Effect of temperature and compression on the mechanical behavior of steam-treated wood

The mechanical behavior of steamed spruce wood changes dramatically with compression along the grain, the change being much more moderate perpendicular to the grain. The stiffness decrement due to increased temperature is greatest in the tangential material direction. The stiffness decrement due to compression is greatest along the grain. Compression to 80% compressive strain at 131°C inverts the order of the material directions regarding stiffness, the stiffness being the least along the grain. Plastic strain due to compression is greater at higher temperatures. The compression-induced decrement of stiffness along the grain is greater at higher temperatures, but the off-axis decrement of stiffness is less at higher temperatures.     

Assessing the influence of mechanical ventilation on blood gases and blood pressure in rattlesnakes

ObjectiveTo characterize the impact of mechanical positive pressure ventilation on heart rate (HR), arterial blood pressure, blood gases, lactate, glucose, sodium, potassium and calcium concentrations in rattlesnakes during anesthesia and the subsequent recovery period.Study designProspective, randomized trial.AnimalsTwenty one fasted adult South American rattlesnakes (Crotalus durissus terrificus).MethodsSnakes were anesthetized with propofol (15 mg kg⁻¹) intravenously, endotracheally intubated and assigned to one of four ventilation regimens: Spontaneous ventilation, or mechanical ventilation at a tidal volume of 30 mL kg⁻¹ at 1 breath every 90 seconds, 5 breaths minute⁻¹, or 15 breaths minute⁻¹. Arterial blood was collected from indwelling catheters at 30, 40, and 60 minutes and 2, 6, and 24 hours following induction of anesthesia and analyzed for pH, PaO₂, PaCO₂, and selected variables. Mean arterial blood pressure (MAP) and HR were recorded at 30, 40, 60 minutes and 24 hours.ResultsSpontaneous ventilation and 1 breath every 90 seconds resulted in a mild hypercapnia (PaCO₂ 22.4 ± 4.3 mmHg [3.0 ± 0.6 kPa] and 24.5 ± 1.6 mmHg [3.3 ± 0.2 kPa], respectively), 5 breaths minute⁻¹ resulted in normocapnia (14.2 ± 2.7 mmHg [1.9 ± 0.4 kPa]), while 15 breaths minute⁻¹ caused marked hypocapnia (8.2 ± 2.5 mmHg [1.1 ± 0.3 kPa]). Following recovery, blood gases of the four groups were similar from 2 hours. Anesthesia, independent of ventilation was associated with significantly elevated glucose, lactate and potassium concentrations compared to values at 24 hours (p < 0.0001). MAP increased significantly with increasing ventilation frequency (p < 0.001). HR did not vary among regimens.Conclusions and clinical relevanceMechanical ventilation had a profound impact on blood gases and blood pressure. The results support the use of mechanical ventilation with a frequency of 1–2 breaths minute⁻¹ at a tidal volume of 30 mL kg⁻¹ during anesthesia in fasted snakes.     

Why cuckoos should parasitize parrotbills by laying eggs randomly rather than laying eggs matching the egg appearance of parrotbill hosts?

The coevolutionary interaction between cuckoos and their hosts has been studied for a long time, but to date some puzzles still remain unsolved. Whether cuckoos parasitize their hosts by laying eggs randomly or matching the egg morphs of their hosts is one of the mysteries of the cuckoo problem. Scientists tend to believe that cuckoos lay eggs matching the appearance of host eggs due to selection caused by the ability of the hosts to recognize their own eggs.In this paper, we first review previous empirical studies to test this mystery and found no studies have provided direct evidence of cuckoos choosing to parasitize host nests where egg color and pattern match. We then present examples of unmatched cuckoo eggs in host nests and key life history traits of cuckoos, e.g. secretive behavior and rapid egg-laying and link them to cuckoo egg laying behavior. Finally we develop a conceptual model to demonstrate the egg laying behaviour of cuckoos and propose an empirical test that can provide direct evidence of the egg-laying properties of female cuckoos. We speculate that the degree of egg matching between cuckoo eggs and those of the host as detected by humans is caused by the ability of the hosts to recognize their own eggs, rather than the selection of matching host eggs by cuckoos. The case of Common Cuckoos(Cuculus canorus) and their parrotbill hosts(Paradoxornis alphonsianus), where it has been shown that both have evolved polymorphic eggs(mainly blue and white), was used to develop a conceptual model to demonstrate why cuckoos should utilize parrotbill hosts by laying eggs randomly rather than laying eggs matching the appearance of host eggs.In conclusion, we found no evidence for the hypothesis that cuckoos lay eggs based on own egg color matching that of the parrotbill-cuckoo system. We argue theoretically that laying eggs matching those of the hosts in this system violates a key trait of the life history of cuckoos and therefore should be maladaptive.     

Analysis of protein structures and interactions in complex food by near-infrared spectroscopy. 2. Hydrated gluten

Hydrated gluten, treated with various salts, was analyzed by near-infrared (NIR) spectroscopy to assess the ability of this method to reveal protein structure and interaction changes in perturbed food systems. The spectra were pretreated with second-derivative transformation and extended multiplicative signal correction for improving the band resolution and removing physical and quantitative spectral variations. Principal component analysis of the preprocessed spectra showed spectral effects that depended on salt type and concentration. Although both gluten texture and the NIR spectra were little influenced by treatment with salt solutions of low concentrations (0.1-0.2 M), they were significantly and diversely affected by treatment with 1.0 M salt solutions. Compared to hydration in water, hydration in 1.0 M sulfate salts caused spectral effects similar to a drying-out effect, which could be explained by salting-out.     

