Modeling soil water dynamics in a drip-irrigated intercropping field under plastic mulch

Intercropping, drip irrigation, and the use of plastic mulch are important management practices, which can, when utilized simultaneously, increase crop production and save irrigation water. Investigating soil water dynamics in the root zone of the intercropping field under such conditions is essential in order to understand the combined effects of these practices and to promote their wider use. However, not much work has been done to investigate soil water dynamics in the root zone of drip-irrigated, strip intercropping fields under plastic mulch. Three field experiments with different irrigation treatments (high T1, moderate T2, and low T3) were conducted to evaluate soil water contents (SWC) at different locations, for different irrigation treatments, and with respect to dripper lines and plants (corn and tomatoes). Experimental data were then used to calibrate the HYDRUS (2D/3D) model. Comparison between experimental data and model simulations showed that HYDRUS (2D/3D) described different irrigation events and SWC in the root zone well, with average relative errors of 10.8, 9.5, and 11.6 % for irrigation treatments T1, T2, and T3, respectively, and with corresponding root mean square errors of 0.043, 0.035, and 0.040 cm³ cm^?3, respectively. The results showed that the SWC in the shallow root zone (0–40 cm) was lower under non-mulched locations than under mulched locations, irrespective of the irrigation treatment, while no significant differences in the SWC were observed in the deeper root zone (40–100 cm). The SWC in the shallow root zone was significantly higher for the high irrigation treatment (T1) than for the low irrigation treatment, while, again, no differences were observed in the deeper root zone. Simulations of two-dimensional SWC distributions revealed that the low irrigation treatment (T3) produced serious severe water stress (with SWCs near the wilting point) in the 30–40 cm part of the root zone, and that using separate drip emitter lines for each crop is well suited for producing the optimal soil water distribution pattern in the root zone of the intercropping field. The results of this study can be very useful in designing an optimal irrigation plan for intercropped fields.     

Monitoring forage production for farmers’ decision making

Objective management of grazing livestock production systems needs monitoring of forage production at the managerial unit level. Our objectives were to develop a system that routinely estimates forage above-ground net primary production (ANPP) at the spatial and temporal resolution required by farmers in the Pampas of Argentina, and to facilitate adoption of the system by end users as a managerial support tool. Our approach was based on the radiation use efficiency (RUE) logic, which proposes that ANPP is determined by the amount of photosynthetically active radiation absorbed by the canopy (APAR), and the efficiency with which that energy is transformed in above-ground dry matter (radiation use efficiency, RUE). APAR is the product of incoming photosynthetically active radiation (PAR) and the fraction absorbed by the canopy (fPAR). We estimated fPAR as a non-linear function of MODIS normalized difference vegetation index (NDVI). RUE was empirically estimated for the two principal forage resources of the region, yielding the following relations: ANPP = 0.6 × APAR + 12, (R² = 0.86; p < 0.001; n = 18) for the upland sown pastures, and ANPP = 0.27 × APAR + 26, (R² = 0.74; p < 0.001; n = 18) for the lowland naturalized pastures, with ANPP in g/m²/60 days and APAR in MJ/m²/60 days. The models were able to predict independent ANPP values with acceptable accuracy. Computational procedures were automated and run in a Relational Data Base Manager System that stored and managed all the information. The system is currently monitoring 212,794 ha in 83 farms and provides monthly ANPP values for the previous month and a history of the last 6 years. The data so generated show ANPP differences between the two major forage resources, considerable variability of a given month’s ANPP among years and paddocks, and contrasting among-farm differences in the efficiency of conversion of ANPP and forage supplements into beef production. The system was well accepted by end users who utilize it mainly for making near real time decisions according to last month ANPP, and explaining results of previous production cycles by incorporating ANPP as an explicative variable. However, there were differences among farmers in the degree of utilization, apparently related to the advisor’s attitude toward this new technology. Our results indicate that (1) forage production of large extensions can be monthly monitored at the paddock level by a small laboratory with capabilities in geographic information systems, and (2) advisors and farmers apply this information to their managerial decisions.     

