Quantitative trait loci for stomatal density and size in lowland rice

Genotypic variation in stomatal density and size has been reported but little is known of the genetic mechanisms behind these leaf traits. Using 101 recombinant inbred lines derived from a cross between a tropical japonica, IR69093-41-3-2-2 and an indica variety, IR72, we conducted a field study to determine stomatal density and size and identify quantitative trait loci (QTL) controlling these traits under lowland conditions. Ten QTLs for stomatal density and four QTLs for size were identified across growth stages and leaf surfaces (adaxial and abaxial). The contribution of each QTL to total phenotypic variation ranged from 9.3 to 15.2% for stomatal density and 9.7 to 14.3% for size. The allele from IR72 increased stomatal density and that from IR69093-41-3-2-2 increased size. The expression of the QTLs for stomatal density and size differed by growth stage indicating that these traits might be genetically controlled depending on growth stage or that each QTL had a different function by growth stage. Significant negative genetic correlations between stomatal density and size at both vegetative (r = −0.308**) and heading (r = −0.484**) stages were observed but no common QTL for these traits was detected across growth stages and leaf surfaces. These results indicate that the QTLs for density and size may neither be genetically linked nor pleiotropically controlled and findings can be used as basis for selection at the leaf level on the balance of carbon and water uptake. Further study is needed to fully understand the mechanism underlying the observed genetic association and to elucidate the function of the QTLs involved.     

Participatory varietal evaluation of open pollinated maize in Western Amhara,North-west Ethiopia

Open pollinated maize varieties are one of the best options for farmers who cannot afford the cost of hybrids, cultivating maize in low potential environments and cannot pay for inputs such as fertilizers and pesticides. The experiment was conducted to use farmers’ input and feedback on selection of well-adapted, high-yielding, and disease-tolerant maize varieties. Treatments were arranged incompletely randomized block design with three replications. Gibe-1 was better preferred open pollinated maize variety by famers due its cob length, disease tolerance, good husk cover and yield. Gibe-1 provided the highest grain yield in South Achefer (8.8 t ha^-1) and the best performing genotype across environments with grain yield of 7.8 t ha^-1. Gibe-1 also had a good reaction to common leaf rust and tercicum leaf blight. GGE biplot analysis classified testing environments in to four mega environments and showed high influence of the environment to grain yield with the contribution of variation 59.59% by the environment, 7.25% by the genotype, and 18.38% by interaction. Gibe-1 was identified as the most ideal open pollinated maize variety which produced the highest mean grain yield and was the most stable. Therefore, Gibe-1 is recommended as a potential open pollinated maize variety for Jabitehinan, South Achefer, and similar agro ecologies.     

Response of wheat growth and productivity to exogenous polyamines under lead stress

Polyamines [i.e. spermine (Spm), spermidine (Spd) and putrescine (Put)] antagonistic effects on stress imposed by 2.0 mM lead (Pb²⁺) on growth, yield and its components and changes in the osmoprotectant and endogenous Pb²⁺ concentrations, the contents of some nutrients and tissue health in wheat plants were evaluated. Under the three applied polyamine (PAs) applications, the efficiency of wheat plants to tolerate Pb²⁺ stress in terms of growth and yield characteristics was noticed to varying degrees. The enhancements in osmoprotectant concentrations and plant health [in terms of relative water content (RWC) and membrane stability index (MSI)], and reductions in electrolyte leakage (EL) and plant Pb²⁺ concentration were correlated with the reasonable growth of Pb²⁺-stressed plants and their grain yield. Results point out that, better growth and yield characteristics, MSI, RWC, leaf photosynthetic pigment and osmoprotectant concentrations, and nutrient contents were obtained with seed soaking in 0.25 mM Spm, 0.50 mM Spd or 1.0 mM Put than those generated with seed soaking in water under 2.0 mM Pb²⁺ stress. In contrast, EL and the concentration of endogenous Pb²⁺ were significantly reduced. However, the Pb²⁺-free control positively exceeded the all stressed treatments. Among all tested PAs, 1.0 mM Put showed the best results and thus is recommended, as seed soaking, for wheat to grow well under Pb²⁺ stress.     