Homogenization conditions affect the oxidative stability of fish oil enriched milk emulsions: oxidation linked to changes in protein composition at the oil-water interface

Fish oil was incorporated into milk under different homogenization temperatures (50 and 72 degrees C) and pressures (5, 15, and 22.5 MPa). Subsequently, the oxidative stability of the milk and changes in the protein composition of the milk fat globule membrane (MFGM) were examined. Results showed that high pressure and high temperature (72 degrees C and 22.5 MPa) resulted in less lipid oxidation, whereas low pressure and low temperature (50 degrees C and 5 MPa) resulted in faster lipid oxidation. Analysis of protein oxidation indicated that especially casein was prone to oxidation. The level of free thiol groups was increased by high temperature (72 degrees C) and with increasing pressure. Furthermore, SDS-PAGE and confocal laser scanning microscopy (CLSM) indicated that high temperature resulted in an increase in beta-lactoglobulin adsorbed at the oil-water interface. This was even more pronounced with higher pressure. Less casein seemed to be present at the oil-water interface with increasing pressure. Overall, the results indicated that a combination of more beta-lactoglobulin and less casein at the oil-water interface gave the most stable emulsions with respect to lipid oxidation.     

Analysis of moniliformin in maize plants using hydrophilic interaction chromatography

A novel HPLC method was developed for detection of the Fusarium mycotoxin, moniliformin in whole maize plants. The method is based on hydrophilic interaction chromatography (HILIC) on a ZIC zwitterion column combined with diode array detection and negative electrospray mass spectrometry (ESI(-)-MS). Samples were extracted using acetonitrile-water (85:15), and the extracts were cleaned up on strong anion exchange columns. By this procedure we obtained a recovery rate of 57-74% moniliformin with a limit of detection at 48 ng/g and a limit of quantification at 96 ng/g using UV detection at 229 nm, which is comparable to current methods used. Limit of detection and quantification using ESI(-)-MS detection was 1 and 12 ng/g, respectively. Screening of maize samples infected with the moniliformin producing fungi F. avenaceum, F. tricinctum, or F. subglutinans detected moniliformin levels of 1-12 ng/g in 15 of 28 samples using ESI(-)-MS detection. To our knowledge this is the first example of HILIC separation in mycotoxin analysis.     

Phylogenetic analysis of the SSU rRNA gene from the piscine diplomonad Spironucleus torosus (Diplomonadida: Hexamitinae)

Previous studies have recorded Spironucleus torosus Poynton et Morrison, 1990 from several species of gadoid fishes, including the only freshwater gadoid, the burbot Lota lota (L.). Two morphologically different isolates of S. torosus have been described (elongate and pyriform). Both have been found in saltwater, while only the elongate has been found in freshwater. To address the conspecificity of the two morphs of S. torosus, and to identify the source of S. torosus in burbot in Norway, we have sequenced the small subunit ribosomal RNA (SSU rRNA) gene from 43 isolates of S. torosus from six species of gadoid fishes sampled at 15 localities in Norway, Sweden and the Baltic Sea. Phylogenetic analyses of the SSU rRNA gene sequence data recovered two major clades, one containing mainly isolates from burbot, while the other contained isolates from marine gadoid fishes only. The genetic distance (based on 25 nucleotide substitutions in 789 base pairs) separating the two assemblages was not large enough to consider the two groups separate species. Spironucleus torosus isolated from burbot displayed limited genetic variation in the small subunit ribosomal RNA (SSU rRNA) gene along the post-Pleistocene migration route of its host. The present study is the first report of S. torosus in tusk Brosme brosme (Ascanius), whiting Merlangius merlangus (L.), and fourbeard rockling Enchelyopus cimbrius (L.).     

Dispersal distances for airborne spores based on deposition rates and stochastic modeling

ABSTRACT A new modeling framework for particle dispersal is explored in the context of the particles being fungal spores dispersed within a field. The model gives rise to both exponentially decreasing and polynomially decreasing two-dimensional densities of deposited fungal spores. We reformulate the model in terms of time to deposition, and show how this concept is equivalent to the deposition rate for fungal spores. Special cases where parameter values for wind and gravitation lead to exponentially or polynomially decreasing densities are discussed, and formulas for one- and two-dimensional densities of deposited spores are given explicitly in terms of parameters for diffusion, wind, gravitation, and spore release height.     

Adoption of milk cooling technology among smallholder dairy farmers in Kenya

Factors influencing adoption of milk cooling technology were studied with data for 90 smallholder dairy farmers who were randomly selected from seven dairy cooperative societies in Kiambu County, Kenya. Logistic regression identified the age of the household head, daily household milk consumption, freehold land ownership, fodder production area, number of female calves, cooperative membership and cooperative services as significant factors influencing farmers’ willingness to invest in milk cooling technology. These findings offer an entry point for increased interventions by policy makers and various dairy sector stakeholders in promoting milk cooling technology with the aim of significantly reducing post-harvest losses and increasing the sector’s competitiveness.