temperature captured by airborne thermal imagery was investigated in Norway Spruce-dominated stands in Southern Finland. Airborne thermal imagery, airborne scanning light detection and ranging (LiDAR) data and 92 field-measured sample plots were acquired at the area of interest. The surface temperature correlated most negatively with the logarithm of stem volume, Lorey’s height and the logarithm of basal area at a resolution of 254?m² (9?m radius). LiDAR-derived metrics: the standard deviations of the canopy heights, canopy height (upper percentiles and maximum height) and canopy cover percentage were most strongly negatively correlated with the surface temperature. Although forest structure has an effect on the detected surface temperature, higher temperatures were detected in severely defoliated canopies and the difference was statistically significant. We also found that the surface temperature differences between the segmented canopy and the entire plot were greater in the defoliated plots, indicating that thermal images may also provide some additional information for classifying forests health status. Based on our results, the effects of forest structure on the surface temperature captured by airborne thermal imagery should be taken into account when developing forest health mapping applications using thermal imagery.     

Changing stock of biomass carbon in a boreal forest over 93 years

The growing stock more than doubled from 1.6 to 3.4 million m³ between 1912 and 2005 in forests on an area of 387 km² in southern Finland. The stock expansion continued for 93 years noting interim results, which were available for 1959, 1982, 1994 and 1999. Forested area in the region hardly changed. Carbon sequestration was mainly a result of a long-term recovery from forest degradation, a legacy of land use in the 18th and 19th centuries. Tree demography responded to management change especially of mature stands: Average tree size and stocking density of stands increased. On average the expanding biomass stock sequestered 18 tons C annually per km² (18 g C per m²). In comparison, the emissions of fossil carbon in the region were estimated at 12 tons C per km² (12 g C per m²) on average. However, fossil CO₂ emissions exceeded biomass sequestration in recent decades. The powerful and persistent expansion of the carbon stock was an unintended co-benefit of forestry, which was motivated by the intention to improve timber yield. On the more negative side the change in management introduced clear-cuts, and a loss of diverse elements of the pre-industrial biota.     

Physical and hydraulic properties of baked ceramic aggregates used for plant growth medium.

Baked ceramic aggregates (fritted clay, arcillite) have been used for plant research both on the ground and in microgravity. Optimal control of water and air within the root zone in any gravity environment depends on physical and hydraulic properties of the aggregate, which were evaluated for 0.25-1-mm and 1-2-mm particle size distributions. The maximum bulk densities obtained by any packing technique were 0.68 and 0.64 g cm-3 for 0.25-1-mm and 1-2-mm particles, respectively. Wettable porosity obtained by infiltration with water was approximately 65%, substantially lower than total porosity of approximately 74%. Aggregate of both particle sizes exhibited a bimodal pore size distribution consisting of inter-aggregate macropores and intra-aggregate micropores, with the transition from macro- to microporosity beginning at volumetric water content of approximately 36% to 39%. For inter-aggregate water contents that support optimal plant growth there is 45% change in water content that occurs over a relatively small matric suction range of 0-20 cm H2O for 0.25-1-mm and 0 to -10 cm H2O for 1-2-mm aggregate. Hysteresis is substantial between draining and wetting aggregate, which results in as much as a approximately 10% to 20% difference in volumetric water content for a given matric potential. Hydraulic conductivity was approximately an order of magnitude higher for 1-2-mm than for 0.25-1-mm aggregate until significant drainage of the inter-aggregate pore space occurred. The large change in water content for a relatively small change in matric potential suggests that significant differences in water retention may be observed in microgravity as compared to earth.     

On-line gas chromatography combustion/pyrolysis isotope ratio mass spectrometry (HRGC-C/P-IRMS) of pineapple (Ananas comosus L. Merr.) volatiles

