播量对水稻生长发育及干物质积累的影响

用盆栽方法进行播量对寒地水稻生长发育及干物质积累影响试验,结果表明:稀播的秧苗发根力强、分蘖多、茎基宽、充实度高。播量200g/m2的产量最高。     

长吻帆蜥鱼作为生物采集器探究海洋中深层生物微塑料污染特征

海洋中深层生物作为链接海洋上层与深层食物网的媒介,对维系大洋生态系统结构和功能的稳定有着不可替代的重要作用。由于样品采集的困难性,针对中深层生物微塑料污染研究十分缺乏。长吻帆蜥鱼(Alepisaurus ferox)具有特殊的消化机制,是优秀的生物采集器。本研究利用激光红外成像光谱技术,量化分析了长吻帆蜥鱼胃中保存的中深层物种体内微塑料的丰度和理化特征。共采集中深层鱼类和头足类7种,其肠道中检测出微塑料146个,检出率85.71%,丰度为10.43 ± 12.12个/尾, 粒径为20.34~309.89 μm(47.36 μm ± 43.41 μm)。微塑料以颗粒状(59.58%)和碎片状(36.30%)为主,聚合物成分主要是丙烯酸酯共聚物(Acrylate copolymer),占比60.27%。本研究首次证明了长吻帆蜥鱼作为生物采集器开展海洋中深层生物微塑料污染研究的可行性,研究结果对解析大洋生态系统微塑料污染及其潜在生态风险具有重要意义。     

配筋混凝土砌块高层设计时应注意的几个问题

针对配筋混凝土砌块高层设计,提出砌块空腔墙的应用,注意合理设置水平配筋,配筋砌块深梁,控制底框房屋层间抗侧刚度比及高层墙体的裂缝问题.     

薄壁封闭环磨削回弹的建模与数值研究

提出了卡环制造过程中磨削回弹的计算模型。根据卡环的精度和啮合力要求,设计了特殊制造工艺。考虑弯曲残余应力,对磨削工序进行力学分析,提出了磨削回弹弯矩、磨削回弹后搭叠长度和啮合力变化的计算模型;开发了卡环制造辅助工艺系统——Shuttle,对卡环磨削工序进行了模拟,并结合实验讨论了磨削前后曲率半径、啮合力和搭叠长度随余量的变化规律。研究表明：随着磨削余量的增加,试样磨削前的啮合力增加,而磨削回弹后的啮合力呈下降趋势;试样磨削前后的搭叠长度均呈下降趋势,并且试样截面惯性矩越大,磨削回弹后试样的搭叠长度下降速度越慢;在各工序阶段,试样的曲率半径有不同程度的增加。     

Effect of stachyose supplementation on growth performance, nutrient digestibility and caecal fermentation characteristics in broilers

1. The objective of this study was to evaluate whether the oligosaccharide stachyose enhances gastrointestinal tract health by fermentation and proliferation of desirable bacteria species and thus affects growth performance and nutrient digestibility in broilers. 2. A total of 432 1-d-old male Arbor Acres (AA) broilers were randomly allocated to one of 6 treatments, with 12 replicate pens per treatment and 6 birds per pen. Chicks were fed a maize-hamlet protein 300 (HP300) basal diet with 0, 4.0, 8.0, 12.0 or 16.0 g/kg stachyose. A sixth diet contained no HP300 but soybean meal (SBM) and provided 8.7 g/kg stachyose and 3.1 g/kg raffinose. The duration of the study was 42 d. 3. Stachyose contents above 12.0 g/kg depressed group body weights, average daily gain and feed/gain but not feed intake during the whole experimental period. Broiler growth decreased linearly and quadratically with increasing stachyose content. No differences were detected between diets supplemented with 12.0 g/kg stachyose and SBM. 4. Nutrient digestibility tended to decrease but not significantly with increasing stachyose. 5. Stachyose content had no significant positive effects on caecal pH, microflora population and the resulting short-chain fatty acid (SCFA) metabolites during the 42 d experiment, with only butyrate differing significantly in the initial period.     

Dietary zinc concentration and lipopolysaccharide injection affect circulating trace minerals,acute phase protein response,and behavior as evaluated by an ear-tag–based accelerometer in beef steers

