Detecting System of the Dielectric Loss in Capacitive Equipment Based on Virtual Instruments

A digital detecting system of the dielectric loss in the capacitive equipment is introduced based on virtual instruments.This system can real-time collect,analyze,process and storage electrical signals with National Instruments' program LabVIEW and ADLINK,s DAQ board.Through the simulation test in lab and the real test in electric substation,it is shown that this system has high accuracy on testing the dielectric loss in the capacitive equipment,the real test data is stable and the relative error of real dielectric loss is less than 5%.It is to say that this system can meet the requirement of the real on-line monitoring.     

发动机用平板型空滤器流动阻力特性分析和改进

为减小平板型空滤器流动阻力以增大进气量,对平板型空滤器流动阻力特性开展了实验研究,获得了空滤器流动阻力随流量变化的规律和阻力构成成分。阻力随流量的增大而加速增大,滤芯阻力约占整个空滤器阻力的一半,入口流量为120 m 3/h时,总阻力为915.3 Pa,滤芯阻力为426.4 Pa。在实验获得滤芯阻力参数的基础上,提出采用多孔介质跃升模型对平板型空滤器内部流场开展三维数值仿真分析,结果表明,仿真结果与实验结果比较吻合,最大误差为5.67%。滤芯阻力同样约占整个阻力的一半,另一半阻力主要为出口处阻力,其余壁面阻力约占15%。最后,在实验和仿真分析的基础上,提出了改进模型并进行了仿真分析。结果表明,改进模型阻力有较大程度的下降,入口流量为120 m 3/h时,总阻力为588.2 Pa,较原始模型下降了32.2%;增大空滤器流通横截面积是减小阻力以增大进气量的有效手段,改进空滤器壁面的平滑性是补充措施。     

各向异性砂土剪切带角度的理论分析

针对平面应变条件下各向异性砂土剪切带角度的试验规律,采用传统的3种理论和分叉理论进行对比分析。将平面应变条件下剪切带角度的试验结果按照传统3种理论整理发现,尽管传统3种理论可以估算同种砂剪切带角度的极小、中间和极大值,但无法解释其各向异性规律。砂土在平面应变条件下破坏时会产生明显的剪切带,当剪切带方向和砂土沉积面方向接近时,会较早诱发剪切带的产生,使材料强度降低,造成了平面应变条件下各向异性强度规律明显不同于常规三轴条件下的试验规律,采用分叉理论结合各向异性模型则可以有效解释这个规律。随砂土沉积面角度的变化,模型可以从细观角度解释常规三轴条件下剪切带角度的单调变化的试验规律,结合分叉理论可以描述平面应变条件下其先减小然后增大的规律。通过几种理论对比分析表明,模型结合分叉理论不但能够描述多种应力状态下的平面应变和常规三轴应力条件下剪切带角度表现的不同规律,而且能够从细观角度解释其各向异性成因。     

The Monitoring Measurements and Country Rock Control of NATM in Tunnel of Express Road during Construction

In this paper the author' s study on the monitoring measurement technique of NATM,the regularity and conditions of the country rock deformation are analysed based on the site measurement data in the west section of Zhongliangshan tunnel. The regression analysis of measure data for different measure lines of vavious country rock is done by the use of self-compiled CRAP program. The stability criterion for various rockmass and optimum time for primary and permanent support are provided. The conclusion available could conduct the theoretical research of NATM deeply as well as tunnel design and construction.     

A NEW APPROACH OF OPTIMIZATION

In this paper, a necessary optimality condition of problems with equality constraints is investigated by the implicit function theorem in n-dimensional Euclidean space. A new approach solving these problems is obtained. The number of dimensions of corresponding system of equations is less than the classic Lagrangian multiplier method.     

Study on Dynamical Characteristic of Epicyclic Gear Drive with Internal Tooth

The epicyclic gear drive with internal tooth is analysed,a dynamic analysis model which is based on the compatibility conditions of deformation is set up.On the basis of this model,the analysis of dynamics and kinematics is made,and the influence of design parameters on dynamical characteristic is also studied.     

秋茬生菜深水栽培氧的需求规律

以意大利耐抽薹生菜为试验材料,研究了深水栽培条件下不同生长发育阶段营养液中的溶氧量和单株吸氧量的变化。结果表明,生菜的不同生长阶段营养液中溶存氧的日变化和植株单株吸氧量有所不同,生长初期,氧需求量和吸收量均较少,只需补充少量的氧就可满足正常生长的需要;生长中期氧的需求和吸收量均较高,生长末期氧需求量减弱,吸收量也明显下降。生产管理上应注意增加和补充生长中期的充氧时间和充氧量,适当减少生长末期的充氧量。     

建立农产品质量安全市场准入机制的原则及措施分析

随着《中华人民共和国农产品质量安全法》的深入实施,中国农产品质量安全准入制度的建立势在必行,而建立良性的准入机制是各项制度有效运转的根本。该文从建立良性的农产品质量安全市场准入运行机制、建设有效的技术支撑体系、加强财政政策扶持等方面入手,提出了建立农产品质量安全市场准入机制的措施和建议。