‘Microbigation’: delivery of biological control agents through drip irrigation systems

The uniform and precise application of microbial particles close to the target organism and to the plant to be protected can increase the success of a biological control treatment. The use of systems or technologies which are usually available in agriculture could influence the acceptability of biocontrol agents by farmers, and enlarge the market. A pilot system was realized using dripper lines, drippers, filters and other tools commonly used in irrigation and precision agriculture in the greenhouse to evaluate their suitability for applying and distributing microbial biocontrol agents. Conidial suspensions of marketed or marketable agents were used, i.e. Fusarium oxysporum, F. solani, Trichoderma harzianum and Paecilomyces lilacinus. The experiments carried out demonstrated that conidial suspensions (10⁶ conidia ml⁻¹) can pass through the drippers without causing clogging, regardless of their size, and remained viable. The term ‘microbigation’ is here proposed for this kind of microbial application technique.     

Sensitivity analysis of optimal operation of irrigation supply systems with water quality considerations

A model for optimal operation of water supply/irrigation systems of various water quality sources, with treatment plants, multiple water quality conservative factors, and dilution junctions is presented. The objective function includes water cost at the sources, water conveyance costs which account for the hydraulics of the network indirectly, water treatment cost, and yield reduction costs of irrigated crops due to irrigation with poor quality water. The model can be used for systems with supply by canals as well as pipes, which serve both drinking water demands of urban/rural consumers and field irrigation requirements. The general nonlinear optimization problem has been simplified by decomposing it to a problem with linear constraints and nonlinear objective function. This problem is solved using the projected gradient method. The method is demonstrated for a regional water supply system in southern Israel that contains 39 pipes, 37 nodes, 11 sources, 10 agricultural consumers, and 4 domestic consumers. The optimal operation solution is described by discharge and salinity values for all pipes of the network. Sensitivity of the optimal solution to changes in the parameters is examined. The solution was found to be sensitive to the upper limit on drinking water quality, with total cost being reduced by 5% as the upper limit increases from 260 to 600 mg Cl l^–1. The effect of income from unit crop yield is more pronounced. An increase of income by a factor of 20 results in an increase of the total cost by a factor of 3, thus encouraging more use of fresh water as long as the marginal cost of water supply is smaller than the marginal decrease in yield loss. The effect of conveyance cost becomes more pronounced as its cost increases. An increase by a factor of 100 results in an increase of the total cost by about 14%. The network studied has a long pipe that connects two distinct parts of the network and permits the supply of fresh water from one part to the other. Increasing the maximum permitted discharge in this pipe from 0 to 200 m³ h^–1 reduces the total cost by 11%. Increasing the maximum discharge at one of the sources from 90 to 300 m³ h^–1 reduces the total cost by about 8%.     

Effects of water table management on soil salinity and alfalfa yield in a semi-arid climate

A lysimeter experiment was conducted to investigate the effect of water table management (WTM) on distribution of soil salinity and annual alfalfa (Medicago scutellata) yield. Subirrigations with three levels of water table namely, 0.5 (WT0.5), 0.7 (WT0.7), and 1.0 m (WT1.0) and a free drainage (FD) conventional irrigation treatment were selected for this study. All treatments were arranged in a complete randomized block design with three replicates. The results of this study indicated that the average soil electrical conductivity of the saturated extract (ECe) in the root zone gradually increased and exceeded the designated crop threshold value (4 dS/m) after the first forage harvest in subirrigated lysimeters. A higher salt accumulation was observed at the WT0.5 treatment. The average dry matter yield of annual alfalfa in WT0.5 and WT0.7 treatments was found to be 52 and 73% higher compared with the control treatment, respectively.     

