Herpesvirus antigens on cell membranes detected by centrifugation of membrane-antibody complexes

Herpesviruses specify new glycoproteins that bind to cell membranes and also appear in the envelope of the virion. Incubation of purified smooth membranes from infected cells with antiviral antibody results in an increase in the density of the membranes as determined by flotation in sucrose density gradients. The magnitude of this increase depends on the amount of antibody used; densities as high as 1.16 grams per cubic centimeter have been obtained (the density of the untreated membranes is 1.08 grams per cubic centimeter). Antiviral antibody does not increase the density of uninfected cell membranes nor do saline or normal rabbit serum change the densities of infected or uninfected cell mnembranes. Viral antigens-presumably the glycoproteins specified by the virus-are probably on the surface of the infected cell membranes and bind to them strongly enough to withstand the hydrodynamic forces applied to them in the sucrose gradient.     

Lunar surface material: spacecraft measurements of density and strength

The relation of the density of the lunar surface layer to depth is probably best determined from spacecraft measurements of the bearing capacity as a function of depth. A comparison of these values with laboratory measurements of the bearing capacity of low-cohesion particulate materials as a function of the percentage of solid indicates that the bulk density at the lunar surface is about 1.1 grams per cubic centimeter and that it increases nearly linearly to about 1.6 grams per cubic centimeter at a depth of 5 centimeters.     

Quenchable high-pressure polymorph of zinc selenate

A new quenchable high-pressure form of zinc selenate (ZnSeO(4)) was produced by subjecting the low-pressure modification to 40 kilobars at 400 degrees C for 30 minutes. The new form is orthorhombic, space group D(2h),(17)-Cmcm. The cell constants at 29 degrees C are: a, 5.511 angstroms; b, 8.110 angstroms; and c, 6.585 angstroms. The calculated density is 4.70 grams per cubic centimeter in comparison with 4.61 grams per cubic centimeter for the low-pressure modification. This implies a volume change of 2 percent at the transition.     

Designed synthesis of 3D covalent organic frameworks

Three-dimensional covalent organic frameworks (3D COFs) were synthesized by targeting two nets based on triangular and tetrahedral nodes: ctn and bor. The respective 3D COFs were synthesized as crystalline solids by condensation reactions of tetrahedral tetra(4-dihydroxyborylphenyl) methane or tetra(4-dihydroxyborylphenyl)silane and by co-condensation of triangular 2,3,6,7,10,11-hexahydroxytriphenylene. Because these materials are entirely constructed from strong covalent bonds (C-C, C-O, C-B, and B-O), they have high thermal stabilities (400 degrees to 500 degrees C), and they also have high surface areas (3472 and 4210 square meters per gram for COF-102 and COF-103, respectively) and extremely low densities (0.17 grams per cubic centimeter).     

The Inner Core Translational Triplet and the Density Near Earth's Center

Four long records from superconducting gravimeters yield evidence of the triplet of translational oscillations of the solid inner core about its central position. Calculations of core oscillation modes allow identification of the three translational resonances at periods of 3.5820 +/- 0.0008, 3.7677 +/- 0.0006, and 4.015 +/- 0.001 hours by their rotational splitting. Each resonance is defined by approximately 20 successive spectral estimates. A new Earth model brings the computed periods into agreement with observation. It has a central density of 12.960 grams per cubic centimeter, inner core radius of 1221.1 kilometers, and a density jump at the inner core boundary of 0.407 grams per cubic centimeter.     

Atmospheric particulates: specific surface areas and densities

Suspended particulates in Pittsburgh air were collected on glass-fiber filters. The specific surface areas of particulates brushed from the filter surface varied from 1.55 to 4.51 square meters per gram when measured by the Brunauer-Emmett-Teller (BET) method with nitrogen and krypton, after 8-hour degassing of the samples at 25 degrees C. Specific surfaces of the same samples varied from 4.3 to 8.00 square meters per gram after 4-hour degassing at 200 degrees C. Bulk densities and densities of samples were 0.49 to 0.64 and 2.0 to 2.6 grams per cubic centimeter, respectively. These data provide some basis for explanation of unpredictable responses reported after inhalation of mixtures of pollutant gases and particles by animals and man; they should also assist in interpretation of gas-solid phase reactions in the atmosphere.     

