种子含水率在线测量系统

根据种子含水率的测量要求，研制了一种可同时测量电容、质量和温度3个参量的装置和测量电路。该测量系统的机械装置由2个同心圆筒组成，内筒的旋转运动实现被测种子的动态喂料。采用抗寄生电容效应的开关电容电路测量上、下极板之间的电容；下极板同时也是称量平台；温度传感器测量种子的温度。3个测量值经A／D转换电路以数字量输出。分别用3个电路单独测量已知的电容、质量和温度，以及不同温度和相对湿度条件下对电容测量值的影响，并据此分析了各测量单元的精度、可靠性和可行性。     

车用汽油机缸内直喷技术的研究现状与展望

从汽油机的混合气形成与调节、燃油喷射、燃烧系统3方面对车用汽油机缸内直接喷射技术的发展及新技术进行了概述。车用汽油机缸内直接喷射技术有很大的发展潜力，将得到更大发展并取代目前的进气道直接喷射方式。通过对排放、积炭、催化器及燃油喷射系统等问题的分析和探讨，提出了缸内直接喷射式汽油机进一步发展的方向和建议。     

Crop response of drought-tolerant and conventional maize hybrids in a semiarid environment

In the High Plains, corn (Zea mays L.) is an important commodity for livestock feed. However, limited water resources and drought conditions continue to hinder corn production. Drought-tolerant (DT) corn hybrids could help maintain high yields under water-limited conditions, though consistent response of such hybrids is unverified. In this two-year study, the effects of three irrigation treatments were investigated for a DT and conventional maize hybrid, Pioneer AQUAMax P0876HR and Pioneer 33Y75, respectively. In 2013, the drier of the 2 years, irrigation amounts and crop water use (ET_c) were greater for the conventional hybrid, but grain water use efficiency (WUE) and harvest index were significantly greater for the DT hybrid. In 2014, grain yields and WUE were not significantly different between hybrids. However, irrigation amounts, ET_c and biomass yields were greater for the conventional hybrid. Results from both years indicate that the DT hybrid required less water to maximize grain yield as compared to the conventional hybrid. Producing relatively high yields with reduced amounts of water may provide a means for producers to continue corn production in a semiarid environment with declining water supplies.     

Modeling soil water dynamics in a drip-irrigated intercropping field under plastic mulch

Intercropping, drip irrigation, and the use of plastic mulch are important management practices, which can, when utilized simultaneously, increase crop production and save irrigation water. Investigating soil water dynamics in the root zone of the intercropping field under such conditions is essential in order to understand the combined effects of these practices and to promote their wider use. However, not much work has been done to investigate soil water dynamics in the root zone of drip-irrigated, strip intercropping fields under plastic mulch. Three field experiments with different irrigation treatments (high T1, moderate T2, and low T3) were conducted to evaluate soil water contents (SWC) at different locations, for different irrigation treatments, and with respect to dripper lines and plants (corn and tomatoes). Experimental data were then used to calibrate the HYDRUS (2D/3D) model. Comparison between experimental data and model simulations showed that HYDRUS (2D/3D) described different irrigation events and SWC in the root zone well, with average relative errors of 10.8, 9.5, and 11.6 % for irrigation treatments T1, T2, and T3, respectively, and with corresponding root mean square errors of 0.043, 0.035, and 0.040 cm³ cm^?3, respectively. The results showed that the SWC in the shallow root zone (0–40 cm) was lower under non-mulched locations than under mulched locations, irrespective of the irrigation treatment, while no significant differences in the SWC were observed in the deeper root zone (40–100 cm). The SWC in the shallow root zone was significantly higher for the high irrigation treatment (T1) than for the low irrigation treatment, while, again, no differences were observed in the deeper root zone. Simulations of two-dimensional SWC distributions revealed that the low irrigation treatment (T3) produced serious severe water stress (with SWCs near the wilting point) in the 30–40 cm part of the root zone, and that using separate drip emitter lines for each crop is well suited for producing the optimal soil water distribution pattern in the root zone of the intercropping field. The results of this study can be very useful in designing an optimal irrigation plan for intercropped fields.     

