Probabilistic evaluation of the final moisture content of kiln-dried lumber using the bootstrap method

This paper presents a probabilistic method of evaluating the final moisture content (MC) of lumber obtained at the end of the kiln-drying process. The final MC data of three different drying tests conducted in past studies were analyzed using the bootstrap method. Target MC was tentatively set below 20 % in the analysis. Two characteristic parameters representing the final MC were estimated with bootstrap confidence intervals. These parameters were the standard deviation (SD) and the percentage of the population that met the MC requirement of less than 20 % (P ₂₀). The histograms of the final MC and the subsequent goodness-of-fit tests revealed that the final MC data of two drying tests did not follow any classical probability distributions, including Normal, Log-Normal, Weibull, and Gamma distributions, thus indicating the need for nonparametric statistics. The uncertainty of the final MC could be evaluated with the estimated SD and P ₂₀. After deriving the relationships between P ₂₀ and the corresponding probability that P ₂₀ is not achieved, we demonstrated how such relationships could provide a kiln operator with information to facilitate better decision-making in optimizing a drying schedule.     

The effects of temporal differences between map and ground data on map-assisted estimates of forest area and biomass

Key message

When areas of interest experience little change, remote sensing-based maps whose dates deviate from ground data can still substantially enhance precision. However, when change is substantial, deviations in dates reduce the utility of such maps for this purpose.

Context

Remote sensing-based maps are well-established as means of increasing the precision of estimates of forest inventory parameters. The general practice is to use maps whose dates correspond closely to the dates of ground data. However, as national forest inventories move to continuous inventories, deviations between map and ground data dates increase.

Aims

The aim was to assess the degree to which remote sensing-based maps can be used to increase the precision of estimates despite differences between map and ground data dates.

Methods

For study areas in the USA and Norway, maps were constructed for each of two dates, and model-assisted regression estimators were used to estimate inventory parameters using ground data whose dates differed by as much as 11 years from the map dates.

Results

For the Minnesota study area that had little change, 7-year differences in dates had little effect on the precision of estimates of proportion forest area. For the Norwegian study area that experienced considerable change, 11-year differences in dates had a detrimental effect on the precision of estimates of mean biomass per unit area.

Conclusions

The effects of differences in map and ground data dates were less important than temporal change in the study area.

     

A new multistage dynamic model for biological control exemplified by the host–parasitoid system <Emphasis Type="Italic">Spodoptera exigua</Emphasis>–<Emphasis Type="Italic">Chelonus oculator</Emphasis>

Over the last few decades, important advances have been made in understanding of host–parasitoid relations and their applications to biological pest control. Not only has the number of agent species increased, but new manipulation techniques for natural enemies have also been empirically introduced, particularly in greenhouse crops. This makes biocontrol more complex, requiring a new mathematical modeling approach appropriate for the optimization of the release of agents. The present paper aimed at filling this gap by the development of a temperature- and stage-dependent dynamic mathematical model of the host–parasitoid system with an improved functional response. The model is appropriate not only for simulation analysis of the efficiency of biocontrol agents, but also for the application of optimal control methodology for the optimal timing of agent releases, and for the consideration of economic implications. Based on both laboratory and greenhouse trials, the model was validated and fitted to the data of Chelonus oculator (F.) (Hym.: Braconidae) as a biological control agent against the beet armyworm, Spodoptera exigua Hübner (Lep.: Noctuidae). We emphasize that this model can be easily adapted to other interacting species involved in biological or integrated pest control with either parasitoid or predator agents.     

Technological properties and fire performance of medium density fibreboard (MDF) treated with selected polyphosphate-based fire retardants

ABSTRACT

The objective of the work was to evaluate the efficacy of two new polyphosphate-based fire retardants (FRs) and one commercial product named Siriono^® on the fire performance and physical–mechanical properties of medium density fibreboard (MDF) fabricated in the laboratory from Scots pine (Pinus sylvestris L.) wood. The fibres were treated with aqueous solutions of fire retardants, at 12% loading (dry salt on dry wood), and bonded with a melamine urea formaldehyde (MUF) adhesive. The physical and mechanical properties of panels were assessed using the European standards, whereas their fire performance was evaluated using an in-house method and the Cone calorimeter. In overall, the chemicals added enhanced the fire and smoke properties of the panels to varying degrees. Critical FR parameters such as peak heat release rate (peak HRR), total heat release (THR) and total smoke production (TSP) were significantly improved in the FR-treated panels, as exhibited in cone calorimeter tests. However, the internal bond strength of treated panels largely decreased by the addition of fire retardants, while thickness swell and water absorption negatively affected to a significant extent. In contrast, the formaldehyde release of the panels was considerably decreased at the E1 class level, with the incorporation of the polyphosphate-based additives.     