Inheritance and relationships of important agronomic traits in almond

The inheritance of 16 important agronomic traits and its relationship were studied for four years in a population of 167 almond [P. dulcis (Mill.) D.A. Webb] seedlings obtained from a cross between the French selection ‘R1000’ (‘Tardy Nonpareil’ × ‘Tuono’) and the Spanish cultivar ‘Desmayo Largueta’. For some traits (blooming and leafing date) descendants segregated between the value of both progenitors, meanwhile for others the mean of the offspring was lower (bloom density, productivity and ripening date) or higher (in-shell/kernel ratio and double kernels). As expected, kernel bitterness and self-incompatibility behaved as monogenic traits. Some important correlations between traits were detected. The implications of the transmission and the correlation of these traits in the breeding programmes are discussed.     

Amplified fragment length polymorphism as a tool for molecular characterization of almond germplasm: genetic diversity among cultivated genotypes and related wild species of almond,and its relationships with agronomic traits

Amplified fragment length polymorphism (AFLP) analysis is a rapid and efficient method for producing DNA fingerprints and molecular characterization. Our objectives were to: estimate genetic similarities (GS), marker indices, and polymorphic information contents (PICs) for AFLP markers in almond cultivars; assess the genetic diversity of almond cultivars and wild species, using GS estimated from AFLP fingerprints and molecular characterization; and facilitate the use of markers in inter-specific introgression and cultivar improvement. The genetic diversity of 45 almond cultivars from Iran, Europe, and America, were studied assaying 19 primer combinations. In addition, several agronomic traits were evaluated, including flowering and maturity times, self-incompatibility, and kernel and fruit properties. Out of the 813 polymerase chain reaction fragments that were scored, 781 (96.23%) were polymorphic. GS ranged from 0.5 to 0.96, marker indices ranged from 51.37 to 78.79, and PICs ranged from 0.56 to 0.86. Results allowed the unique molecular identification of all assayed genotypes. However, the correlation between genetic similarity clustering as based on AFLP and clustering for agronomic traits was low. Cluster analysis based on AFLP data clearly differentiated the genotypes and wild species according to their origin and pedigree, whereas, cluster analysis based on agronomic data differentiated according the pomological characterization. Our results showed the great genetic diversity of the almond cultivars and their interest for almond breeding.     

Effects of high- vs. low-yield environments on selection for increased biomass yield in switchgrass

No information is available on the effects of different biomass yield environments on selection efficiency in switchgrass (Panicum virgatum L.) breeding improvement. This study was conducted to assess the effects of high- and low-biomass yield environments (HYE and LYE, respectively) on recurrent selection for general combining ability (RSGCA) in a lowland population of switchgrass (NL-94). The top 14 of 65 NL-94 C₀ parent plants were selected based on biomass yield of half-sib (HS) progeny tested for one post-establishment year under HYE and LYE conditions. Nine of the 14 C₀ parent plants were the same based on HS performance under HYE and LYE. Selected plants were intercrossed to produce NL-94 HYE and NL-94 LYE C₁ populations. One hundred and twenty-five HS C₁ progeny families (60 NL-94 HYE and 65 NL-94 LYE) were evaluated for biomass yield for 3 years (2002–2004) under HYE and LYE conditions. The HYE produced about 2.5 times higher biomass yields than the LYE in both C₀ and C₁ HS progeny tests. Estimated additive genetic variance and predicted gains from selection (ΔG) were high in the C₁ populations indicating that RSGCA should achieve higher biomass yields. Mean biomass yields of C₁ HS families originating from the LYE protocol were significantly higher than those of families originating from the HYE protocol in both HYE and LYE performance tests, suggesting greater selection response under LYE in the C₀ population. The estimates of narrow-sense heritability ( ) and ΔG from the C₁ populations indicate that positive response to selection for biomass yield is possible in subsequent cycles of selection under either HYE or LYE, with a possible small advantage for HYE.