A new family of zero current and zero voltage switching pulse width modulation converters

A new family of zero current and zero voltage switching (ZC ZVS) pulse width modulation (PWM) converters was proposed, based on a new ZC ZVS PWM switch cell. The main switches operate at ZCS on and off, the auxiliary switches operate at ZVS on and off, and the passive semi conductor devices in the ZC ZVS converters operate at ZCS on and off. In addition to operating at constant frequency and reducing commutation losses, the new converters have no additional current stress or conduct loss in the main switch in comparison to hard switching converters. The principle of the new ZC ZVS PWM Boost converter was analyzed. The simulation results of the ZC ZVS PWM converter are provided to verify the performance of the new ZC ZVS PWM converters.     

A NEW COMPENSATIVE SNUBBER FOR ELIMINATING THE SURGE AND NOISE IN PWM CONVERTERS

A new compensative snubber is presented for eliminating the surge current and high frequency parasitic oscillation in rectified circuit of the PWM DC-DC converters. The output surge and noise voltages are de-creased over 4/5. The working principle of the sunbber is analyesd in detail, the designing formulas are derived. The theoretic analysis is consistent with the experimental results.     

The Stability Analysis of Single end Flyback Switching Power Supplies

Based on the research of a practical project for high hrequency high voltage switching power supplies,the state space average model as well as the transfer function of single end flyback converters,which can be used to analyze the stability of single end flyback switching power supplies,are established.     

Passive Lossless Forward Converter with Current Double Rectifier

To reset transformer excitation flux reliably,reduce the switching losses and improve influence of EMI noises in high frequency forward converters,several kinds of methods have been proposed,including RCD snubbers,active snubbersand resonant converters,and so on.These methods have many shortages.In consideration of these shortages,this paper puts forward a passive lossless forward converter with current double rectifier(CDR).The circuit does not require an extra switch or additional control circuit,and can resets the transformer excitation flux reliably,and does not include lossy components.So the circuit has higher reliability and higher performance/price ratios than above several kinds of methods. The paper analyzes the frame and operating principle of main circuit in detail.The key parameters design principles of the circuit are given.The simulation results confirm validity of the theoretical analysis results.     

The power-supply of X-ray machine adopting PID control and high-frequency inverter technology

To solve the problem of low control accuracy and low stability of current X-ray machines, a kind of digital power supply for X-ray machine is introduced. In the digital power supply, some key technologies are used to improve the output stability of the high frequency inverter, including improved BUCK circuit for voltage regulating circuit, high frequency inverter and soft switching technology for the high-voltage generator. The PWM control technology is used to control the switch transistor of voltage regulating circuit and inverter circuit, which makes the drive waveform output stable and easy to control. In order to improve the control accuracy, reduce the volume and change high voltage consecutively, the software PID of the microcomputer is used to control the feedback circuit. The high-accuracy power chip is used for the filament power supply to make the filament electric current stable. Through the analysis of the circuit, the parameters of the circuit are calculated and the circuit is simulated by PSPICE software. The results show that the theoretical analysis is consistent with the practical simulation results. The design can meet the requirement of the technology indices of the power supply of the X-ray machines.     

Research on a Novel Inverter of VSC

In order to improve waveform performance of light HVDC system, a lot of switches which operate in high frequency are used, which causes large switching losses and results high cost. A new Buck type voltage source converter(BVSC) is proposed. The new BVSC comprises a dual-buck converter and a three-phase inverter operating in grid frequency. Only two high frequency switches are used, which results good output waveform performance. In order to reduce the high frequency switching losses, a novel improved double-frequency Buck type voltage source converter(DBVSC) is also proposed. An additional dual-Buck converter is added to the BVSC, the added dual-Buck converter deals with the fundamental power that operates in low frequency, and BVSC only deals with harmonic power that operates in high frequency. The output waveform is enhanced and the switching losses are reduced in DBVSC, and the power rating is also increased. The DBVSC is very suitable for large power rating application. The one cycle control theory is adopted to control the proposed DBVSC with analog circuit, which is very simple. The proposed DBVSC and control method are verified by simulation.     

A charge balance control algorithm of dual-transistors forward converter

An algorithm is proposed for dual-transistors forward converter (DTFC) by using the principle of charge balance control during a transient process to improve their dynamic performance. Combined with response curve,the theoretical analysis and some key equations are presented to improve the dynamic performance of the DTFC by minimizing the over/under shoot and the recovery time. In order to avoid the magnetic saturation of the transformer,an approximate method is introduced in the calculation of the optimal switching time,which can also be applied to other isolated converters when the maximum duty cycle is limited. Finally,the simulation results and the experimental results of the prototype show that,compared with the traditional voltage mode control,the proposed algorithm can significantly improve the dynamic performance of DTFCs.     