Small-scale forestry development in Leyte,Philippines: The central role of nurseries

This paper presents results of survey research into the role of the forestry nursery sector in the development of smallholder forestry in Leyte, Philippines. Seedling production in the province is basically carried out by three categories of nurseries: individual, communal and the government. Seedlings in the government nurseries are primarily raised for free distribution to landholders but the extension scheme fails to reach the majority of the smallholder farmers. Seedling demand of landholders is mostly catered for by the more numerous and accessible individual and communal nurseries. However, problems of capital outlay, sources and supply of germplasm, technical knowledge in nursery management for both timber and fruit trees and low sales are among the major impediments in the sustainability of small-scale nurseries. Most of the communal nurseries fail to sustain the operation after the withdrawal of supporting agencies. Knowledge on site-species matching is needed not only by small-scale nursery operators but also by the managers of government nurseries. It is concluded that the seedling industry in the province is not well established and there is a need to organise better the overall nursery system so as to improve the availability of seedlings and promote appropriate site and species combinations.     

Effects of various densities of Ophiostoma ips inoculations on Pinus sylvestris in north‐western Spain

The aim was to determine the inoculation density above which Scots pine (Pinus sylvestris) is overcome by the blue‐stain fungus Ophiostoma ips that is associated with the bark beetle Ips sexdentatus. In north‐western Spain, stems of 16 Scots pines were inoculated at various densities (0, 400, 800 or 1600 inoculi/m²) along circumferential 100 or 150 cm wide inoculation belts. Each inoculum consisted of a 5 mm diameter cylinder of malt extract agar colonized by the fungus. Three months later, all trees were harvested and trunk resinosis and foliage colour were visually assessed. The percentage of healthy, desiccated, resin soaked, and blue‐stained sapwood, as well as growth productivity indices, were calculated from stem disks cut from within the inoculated zone of each tree. Sapwood‐specific hydraulic conductivity (Ks) of each tree was measured in the middle of the inoculated zone. All parameters of tree vigour changed dramatically to the worse when inoculation densities were above 400 inoculi/m², and foliage changed from green to yellow‐green or yellow when an inoculation density of 800 instead of 400 was used. The percentage loss of sapwood‐specific conductivity (PLC) increased from 30 to 90% and the percentage of healthy, conductive sapwood dropped from 85 to 35% at 800 inoculi/m². No effect of the width of the inoculation belt was observed, and there was no relationship between tree productivity indices and the level of resistance. A non‐linear negative relationship was found between PLC and the percentage of healthy sapwood. It is concluded that tree resistance was overcome and that trees were going to die when the inoculation density was ≥800 inoculi/m².     

Attributes of People’s Organisations and the institutional viability of selected Community-Based Forest Management projects in northern Luzon

An assessment was made of the attributes of People’s Organisations (POs) and of the institutional viability of Community-Based Forest Management (CBFM) programs in three project sites in the Philippines. In CBFM, the capacity of People’s Organisations, as de facto managers of forest resources, is being developed by non-government organisations under the guidance of local government units (LGUs) and the Department of Environment and Natural Resources (DENR). A survey was conducted of community members (case informants) and members of the various agencies (key informants) to ascertain the characteristics of successful POs and the relationship between these characteristics and the viability of CBFM. Although commendable contributions have been made to the forest management capability of POs, their standard of living and environmental conditions, there are also many instances in which institutional conflict among stakeholders is apparent. The great challenge for the various stakeholders is to orchestrate their differing interests so as to address successfully the critical issues of the low socioeconomic status of PO members, corruption, lack of transparency and accountability of the organisations involved, loss of interest of PO members in project activities, lack of technical assistance, loss of credibility of the DENR, and lack of equitable benefit sharing.     