To assess plasma trace mineral (TM) concentrations, the acute phase protein response, and behavior in response to a lipopolysaccharide (LPS) challenge, 96 Angus cross steers (average initial body weight [BW]: 285 ± 14.4 kg) were sorted into two groups by BW (heavy and light; n = 48/group), fitted with an ear-tag–based accelerometer (CowManager SensOor; Agis, Harmelen, Netherlands), and stagger started 14 d apart. Consecutive day BW was recorded to start the 24-d trial (days −1 and 0). Dietary treatments began on day 0: common diet with either 30 (Zn30) or 100 (Zn100) mg supplemental Zn/kg DM (ZnSO₄). On day 17, steers received one of the following injection treatments intravenously to complete the 2 × 3 factorial: 1) SALINE (~2–3 mL of physiological saline), 2) LOWLPS: 0.25 µg LPS/kg BW, or 3) HIGHLPS: 0.375 µg LPS/kg BW. Blood, rectal temperature (RT), and BW were recorded on day 16 (−24 h relative to injection), and BW was used to assign injection treatment. Approximately 6, 24 (day 18), and 48 (day 19) h after treatment, BW, RT, and blood were collected, and final BW recorded on day 24. Data were analyzed in Proc Mixed of SAS with fixed effects of diet, injection, diet × injection; for BW, RT, dry matter intake (DMI), plasma TM, and haptoglobin-repeated measures analysis were used to evaluate effects over time. Area under the curve analysis determined by GraphPad Prism was used for analysis of accelerometer data. Body weight was unaffected by diet or injection (P ≥ 0.16), but there was an injection × time effect for DMI and RT (P < 0.05), where DMI decreased in both LPS treatments on day 16, but recovered by day 17, and RT was increased in LPS treatments 6 h post-injection. Steers receiving LPS spent less time highly active and eating than SALINE (P < 0.01). Steers in HIGHLPS spent lesser time ruminating, followed by LOWLPS and then SALINE (P < 0.001). An injection × time effect (P < 0.001) for plasma Zn showed decreased concentrations within 6 h of injection and remained decreased through 24 h before recovering by 48 h. A tendency for a diet × time effect (P = 0.06) on plasma Zn suggests plasma Zn repletion occurred at a greater rate in Zn100 compared to Zn30. These results suggest that increased supplemental Zn may alter the rate of recovery of Zn status from an acute inflammatory event. Additionally, ear-tag–based accelerometers used in this study were effective at detecting sickness behavior in feedlot steers, and rumination may be more sensitive than other variables.     

饲料中微量元素的测定

试验采用ICP-AES法和AAS法分别测定了饲料样品中微量元素Fe、Cu、Zn、Mn、Co的含量。两种测试方法结果接近,比较发现,ICP-AES法比AAS法具有较多优点,简单、快速、多元素可同时测定,检出限为0.0015~0.0756mg/kg,回收率为92%~106%。     

有益菌根真菌及其互作对带叶兜兰试管苗生理生长的影响

为探讨菌根真菌的互作效应,筛选协同互作模式组合,对从野生兜兰新鲜营养根中分离、筛选出的3种菌根真菌（PF02、PF06和PF07）,采用单菌接种、双菌混合接种和三菌混合菌种等7种接种方式,开展菌−苗共生培养,筛选出优势菌株PF02和PF07,揭示在实验室环境下接菌方式与接种效应之间的相互联系,分析菌根真菌互作对带叶兜兰植株生长和生理的影响。结果表明：显示菌根真菌互作对宿主植株的生物量、保护酶活性及叶绿素总量具有较好的正向效应。3种双菌混合接种方式PF02−PF06、PF02−PF07及PF06−PF07均能有效促进带叶兜兰生物量增长,尤其是PF02−PF06接种方式,抗氧化酶POD、超氧化物歧化酶SOD、过氧化氢酶CAT活性及叶绿素总量提高显著。选择优化的接种方式,以及能够协同促进、达到共生平衡的最佳接种方式组合,最大限度发挥菌根对宿主植物的益生作用。     

用H-Y抗血清对大鼠胚胎进行性别鉴定的研究

利用高度近交系大鼠的新生仔睾丸作抗原对处女大鼠进行免疫,制得 H-Y 抗血清.将同系大鼠的桑椹胚置于含有抗血清的培养液中体外培养5～6小时.结果表明其中部分胚胎能继续发育至囊胚(46.7%);另一部分胚胎停滞发育(53.3%),但解除抗体后重新恢复发育能力(34%).经胚胎移植后证明,前者约有79%发育为雌鼠,而后者约86%发育为雄鼠.由此可见,H-Y 抗血清对雄性胚胎具有特异性的抑制作用.用同样方法免疫远交系大鼠,所得抗血清不能对雄性胚胎产生抑制作用.     

NaCl胁迫对丁香‘瓷蓝’光合作用及叶绿素荧光的影响

为研究NaCl胁迫对丁香‘瓷蓝’光合作用的影响,以‘瓷蓝’的一年生扦插苗为试材,对不同浓度NaCl胁迫下‘瓷蓝’的叶绿素含量、光合特性及叶绿素荧光参数等进行研究。结果表明:盐胁迫使得光合性能降低,并且随着盐浓度的增加,叶绿素含量、光化学猝灭系数(q P)、PSⅡ的实际光化学效率(ΦPSⅡ)和PSⅡ最大光化学量子产量(Fv/Fm)呈下降趋势。非光化学猝灭系数(NPQ)呈先增加后下降趋势。光合速率下降的主要原因为气孔限制。‘瓷蓝’的耐盐范围在0.4%以下,在盐浓度低于0.4%时会通过提高非光化学猝灭系数(NPQ)来抵抗胁迫造成的伤害,当盐浓度高于0.4%时其光合机构受损严重,产生严重光抑制。