Improvement and simulation on direct torque control system of permanent magnet synchronous motor

To solve the problems of large flux, torque ripple and inconstant inverter switching frequency in conventional direct torque control (DTC), a space vector modulation (SVM) technique is introduced to the conventional PMSM-DTC system and analyzed thoroughly based on the mathematical model. This novel control method which enjoys the advantages of VC and DTC has only one easy adjustable PI regulator and is easy to realize. The simulation verifies that this control system is capable of effectively improving the steady state performance and keeping the excellent dynamic performance of the PMSM-DTC system simultaneously and remain the switching frequency constant.     

An Approach of Pulse Waveform Integral to Modeling Resonant Converters

A novel approach to modelin8 resonant conventers, was presented in this paper.The variant subtopologies of a converfer are unified into an equiualent topology by the periodicpulse functions;Laplace transforms of the sampled function ,insteady of continuous ,of a small sig-nal variable are made;furthermore,the linear approximation is processed according to the differenttypes of converters, The conventional series and parallel converters are used as examples to discussthe principles of the approach. Finally the computer calcultion data is compared with the experiment results to con firm the models to be correct.     

Analysis,Modeling and Simulation of the Phase shift Full Bridge Zero-Voltage-Switched PWM Converter

Based on the analysis of the phase shift Full Bridge Zero Voltage Switched PWM Converter(FB ZVS PWM converter),a smal signal model is derived,and simulation results of frequency domain and time domain are given.[WT5HZ]     

Comparative study of aircraft three-phase power factor corrections

This paper summarizes the requirements of standards for aircraft power supply firstly,and then points out that the input current harmonic and output DC voltage ripple should be considered seriously when designing three-phase power factor correction (PFC)for aircraft under variable line frequency and unbalanced line supply. Based on reviewing the topologies for aircraft three-phase PFC,three typical topologies,i.e. three-phase pulse width modulation (PWM)rectifier,traditional shunt active power filter (APF)and generalized APF,are picked up. A unified single-phase equivalent model is developed for comparing the harmonic suppression performance of the three active PFC schemes. And the switching stress is also calculated for evaluating their efficiency and power density. Three 5 kW PFC are designed by employing each of the three selected schemes. Simulation is carried out to verify the correctness of the theoretical analysis. The theory and simulation results indicate that the generalized APF topology shows the most technical merit for aircraft three-phase PFC. Future research works on generalized APF are also pointed out,which are solving the uncontrollability of its DC output voltage and optimal designing the filter inductors.     

烟草烟碱转化株早期诱导鉴定的有效性研究

以白肋烟为材料研究了采用乙烯利处理对烟碱转化株进行早期鉴定的有效性以及取样时间和部位对鉴定效果的影响。结果表明,乙烯利处理早期鉴定的转化株包括了所有调制后自然形成的转化株,还可以鉴别出一些在正常晾制条件下不能有效鉴别的低转化株;早期测定的烟碱转化率一般高于烟叶自然晾制后的烟碱转化率,有利于提高鉴定的准确性和有效性。根据鉴定结果将非转化株、低转化株和高转化株分别自交留种,后代群体分别有8.6%,59.8%和100%的转化株,表明鉴定方法是有效的,且通过转化株的鉴别和清除可以对品种进行有效改良。对转化株的鉴定从苗期到开花前都可以进行,移栽后4~6周取样测定更利于大批量处理和检测。不同部位叶片都可用于早期诱导和鉴定,但下部叶诱导时间短,便于操作。     

Realization of Flash Stimulation with PWM in the Extraction of Visual Evoked Potential

Evoked EEG signal can be obtained by flash stimulation in the extraction of flash visual evoked potential(FVEP).Experiments show that the width,frequency and flash times of flash pulses will play key role for extracting FVEP.Aims at the feature of VEP extraction and its correlation factors,the flash stimulation method with pulse width modulation(PWM) technology has been discussed,and the realization methods based on hardware and software are studied,then the output of precise PWM with special integrated circuit is realized.So the parameters of flash stimulation can be adjusted based on the material conditions of FVEP extraction,then VEP can be extracted effectively.Experiments show that it is of better effectiveness for FVEP extraction by using the method based on the output of precise PWM to control the flashing stimulation.     