热风干燥对魔芋甘露聚糖含量的影响

应用二次正交旋转组合试验设计，研究了风温，风速，切片厚度３因素对魔芋甘露聚糖含量的影响，结果表明：（１）由试验研究所得到的数学模型可用于定量描述魔芋甘露聚糖在干制中的变化规律；（２）影响魔芋甘露聚糖变化的主因素效应为：风温〉片厚〉〉风速；（３）风温与片厚和风速与片厚的交互作用对魔芋甘露聚糖具有极其显著的影响；（４）魔芋甘露糖损失率最小的最佳干燥工艺参数为，风温７０℃，风速１．２ｍ／ｓ，切片厚度７ｍ     

论我国肉羊生产的前景及意义

虽然我们的羊肉在质量等到方面与国外有一定的差距,但也有我们自身的优势。生产成本、价格、劳动力资源等从地缘、竞争对手、进口国、出口价格等考虑,均有竞争优势,发展前景很好。     

玉米中耕除草复合导航系统设计与试验

为了实现玉米中耕除草过程中的自动导航作业,提高自动除草的效率和准确性,设计了一种玉米中耕除草复合导航系统。系统由基于GNSS的农机自动导航部分和基于机器视觉的农具自动导航部分组成,可通过GNSS位置信息进行农机自动导航,同时根据摄像头获取的玉米作物行信息控制农具铲刀进行行间除草。对农机的转向控制部分和前轮转角检测部分进行了机械改装,以PLC和步进电机驱动器为基础设计了农机转向控制电路和农具液压控制电路;以横向偏差和横向偏差变化率作为模糊控制的输入变量设计了自适应模糊控制方法;采用摄像头获取玉米作物行,通过扫描滤波方法进行作物行检测。农机独立导航除草试验和农机具复合导航试验结果表明：在车速为0.6 m/s时,农机自动导航最大横向偏差为10.04 cm,平均偏差为4.62 cm;农机具复合导航时的最大偏差为6.35 cm,平均偏差为2.73 cm;农机具复合导航系统能较好地满足玉米中耕除草的要求。     

变速恒频风力机组变桨距控制系统

在风力机空气动力学特性分析的基础上，讨论了变速恒频风力机组变桨距机构在低于额定风速阶段和高于额定风速阶段的不同控制策略。将模型与控制方法相结合的数字仿真表明，控制曲线与预期要求一致。具体设计了变桨距机构液压控制方案和电机控制方案，并提出了高油压冗余式电液比例变桨距机构的设计思路。     

PLC在农产品称量包装控制中的应用

设计用可编程序控制器(PLC)来控制农产品称量包装的自动化生产.同时,介绍了系统的构成及工作过程,给出了系统流程图及PLC控制梯形图以及提高精度的各项措施.该系统不仅线路简洁、可靠性高,而且较好地兼顾了动态称量的精度和速度,满足了在线快速动态称量包装的要求.     

Sensitivity analysis of optimal operation of irrigation supply systems with water quality considerations

A model for optimal operation of water supply/irrigation systems of various water quality sources, with treatment plants, multiple water quality conservative factors, and dilution junctions is presented. The objective function includes water cost at the sources, water conveyance costs which account for the hydraulics of the network indirectly, water treatment cost, and yield reduction costs of irrigated crops due to irrigation with poor quality water. The model can be used for systems with supply by canals as well as pipes, which serve both drinking water demands of urban/rural consumers and field irrigation requirements. The general nonlinear optimization problem has been simplified by decomposing it to a problem with linear constraints and nonlinear objective function. This problem is solved using the projected gradient method. The method is demonstrated for a regional water supply system in southern Israel that contains 39 pipes, 37 nodes, 11 sources, 10 agricultural consumers, and 4 domestic consumers. The optimal operation solution is described by discharge and salinity values for all pipes of the network. Sensitivity of the optimal solution to changes in the parameters is examined. The solution was found to be sensitive to the upper limit on drinking water quality, with total cost being reduced by 5% as the upper limit increases from 260 to 600 mg Cl l^–1. The effect of income from unit crop yield is more pronounced. An increase of income by a factor of 20 results in an increase of the total cost by a factor of 3, thus encouraging more use of fresh water as long as the marginal cost of water supply is smaller than the marginal decrease in yield loss. The effect of conveyance cost becomes more pronounced as its cost increases. An increase by a factor of 100 results in an increase of the total cost by about 14%. The network studied has a long pipe that connects two distinct parts of the network and permits the supply of fresh water from one part to the other. Increasing the maximum permitted discharge in this pipe from 0 to 200 m³ h^–1 reduces the total cost by 11%. Increasing the maximum discharge at one of the sources from 90 to 300 m³ h^–1 reduces the total cost by about 8%.