Response of <Emphasis Type="Italic">Pinus pseudostrobus</Emphasis> Lindl. to fertile growing medium and tephra-layer depth under greenhouse conditions

Major disturbances that remove vegetation cover create conditions that differ greatly from those in adjacent forests. In volcanic areas, tephra deposition can be a major disturbance that eliminates vegetation cover and creates a barrier for plant establishment. The eruption of the Paricutín volcano, in Michoacán, México, from 1943 to 1952, created large tephra deposits adjacent to forest stands. Many of these deposits still lack native vegetation and understanding of the limiting factors for establishment of native tree species is necessary to restore these areas. Pinus pseudostrobus early growth in response to the amount of fertile growing medium on top of a variable-depth tephra layer was evaluated in a greenhouse experiment. Increasing amounts of fertile growing medium increased height of 28-week-old plants (no growing medium = 5.5 cm tall ±1.8 cm, 3 cm of growing medium = 21.2 ± 4.6 cm and 6 cm of growing medium 24.8 ± 4.4 cm). Other variables showed the same trend (diameter, number of fascicles, belowground biomass and aboveground biomass). Our results suggest that P. pseudostrobus establishment in tephra covered areas will depend on the accumulation of a fertile layer of more than 3 cm in thickness.     

Genotype × environmental interaction by AMMI and GGE biplot analysis for the provenances of <Emphasis Type="Italic">Michelia chapensis</Emphasis> in South China

A provenance trial of Michelia chapensis Dandy in the south of China was carried out in three sites to assess yield and stability analyses. The trials were conducted as randomized, complete block designs with four replications at each site. Additive main effects and multiplicative interaction (AMMI) and genotype main effect and genotype × environment interaction (GGE) were employed in the evaluation of provenances; AMMI analyses showed that significant genotype × environment interaction effects (P < 0.05) existed between provenances, capturing 15.11 % of the total sum of squares. The AMMI stability value revealed that provenance 2 was stable, but had low yield. GGE-biplot models showed that provenances 7, 8, 10, and 11 were more stable and high-yielding. The GGE results also confirmed that among the three sites, site JiuQuShui was the most ideal environment for representation and discrimination.     

Improving the design of long-term monitoring experiments in forests: a new method for the assessment of local soil variability by combining infrared spectroscopy and dendrometric data

Key message

Near- and mid-infrared spectroscopy allows for the detection of local patterns of forest soil properties. In combination with dendrometric data, it may be used as a prospective tool for determining soil heterogeneity before setting up long-term forest monitoring experiments.

Context

Forest soils and stands generally exhibit higher spatial heterogeneity than other terrestrial ecosystems. This variability needs be taken into account before setting up long-term forest monitoring experiments to avoid multiple interactions between local heterogeneity and the factors tested in the experiment.

Aims

We hypothesized that raw near- and mid-infrared spectra can be used as an integrated proxy of a large set of soil properties. The use of this method, in combination with dendrometric data, should provide a quick and cost-effective tool for optimizing the design of experimental forest sites.

Methods

We assessed the local soil heterogeneity at 11 experimental sites in oak and beech stands, which belong to a new forest long-term ecological research (LTER) network. We used near- and mid-infrared spectroscopy in soil and litter samples. The spectra were subjected to principal components analyses (PCA) to determine the intra-site variability of the soil and litter layers.

Results

Based on mapped PCA coordinates and basic dendrometric data, it was possible to design the experiment and minimize the interactions between the treatment layout and the tested variables. The method was validated with chemical analyses of the soil. No interaction was detected at the set-up of the experiment between the treatment layout and chemical soil properties (C, N, C/N ratio, pH, CEC, Al, Mg, P₂O₅, Fe, Mn, Na, and K).

Conclusion

Near-infrared (NIR) and mid-infrared (MIR) spectroscopy is a useful tool for characterizing the overall heterogeneity of soil chemical properties. It can be used without any preliminary calibration. In combination with dendrometric data, it provides a reliable method for optimizing LTER plots in different types of ecosystems.