Chemical characterization of smoke from the production process of wood-plastic composites

The chemical composition of unpleasant smell, emitted from the production process of wood-plastic composites using Manchurian ash sawdust (Fraxinus mandschurica Rupr.) and polypropylene powder as the raw material, was investigated. Wood sawdust and polypropylene powder were subjected to heat treatment to 290°C during 8 min (the conditions were similar to those employed on an industrial scale). The emitted compounds were collected and analyzed by gas chromatography-mass spectrometry (GC-MS). The analytical r...     

A NMR study of water distribution in hardwoods at several equilibrium moisture contents

The water state of one tropical (Robinia coccinea) and two temperate (Acer saccharum and Fagus grandifolia) hardwoods was determined at different equilibrium moisture contents (EMC) during desorption at 25°C. NMR technique was used to separate different components of water in wood. The species studied presented different structures, which were apparent on the spin–spin relaxation T₂ values. Three different water components were separated: slow T₂ (liquid water in vessel elements), medium T₂ (liquid water in fiber and parenchyma elements) and fast T₂ (bound or cell wall water). The NMR results showed that even at equilibrated conditions a region exists where loss of liquid water and bound water takes place simultaneously. This region will vary according to the wood structure. Finally, liquid water was present at EMC lower than the fiber saturation point, which contradicts the concept of this point when considered as a bulk property of wood.     

Distribution of boron in wood treated with aqueous and methanolic boric acid solutions

The distributions of boron in Japanese cedar (Cryptomeria japonica D. Don) sapwood blocks treated with aqueous or methanolic boric acid [B(OH)₃] solutions were explored through Raman spectroscopy and prompt gamma-ray analysis (PGA). B(OH)₃ was the sole boron species observed in Raman spectra of the wood blocks treated with either solution. Plots of weight gain of the treated wood blocks versus boron concentration in treatment solutions were found to be linear. The results indicated that the methanolic solution makes it possible to impregnate wood with much larger amounts of boron than the aqueous solution. PGA confirmed that B(OH)₃ was highly enriched near the end grains of the treated wood blocks. Raman measurements suggested that boron content in the bulk of the wood block is not as large as expected from the weight gain of the treated wood blocks when an ordinary air-drying method is used. It was concluded that the aqueous solution impregnates the cell walls of wood with boron more easily than the methanolic solution. Part of this report was presented at the 55th (Kyoto, March 2005) and 56th (Akita, August 2006) Annual Meetings of the Japan Wood Research Society. This article follows the previous rapid communication “Analysis of boron in wood treated with boric acid solutions using Doppler broadening method of prompt gamma-rays.” J Wood Sci (2006) 52:279–281     

Effect of thermo-mechanical refining on properties of MDF made from black spruce bark

The effects of thermo-mechanical refining conditions on the properties of medium density fiberboard (MDF) made from black spruce (Picea mariana) bark were evaluated. The bark chips were refined in the MDF pilot plant of Forintek Canada Corporation under nine different refining conditions in which preheating retention time was adjusted from 3 to 5 to 7 min and steam pressure was set at either 0.6, 0.9 or 1.2 MPa. The resulting bark fibers were blended with 12% UF resin (based on oven-dry fiber weight) using a mechanical blender. The resinated fibers were manually formed into fiber mats and hot-pressed into MDF panels using consistent parameters. Two panels for each refining condition were produced, resulting in a total of 18 panels. Analysis of variance (ANOVA) was used to analyze the significance of factors. Regression coefficients and 3D contour plots were used to quantify the relationship between panel properties and the two test factors. The results from this study indicated that the preheating retention time was a significant factor for both modulus of rupture (MOR) and modulus of elasticity (MOE), the steam pressure was a significant factor for internal bond strength (IB), MOR and MOE, whereas both factors were insignificant for thickness swelling, water absorption and linear expansion. The properties of MDF panels were quadratic functions of retention time and steam pressure. Compared to the ANSI standard for 120-grade MDF, most panels with a nominal density of 950 kg/m³ had very high IB (>1 MPa) and acceptable MOR, MOE and dimension stabilities. These results suggest that black spruce bark residues can be considered as a potentially suitable raw material for manufacturing MDF products.     