Measuring versus estimating net radiation and soil heat flux: Impact on Penman–Monteith reference ET estimates in semiarid regions

The standardized ASCE Penman–Monteith and FAO-56 equations were used to estimate reference evapotranspiration (ET₀) using estimated and measured net radiation (R_n) and soil heat flux (G), based on hourly and daily meteorological data. The estimates were evaluated against lysimeter measurements. The results indicate that using measured or estimated values of R_n and G can have significant effect on the accuracy of the ET₀ estimations, especially when calculations were made on an hourly basis. The FAO-56 version performed very well during the irrigation season on a daily basis. The use of measured R_n and G did not improve ET₀ estimation on a daily basis, therefore, the use of estimated R_n and G appears to be dependable when calculations are based on 24-h weather data. When daily ET₀ was calculated from hourly estimations, the results were different depending on the version used. The ASCE version was more accurate, especially when R_n and G were measured. Therefore, measurement of R_n and G may have potential to improve estimation only when daily ET₀ is calculated from hourly estimations. The PM FAO-56 version was always a little less accurate than the ASCE version. For hourly calculations, using a constant surface resistance (as in FAO-56 version), the PM method underpredicted for high evaporative demand and vice versa. The ASCE version performed better than PM FAO-56 version when R_n and G were measured and estimated. Therefore, ASCE version tended to provide quite accurate values of hourly ET₀, even using estimated values of R_n and G. As conclusion, the methods proposed by FAO-56 for estimating R_n and G tended to produce accurate estimates for daily and hourly ET₀ under semiarid conditions and can be used with some degree of confidence for estimating ET₀. In addition, results suggest that the ASCE standardized equation on an hourly basis improved the accuracy of ET₀ estimation with respect to the FAO-56 version.     

SIRIAS: a simulation model for sprinkler irrigation

Uniformity of distribution in irrigation systems plays an important role in the optimum use of irrigation water, with direct repercussions on water-use efficiency and production. To evaluate the effects of the wind on sprinkler water uniformity, it is necessary to measure infield water distribution under different wind conditions and then calculate the parameters that define water distribution. This paper perfects the SIRIAS simulation model for sprinkler systems, which can be used to design new irrigation installations or to improve existing ones. Using ballistic theory to simulate the trajectory of drops discharged by the sprinkler, the model obtains wind-distorted water distribution, with a new formulation for the air drag coefficient. It takes into account three options to distribute the evaporation and drift losses in the irrigation process. SIRIAS software has been programmed using Delphi language for Windows 95, 98 and NT.     

Artificial inoculation and susceptibility of Pinus armandii to Dothistroma septosporum

Dothistroma needle blight (DNB) is a serious needle disease of conifers that primarily affects pine species (Pinus spp.). Dothistroma septosporum is one of the DNB pathogens that has a diverse range of host species excluding Pinus armandii. In 15 inoculated P. armandii seedlings, D. septosporum acervuli were observed in 43 infected needles of ten seedlings with a mean disease severity of 1.11% at 25 weeks after inoculations, demonstrating the potential of D. septosporum to cause symptoms on the needles of P. armandii via artificial inoculation. The disease severity of P. armandii was similar to the positive control, Pinus nigra (median 0.75 for P. armandii to 0.70 for P. nigra), thus, P. armandii acts under artificial conditions as a susceptible host species.     

Multivariate analysis of invasive plant species distributions in southern US forests

Landscape Ecology - Invasive plants cause significant impacts in forested areas throughout the world. However, little is known about the relative importance of environmental drivers on the...     

Sediment production from unpaved roads in a sub-tropical dry setting — Southwestern Puerto Rico

The threat imposed by increased sediment loading rates ranks among the most important stressors affecting coral reef ecosystems worldwide. This study represents an effort to quantify the effects of unpaved roads on erosion rates in a dry sub-tropical area of Puerto Rico and is intended to aid in developing scientifically-based erosion mitigation strategies. Hence, the specific objectives of this study were to: (1) measure sediment production rates from unpaved roads; (2) evaluate the effect of precipitation, rainfall erosivity, slope, plot length, and vegetation cover on sediment production rates; and (3) compare measured sediment production rates to published surface erosion data from roaded and natural sites in the Eastern Caribbean. Sediment production from nine abandoned road segments with varying slopes and plot lengths were measured with sediment traps in southwestern Puerto Rico from August 2003 to September 2005.     