A New Dense Form of Solid Germanium

A new form of solid germanium, of greater density than ordinary cubic germanium, can be formed by compressing cubic germanium at pressures exceeding 120 kilobars and reducing the pressure back to that of the atmosphere. The crystal structure is tetragonal, with a equal to 5.93 angstroms and c, to 6.98; 12 atoms per unit cell; and theoretical density, 5.91 grams per cubic centimeter. Electrically it behaves like a semiconductor. At temperatures above 200 degrees C it reverts rather rapidly to the cubic form.     

"C"-type viral particles in plasma of cats with feline leukemia

Linear sucrose-density gradient was used to detect and isolate typical "C"-type viral particles in plasma of cats with spontaneous and experimentally induced leukemia. The density of the agent is similar to known murine leukemia virus (1.15 to 1.17 grams per cubic centimeter). In the electron microscope the virus showed typical "C"-type particle morphology with various maturation stages. The maximum diameter of the mature viral particles in plasma was 115 millimicrons, a diameter slightly larger than budding particles observed in tissue. Leukemia was transmitted with cellular and cell-free inoculum after a 5-week period of latency.     

Superdense water ice

A new allotropic form of water ice with a density of 2.32 +/- 0.15 grams per cubic centimeter has been observed at very low pressures and for temperatures lower than 100 degrees K. It is most likely amorphous.     

Images of asteroid 21 Lutetia: a remnant planetesimal from the early Solar System

Images obtained by the Optical, Spectroscopic, and Infrared Remote Imaging System (OSIRIS) cameras onboard the Rosetta spacecraft reveal that asteroid 21 Lutetia has a complex geology and one of the highest asteroid densities measured so far, 3.4 ± 0.3 grams per cubic centimeter. The north pole region is covered by a thick layer of regolith, which is seen to flow in major landslides associated with albedo variation. Its geologically complex surface, ancient surface age, and high density suggest that Lutetia is most likely a primordial planetesimal. This contrasts with smaller asteroids visited by previous spacecraft, which are probably shattered bodies, fragments of larger parents, or reaccumulated rubble piles.     

Amorphous ice: density and reflectivity

Amorphous ice prepared under a wide range of conditions has a density, determined from its buoyancy in liquid oxygen, of 0.94+/-0.02 gram per cubic centimeter, the same as that of ordinary hexagonal ice, with no indication of the glassy superdense ice (2.32 grams per cubic centimeter) reported recently. The diffuse reflectivity shows a small increase as the ice crystallizes at 153 degrees K. This increase is followed by a much larger increase (probably associated with crystal growth) as the sample warms, and the reflectivity reaches a maximum well below the melting temperature. Although the ice deposits appear translucent, the specular reflectivity is low, thus indicating a dull rather than a glassy surface.     

Ultragiant urban aerosol particles

Measurements taken 300 meters above ground level show surprisingly high concentrations of ultragiant aerosol particles both upwind and downwind of the St. Louis, Missouri, urban area. Assuming an average particle density of 2.0 grams per cubic centimeter, concentrations of particles with diameters between 5 and 55 micrometers sampled on 11 different days averaged 31 micrograms per cubic meter upwind and 55 micrograms per cubic meter downwind of the city.     

Anomalous water: attempts at high-pressure synthesis

The high density, 1.4 grams per cubic centimeter, reported for anomalous water suggests that high pressures should be conducive to the formation of anomalous water. Six attempts at 60 kilobars in which water was cooled from about 600 degrees C in nickel or platinum tubes, with or without the presence of silica, did not produce any detectable amounts of anomalous water.     