Single-end Flyback High-frequency High-voltage Switching Power Supplies

Based on the research of a practical project of high frequency high voltage switching power supplies,the system design and experimental investigation of a single end flyback high frequency high voltage switching power supply are presented. In order to solve the problem of durable voltage of power MOSFETs that are used in the single end flyback high voltage switching power supply,an effective approach that adopts dual MOSFETs in series connected is proposed.The procedure of the designing and the parameter of each device is given in detail.A prototype of 220 Volt input and 2000V/3mA output is developed, and the validity of the scheme is demonstrated by the experiment.     

One-cycle Control Three-phase Four-wire Active Power Filter with Four-arm

This paper presents a three-phase four - wire active power filter based on one-cycle control. This method need not sense the three phase load currents or the three phase voltages, need not use any multipliers. It has simplified circuit , and the controller is composed of four integrators with reset along with several flip-flops, comparators and some analog components. The main circuit switching frequency is constant, which is desirable for industrial applications. Analysis and simulation are carried out with the four-arm inverter, the simulation results verify that the APF with one-cycle control can dynamically and effectually compensate the harmonics, reactive current and zero sequence current.     

Alleviating Bus Voltage Stress in Single Stage Power Factor Correction Converters

High DC bus voltage stress is an important issue for the single stage PFC converters in practical application. This paper analyzes the inherent reason of the high bus voltage stress of single-stage power-factor-correction (PFC) AC/DC converters. Four possible resolving schemes are analyzed and discussed, and some of practical implementation circuits topologies are also given. Theoretical analysis and simulation results show that the both series-charging, parallel-discharging capacitors (SCPDC) scheme and bus-voltage-feedback (BVF) method are deemed to be more viable than the other two methods.     

Topology Analysis of Phase-shifted Full-bridge Soft-switching Converter

Phase-shifted full-bridge(FB) soft-switching converters are developing form the basic phase-shifted FB-ZVS-PWM converter to phase-shifted FB-ZVZCS-PWM converter and phase-shifted FB-ZCS-PWM converter,to a series of the other new phase-shifted full-bridge circuits,which make up of the converters with developmental and useful foreground.The topology structures,operation characteristics,as well as their merits and demerits are compared and analyzed.The improved phase-shifted FB-ZVS-PWM converter enlarge the load range of ZVS in lag-arm.Phase-shifted FB-ZVZCS-PWM converter solves the problem mentioned above,and insulated gate bipolar transistor(IGBT) is fit for the lag-arm.Phase-shifted FB-ZCS-PWM converter could achieve ZCS in every power tube,and is used in high-power occasion.What's more,the developmental trend of soft-switching converting technic without resonance network is pointed out.     

Analysis of Loosely Coupled Inductive Power Transfer System

In LCIPT system, the selection of system operation frequency has a relationshi Pwith the cost and power transfer capability of the power supply. Due to the development of Power device and system efficiency requirement , it is restricted to increase the system operation frequency . This paper presentes a topology which transfers power through LC oscillation. When the voltage of the capacitor is less than reference voltage, the switch is turned off and the capacitor is charged, which makes the switching frequency far less than the syntonic frequency. Thus the system efficiency is improved, and the system cost is reduced. This is verified by the time domain and frequency domain simulations of Saber. This topology not only can be used in LCIPT, but also in other convertors.     

模糊控制系统的垂直切换判决算法分析

针对模糊控制系统中切换时延较长和切换次数较多的问题,研究了一种基于模糊控制系统的垂直切换判决算法。在基于信号强度判决时将RSS作为门限值,提高系统判决能力;同时,将网络参数和服务类型作为判决因素,结合层次分析法引入并行的模糊控制系统,缩短了切换判决的时间、选择适合用户的最佳网络,做出垂直切换。仿真结果表明,该算法减少了切换次数,降低了切换时延,增强了系统的性能。与传统的切换算法相比较,该算法对切换的判决因素考虑的更全面,兼顾了用户终端的使用环境及成本问题,有效地保证了网络的服务质量。     

Numerical Simulation in Flow Field of CNG Vehicle Catalytic Converters

The steady flow in the catalytic converters of CNG was simulated. The gas can breakaway in the entering pipe and the flow of the gas can convergence well in the exhaust pipe. The flow distributing mainly depends on the flow capability of the expanding pipe. The pressure falls apparently in the carrier of catalytic converters. The noble metals in the center of the catalytic converters are consumed more quickly than the edge zone.