By use of extracts prepared by liquid-liquid separation of the volatiles from self-prepared juices of pineapple fruits (Ananas comosus) (n = 14) as well as commercial pineapple recovery aromas/water phases (n = 3), on-line capillary gas chromatography-isotope ratio mass spectrometry was employed in the combustion (C) and the pyrolysis (P) modes (HRGC-C/P-IRMS) to determine the delta(13)C(VPDB) and delta(2)H(VSMOW) values of selected pineapple flavor constituents. In addition to methyl 2-methylbutanoate 1, ethyl 2-methylbutanoate 2, methyl hexanoate 3, ethyl hexanoate 4, and 2,5-dimethyl-4-methoxy-3[2H]-furanone 5, each originating from the fruit, the delta(13)C(VPDB) and delta(2)H(VSMOW) data of commercial synthetic 1-5 and "natural" (biotechnologically derived) 1-4 were determined. With delta(13)C(VPDB) data of pineapple volatiles 1-4 varying from -12.8 to -24.4 per thousand, the range expected for CAM metabolism was observed. Compound 5 showed higher depletion from -20.9 to -28.6 per thousand. A similar situation was given for the delta(2)H(VSMOW) values of 3-5 from pineapple ranging from -118 to -191 per thousand, whereas 1 and 2 showed higher depleted values from -184 to -263 per thousand. In nearly all cases, analytical differentiation of 1-5 from pineapple and natural as well as synthetic origin was possible. In general, natural and synthetic 1-5 exhibited delta(13)C(VPDB) data ranging from -11.8 to -32.2 per thousand and -22.7 to -35.9 per thousand, respectively. Their delta(2)H(VSMOW) data were in the range from -242 to -323 per thousand and -49 to -163 per thousand, respectively.     

Botrytis cinerea Infection in Grape Flowers: Defense Reaction, Latency, and Disease Expression

ABSTRACT Inflorescences of field-grown grapevines (Vitis vinifera L. cv. Gamay) were inoculated with a Botrytis cinerea conidia suspension or dried conidia at different stages during bloom in moist weather. Approximately 10% of the conidia germinated within 72 h, resulting in two to three times more latent infections than uninoculated controls in pea-size (7 mm in diameter) berries. In surface-sterilized pea-size berries, latent B. cinerea was present predominantly in the receptacle area. After veraison, latent B. cinerea also was found in the style and, in mature berries, latent colonies were distributed throughout the pulp. Inoculation at full bloom led to the highest disease severity (66%) at harvest, compared with 38% in controls. Stilbene stress metabolites in the flowers were measured by high-performance liquid chromatography. Resveratrol accumulated mainly after pre-bloom and full-bloom inoculation, but did not prevent infection. Piceid levels did not change following inoculation, while epsilon-viniferin was found in necrotic tissues only, and pterostilbene and alphaviniferin were not detected at all. B. cinerea conidia suspensions also were applied to various locations on flowers of pot-grown cvs. Pinot Noir and Chardonnay. Inoculation of the receptacle area, but not that of the stigma and ovary, resulted in latent infections. Stilbene synthesis was similar to the field results, with resveratrol accumulating mainly in the calyptra and receptacle area. Constitutive soluble phenolic compounds (mainly derivatives of quercetin and hydroxy-cinnamic acid) were present at high concentrations in the calyptra but at low levels in the receptacle area. These experiments confirmed bloom as a critical time for B. cinerea infection in grapes and suggest that the most likely site of infection is the receptacle area or cap scar exposed at anthesis. Stilbenes may have a limited role in inhibition of flower infection and latency in susceptible grape cultivars, and epsilon-viniferin may be a by-product rather than a deterrent of infection.     

Intraspecific Relationship of Plasmopara halstedii Isolates Differing in Pathogenicity and Geographic Origin Based on ITS Sequence Data

Sequence parts of the internal transcribed spacer (ITS) region of nuclear ribosomal DNA were analysed to screen for the intraspecific variability of a non-coding genomic region in 15 Plasmopara halstedii populations of different pathotype and geographic origin. Samples revealed uniformity in a ca. 790 Bp fragment comprising of the ITS-1, 5.8S and front parts of the ITS-2. In contrast, clear differences were found in a ca. 810 Bp fragment of the ITS-2 thus allowing differentiation between populations of pathotype 100, 310 and 330 and a group of populations representing pathotypes 700, 701, 703, 710 and 730. Samples of pathotypes 700 to730 originated from Slovakia, France, and Germany, but were uniform in both ITS sequence parts, thus indicating very recent origin of these highly aggressive physiological races. The potential use of ITS sequences for pathotype differentiation and phylogenetic studies in P. halstedii is discussed.