Physicochemical and Biological Characterization of Fucoidan from Fucus vesiculosus Purified by Dye Affinity Chromatography

A comparative study concerning the physicochemical, monomeric composition and biological characters among different fucoidan fractions is presented. Common purification techniques for fucoidan usually involve many steps. During these steps, the important structural features might be affected and consequently alter its biological activities. Three purified fractions were derived from Fucus vesiculosus water extract which, afterwards, were purified by a recently-developed dye affinity chromatography protocol. This protocol is based on dye-sulfated polysaccharide interactions. The first two fractions were obtained from crude precipitated fucoidan at different pH values of the adsorption phase: pH 1 and 6. This procedure resulted in fucoidan_1 and 6 fractions. The other, third, fraction: fucoidan_M, however, was obtained from a buffered crude extract at pH 1, eliminating the ethanol precipitation step. All of the three fractions were then further evaluated. Results revealed that fucoidan_M showed the highest sulfur content (S%), 12.11%, with the lowest average molecular weight, 48 kDa. Fucose, galactose, and uronic acid/glucose dimers were detected in all fractions, although, xylose was only detected in fucoidan_1 and 6. In a concentration of 10 µg·mL⁻¹, Fucoidan_6 showed the highest heparin-like anticoagulant activity and could prolong the APTT and TT significantly to 66.03 ± 2.93 and 75.36 ± 1.37 s, respectively. In addition, fucoidan_M demonstrated the highest potency against HSV-1 with an IC₅₀ of 2.41 µg·mL⁻¹. The technique proved to be a candidate for fucoidan purifaction from its crude extract removing the precipitation step from common purification protocols and produced different fucoidan qualities resulted from the different incubation conditions with the immobilized thiazine toluidine blue O dye.     

Physicochemical Properties of Oat Varieties and Their Potential for Breadmaking

The breadmaking potential of six oat varieties was compared with and related to their physicochemical properties. The most significant differences in the bread characteristics were found in the crumb structure. The varieties Buggy, Energie, and Zorro resulted in good bread quality with an even gas‐cell distribution characterized by a high number of relatively small pores. In contrast, Typhon, Ivory, and Nord 08/311 each had a large hole in the center of the crumb and accordingly poor quality. Breads differed little in specific volume, bake loss, and density. Rheological analysis revealed positive effects of low batter resistance to deformation on oat bread quality. On the basis of the physicochemical characterization, protein and fat contents were identified as key factors responsible for differences observed in bread quality, provided that starch damage and water‐hydration capacity were low. Additionally, high setback and final viscosity, as determined by Rapid Visco Analyser (RVA) analysis, positively affected oat bread quality. High α‐amylase activity was found to influence negatively the breadmaking performance of oats. Overall, protein, fat, dietary fiber content, starch pasting properties, and α‐amylase activity were responsible for the breadmaking properties of oat varieties.     

Frequency of occupation with different simultaneously offered devices by fattening pigs kept in pens with or without straw

The aim of this study was to investigate to what extent different occupational devices (pendular beam, cross of chains or lifting beam) offered simultaneously were used by one or more pigs kept in pens with or without straw during the fattening period. The data were obtained in four fattening periods. In every round four pens with nine animals each were available, two of them had a solid concrete floor and were littered with straw the other two had a partially slatted floor without any straw. At three stages during each fattening period the behaviour of the pigs was video-recorded for 24 h and their use of each occupational tool was analysed second-wise.In both housing systems the cross of chains was used longer for occupation than the other devices. The pendular beam was used least of all. All three devices could have been used by more than one pig at the same time, but the cross of chains was used longer by two to four pigs simultaneously than the others. It was observed that pigs in pens without straw used the cross of chains and the lifting beam significantly (p < 0.05) longer than the pigs in the pens with straw.All three devices are suitable to enrich a housing system without any litter. Especially a cross of chains allows the pigs to perform their explorational behaviour.     