The role of land tenure in conservation of tree and shrub species diversity in miombo woodlands of southern Malawi

Biodiversity is declining throughout southern African miombo woodlands due to poor land use practices that are detrimental to soil, vegetation and habitat. We aimed at examining tree and shrub species diversity and distribution in Uapaca kirkiana-dominated woodlands under three land tenure types; forest reserves, customary and leasehold land. The study was conducted at different forest sites within similar agroecological zone in southern Malawi. Study sites were located at a range of altitudes between 900 and 1,200 m a.s.l. Three circular plots each with 32.60 m radius were established at each study site to sample tree and shrub species composition, structure and distribution under three land tenure types. We found that forest reserves had higher species diversity with an average of 16 tree families, 27 genera and 34 species as compared to only 10 tree families, 6 genera and 6 species on customary forest lands. Comparisons of diameter at breast height size class distributions showed that customary land had significantly low numbers of small (5.0–10.0 cm) and very large (≥30 cm) diameter classes suggesting lower levels of regeneration and high rate of anthropogenic activities. The high species diversity and richness in forest reserves and leasehold land indicate high potential for protected lands to restore tree species diversity. It is concluded that levels of human activities as influenced by land tenure type reduce tree species diversity, composition and distribution at the different sites, and this confirms the hypothesis that open access lands are not compatible with conservation of tree and shrub species diversity because of high anthropogenic activities.     

早园竹早出高产留种竹技术试验研究

早园竹早出高产留种竹试验结果表明,采用配方施肥(每年分别在11～12月、2～3月、5～6月、9月、11月施肥,每公顷共施尿素1500～1800kg,氯化钾375～450kg,钙镁磷肥300～375kg,有机畜肥45000～60000kg),同时以竹叶、砻糠、竹叶稻草,砻糠稻草4种材料覆盖早竹地,与试验前相比,产量和产值分别增长240.12％和15.2倍,投入与产出比为1:9.55,最高达1:16.18,效益十分显著。     

对船艇部队码头基地防护林建设的几点思考

从6个方面分析论述了沿海防护林建设中存在的问题,呼吁性提出解决诸多不利于沿海防护林发展的建议。     

Biomass production,nutrient cycling and distribution in age-sequence Chinese fir (<Emphasis Type="Italic">Cunninghamia lanceolate</Emphasis>) plantations in subtropical China

Biomass production and nutrient (N, P, K, Ca and Mg) accumulation, distribution and cycling were quantified in young, mature and over-mature (10-, 22-, and 34-year old) Chinese fir [Cunninghamia lanceolate (Lamb.) Hook] plantations in southern China. Total stand biomass of young, mature and over-mature stands was 38, 104 and 138 t ha^?1 respectively. Biomass production increased significantly with age. Stem wood represented the highest percentage of stand biomass, accounting for 41, 55 and 63 % in the young, mature and over-mature plantations respectively. Nutrients concentration was highest in live needles and branches, and lowest in stem wood. The plantations accumulated more N, followed by K, Ca, Mg, and P. Nutrient return amount, nutrient utilization efficiency, nutrient turnover time, the ratio of nutrient return and uptake increased with stand age, which implies that young Chinese fir deplete soil nutrients to maintain growth, and efficiently utilize nutrients to decrease dependence on soil nutrients as they age. Harvesting young Chinese fir plantations would therefore lead to high nutrient loss, but prolonging the rotation length could improve soil recovery, and help sustain productivity in the long-term. Improved nutrient return through litterfall as stands get older may also be beneficial to nutrient pool recovery.     

Adaptation of Asia-Pacific forests to climate change

Climate change is a threat to the stability and productivity of forest ecosystems throughout the Asia-Pacific region. The loss of forests due to climate-induced stress will have extensive adverse impacts on biodiversity and an array of ecosystem services that are essential for the maintenance of local economies and public health. Despite their importance, there is a lack of decision-support tools required to evaluate the potential effects of climate change on Asia-Pacific ecosystems and economies and to aid in the development of regionally appropriate adaptation and mitigation strategies. The project Adaptation of Asia-Pacific Forests to Climate Change, summarized herein, aims to address this lack of knowledge and tools and to provide support for regional managers to develop effective policy to increase the adaptive capacity of Asia-Pacific forest ecosystems. This objective has been achieved through the following activities: (1) development of a high-resolution climate downscaling model, ClimateAP, applicable to any location in the region; (2) development of climate niche models to evaluate how climate change might affect the distribution of suitable climatic conditions for regionally important tree species; (3) development and application of forest models to assess alternative management strategies in the context of management objectives and the projected impacts of climate change; (4) evaluation of models to assess forest fire risk and the relationship between forest fire and climate change; (5) development of a technique to assess ecosystem carbon storage using LiDAR; and (6) evaluation of how vegetation dynamics respond to climate change using remote sensing technology. All project outputs were developed with a focus on communication and extension to facilitate the dissemination of results to regional forest resource managers to support the development of effective mitigation and adaptation policy.