Carbon: A New Crystalline Phase

The electrical resistance of single crystal graphite shows a very sharp increase at above 150 kilobars, accompanied by a drifting upward with time. The behavior is typical of a first-order phase transition, and is irreversible. X-rays on the material after removal from the cell show lines of a new material with a structure which can be indexed as a cubic lattice with a unit cell edge of 5.545 angstroms. The density of the new phase is estimated at 2.80 grams per cubic centimeter.     

Observations of Hydrogen at Room Temperature (25{degrees}C) and High Pressure (to 500 Kilobars)

Hydrogen becomes a solid at 25 degrees C when subjected to a pressure of 57 kilobars. The high-pressure phase appears as a transparent crystalline mass. The refractive index of the high-pressure phase increases sharply with pressure, indicating a density increase of similar magnitude. At 360 kilobars the calculated density of the high-pressure phase is 0.6 to 0.7 grams per cubic centimeter.     

Electrical Transport Properties of Undoped CVD Diamond Films

Polycrystalline diamond films synthesized by microwave-assisted chemical vapor deposition (MACVD) were examined with transient photoconductivity, and two fundamental electrical transport properties, the carrier mobility and lifetime, were measured. The highest mobility measured is 50 centimeters squared per volt per second at low initial carrier densities (<10(15) per cubic centimeter). Electron-hole scattering causes the carrier mobility to decrease at higher carrier densities. Although not measured directly, the carrier lifetime was inferred to be 40 picoseconds. The average drift length of the carriers is smaller than the average grain size and appears to be limited by defects within the grains. The carrier mobility in the MACVD films is higher than values measured in lower quality dc-plasma films but is much smaller than that of single-crystal natural diamond.     

Density-modulus relationship in graphite fibers made from acrylic yarns

Three types of polyacrylonitrile yarn were converted to graphite fibers. There was a linear relation between density and Young's modulus of the graphite fibers, the ranges observed being 1.58 to 2.18 grams per cubic centimeter and 25 to 112 x 10(6) pounds per square inch.     

The suboceanic mantle

An independent determination of density in the suboceanic lithosphere gives 3.5 to 3.6 grams per cubic centimeter at a depth of about 100 kilometers. This high value implies the existence of an ecologitic facies. A mechanism is proposed in which eclogite fractionation from the underlying, partially molten asthenosphere plays a key role in the creation and the spreading of the rigid, lithospheric plate.     

Strength-density relations in particulate silicates of complex shape and their possible lunar significance

Some terrestrial particulate silicate rocks with complex particle shapes have internal friction angles over 45 degrees and cohesion of about 0.1 newton per square centimeter at bulk densities of 0.6 to 0.8 gram per cubic centimeter. Mechanical and other properties of the lunar surface layer, observed with spacecraft, may be consistent with a low bulk density and complex reentrant shapes for the fine particles.     

Mercury: results on mass, radius, ionosphere, and atmosphere from mariner 10 dual-frequency radio signals

Analysis of the radio-tracking data from Mariner 10 yields 6,023,600 +/- 600 for the ratio of the mass of the sun to that of Mercury, in very good agreement with values determined earlier from radar data alone. Occultation measurements yielded values for the radius of Mercury of 2440 +/- 2 and 2438 +/- 2 kilometers at laditudes of 2 degrees N and 68 degrees N, respectively, again in close agreement with the average equatorial radius of 2439 +/- 1 kilometers determined from radar data. The mean density of 5.44 grams per cubic centimeter deduced for Mercury from Mariner 10 data thus virtually coincides with the prior determination. No evidence of either an ionosphere or an atmosphere was found, with the data yielding upper bounds on the electron density of about 1500 and 4000 electrons per cubic centimeter on the dayside and nightside, respectively, and an inferred upper bound on the surface pressure of 10(-8) millibar.