Impact of rank position on fertility of sows

The investigations were carried out with 484 sows from two farms (farm A: housing the sows in small groups of 8 animals each, farm B with a large group of 100 sows) and a total number of 982 inseminations. The number of agonistic interactions was registered for each sow during 48 h after mixing soon after weaning the piglets at farm A. The individual rank place in the social hierarchy was calculated on the basis of wins and defeats and the sows were divided in high and low ranking sows. At farm B the rank position was estimated on the basis of the daily feeding order at two electronic feeding stations (first half of the sows in the feeding order = high ranking, second half = low ranking). Additionally, the following parameters were recorded for each sow: parity, genotype, farrowing rate and litter size (total and alive born piglets). The analysis showed that sows with a high rank position had a significantly higher farrowing rate (88.8%) compared to group-mates with low rank places (82.8%, p = 0.051) (farm A). Sows with a high rank position reached a significantly higher litter size of total born piglets (12.66, 16.14 piglets per litter respectively) than the low-ranking group-mates (12.13, 14.83 piglets/litter respectively — farms A and B). When mixing sows, the time and the conditions (e.g. group size, space allowance per sow) have to be considered to prevent the negative influence of low rank order on fertility.     

Development of two microsatellite multiplex PCR systems for high throughput genotyping in Populus euphratica

Eighteen microsatellite primer pairs previously developed at Oak Ridge National Laboratory for Populus tremuloides Michx. and Populus trichocarpa Torr. & Gray were screened for amplification in Euphrates poplar, Populus euphratica Oliv. Thirteen loci were found to express polymorphisms ranging from two to 17 alleles. The eight most variable loci were selected to set up and optimize two multiplex polymerase chain reaction (PCR) assays. Three populations containing altogether 436 trees were used to characterize the selected loci and ascertain their applicability for parentage analysis and genotyping studies. Through cross-checking of clonal identity against sex of the genotyped trees we estimated the maximum error rate for merging genotypes to be less than 0.045. Foundation project: This study was supported by the Deutsche Forschungsgemeinschaft DFG (grant number SCHN 1080/1-1)     

两种微卫星多样PCR系统应用于胡杨高效生产基因型

对已在橡树岭国家实验室建立起来的美洲山杨(Populus tremuloides Michx.)和毛果杨(Populus trichocarpa Torr.＆ Gray)18个微卫星引物进行筛选,用于胡杨相关基因的扩增.发现有13个基因位点可以表达基因多态性,范围是2～17个等位基因.选择了8个最易变的基因位点,来构建和优化2种多样PCR法.用来自3个种群的436株树木表征选择的位点,确定他们在亲缘关系分析、基因型研究的适用性.通过克隆基因型鉴定树木性别的交叉检验,我们估计并入基因型最大误差率小于O.045.     

Factors Affecting Small-Scale Farmers’ Land Allocation and Tree Density Decisions in an <Emphasis Type="Italic">Acacia decurrens</Emphasis>-Based <Emphasis Type="Italic">taungya</Emphasis> System in Fagita Lekoma District,North-Western Ethiopia

The development of woodlots as an additional source of livelihood and as a land management option for small-scale farmers is a challenging issue in the cereal-based subsistence farming systems of north-western Ethiopia. There is a need to understand why and which factors determine the decisions of small-scale farmers to grow short-rotation woodlots on their land. Data used in this study were collected from a survey of 200 randomly selected households in the region. A Tobit regression model was used to determine predictor variables for farmers’ decisions to allocate land to planting Acacia decurrens (J.C. Wendl.) Willd. and at what density trees are planted on the respective plots. The most important motivations for planting A. decurrens were income, soil fertility management, and soil and water conservation. Having a male head of household, long distance to markets and plots being on marginal land, among other factors, increased the allocation of land to A. decurrens woodlots. Having a male head of household, access to credit and plots being on marginal land, among other factors, increased tree planting density. Age had a negative effect on both allocation of land to woodlots and tree density, whereas farm size had an inverted U-shaped relationship with both decisions. These results suggest that wider expansion of A. decurrens-based plantation systems could be achieved through improving extension, credit access and road infrastructure to connect small-scale farmers to markets and finance.