LED-Induced Chlorophyll Fluorescence Spectral Analysis for the Early Detection and Monitoring of Cadmium Toxicity in Maize Plants

Chlorophyll fluorescence spectral analysis permits detection, monitoring, and evaluation of abiotic stresses upon healthy plants using illumination of a light source in the UV?CVIS spectral range. This technique indirectly assesses the amount of physiological stress caused by photosynthetic damage, specifically damage to photosystem II, in plants. The objective of this study was to detect the toxicity of cadmium in maize plants via spectral analysis of chlorophyll fluorescence. The analysis is noninvasive and nondestructive and is used to follow the temporal evolution of changes in the chlorophyll content and physiological state of Zea mays L. seedlings under cadmium stress. Conventional techniques were also used to evaluate the dry matter production and Cd accumulation in plant leaves. Plants exhibited a notable reduction in dry matter production and chlorophyll levels with the administration of increasing doses of Cd in the nutrient solution. The fluorescence analysis was sensitive to changes caused by Cd in maize plants, detecting damage caused by different treatments before visual symptoms were observed. This technique has a practical application and produces rapid results that can be used in the evaluation of Cd-induced stress in plants and the detection of areas contaminated by this element.     

Flavor and quality characteristics of salted and desalted cod (Gadus morhua) produced by different salting methods

Flavor characterization and quality of salt-cured and desalted cod (Gadus morhua) products was studied using sensory analysis and gas chromatography techniques. The products were produced in Iceland using two different processing methods (filleting and splitting) and three different salting procedures, i.e., the old single-step kench salting or a multistep procedure, and presalting (injection and brine salting or only brine salting), which was followed by kench salting. The main difference observed was between fillets and split fish, where the split fish was darker and had stronger flavor characteristics. Comparison of different salting procedures showed that the use of presalting improved the appearance of the salted products, which can be described as increased lightness and reduced yellowness of the products. In the same products, the intensity of curing flavors was milder, as described by sensory analysis and key aroma compounds. Derivatives from lipid and protein degradation contribute to the characteristic flavor of the salted products.     

Atmospheric Mercury Fluxes in a Southern Boreal Forest and Wetland

Total gaseous mercury (TGM) fluxes from the forest floor and a boreal wetland were measured by a flux chamber technique coupled with an automatic mercury vapour analyser. The fluxes were measured at three sampling sites in southern Finland, 61°14′ N, 25°04′ E in summer 2007, with additionally in situ TGM concentrations in the air at one of the sites and mercury bulk deposition at another. Most of the flux data were collected during the daytime. At one of the sites, diurnal flux behaviour was studied, and a clear cycle with an afternoon maximum and a night minimum was observed. The highest emissions (up to 3.5 ng m⁻² h⁻¹) were observed at the forest floor site having a moss and grass cover. At the wetland and litter-rich forest floor sites, the emissions were below 1 ng m⁻² h⁻¹ and sometimes negative (down to −1.0 ng m⁻² h⁻¹), indicating mercury uptake. The measured average fluxes in August were 0.9 ± 1.1 and 0.2 ± 0.3 ng m⁻² h⁻¹ for the forest floor sites and wetland sites, respectively. The flux data were compared with the mercury bulk deposition, which proved to be of the same magnitude, but opposite in sign. At the mossy forest floor site, the extrapolated TGM emissions were 130% of the Hg deposition in August 2007. Comparison with other studies showed that the fluxes in background areas are relatively uniform, regardless of measurement site location and method used. Airborne TGM remained at the background level during the study, with an average value of 1.3 ± 0.2 ng m⁻³; it frequently showed a diurnal cycle pattern.