Simulated rainfall evaluation of revegetation/mulch erosion control in the Lake Tahoe basin: 2. Bare soil assessment

Slopes that have been disturbed through roadway, ski slope or other construction often produce more sediment than less disturbed sites. Reduction or elimination of sediment loading from such disturbed slopes to adjacent streams is critical in the Lake Tahoe basin. Here, use of a portable rainfall simulator (RS), described in the first paper of this series, is used to evaluate slope effects on erosion from bare volcanic and granitic soils (road cut and ski run sites) common in the basin in order to establish a basis upon which revegetation treatment comparisons can be made. Rainfall simulations (60 mm h⁻¹, approximating a 100‐year, 15‐minute storm) at each site included multiple replications of bare soil plots as well as some adjacent ‘native’, or relatively undisturbed soils below trees where available. Field measurements of time to runoff, infiltration, runoff, sediment discharge rates, and average sediment concentration were obtained. Laboratory measurements of particle‐size distributions using sieve and laser counting methods indicated that the granitic soils had larger grain sizes than the volcanic soils and that road cut soils of either type also had larger grain sizes than their ski run counterparts. Particle‐size‐distribution‐based estimates of saturated hydraulic conductivity were 5–10 times greater than RS‐determined steady infiltration rates. RS‐measured infiltration rates were similar, ranging from 33–50 mm h⁻¹ for disturbed volcanic soils and 33–60 mm h⁻¹ for disturbed granitic soils. RS‐measured runoff rates and sediment yields from the bare soils were significantly correlated with plot slope with the exception of volcanic road cuts due to the narrow range of road cut slopes encountered. Sediment yields from bare granitic soils at slopes of 28 to 78 per cent ranged from ∼1 to 12 g m⁻² mm⁻¹, respectively, while from bare volcanic soils at slopes of 22 to 61 per cent they ranged from ∼3 to 31 g m⁻² mm⁻¹, respectively. Surface roughness did not correlate with runoff or erosion parameters, perhaps also as a result of a relatively narrow range of roughness values. The volcanic ski run soils and both types of road cut soils exhibited nearly an order of magnitude greater sediment yield than that from the corresponding native, relatively undisturbed, sites. Similarly, the granitic ski run soils produced nearly four‐times greater sediment concentration than the undisturbed areas. A possible goal of restoration/erosion control efforts could be recreation of ‘native’‐like soil conditions. Copyright © 2005 John Wiley & Sons, Ltd.     

Simulated rainfall evaluation of revegetation/mulch erosion control in the Lake Tahoe Basin—1: method assessment

Revegetation of road cuts and fills is intended to stabilize those drastically disturbed areas so that sediment is not transported to adjacent waterways. Sediment has resulted in water quality degradation, an extremely critical issue in the Lake Tahoe Basin. Many revegetation efforts in this semiarid, subalpine environment have resulted in low levels of plant cover, thus failing to meet project goals. Further, no adequate physical method of assessing project effectiveness has been developed, relative to runoff or sediment movement. This paper describes the use of a portable rainfall simulator (RS) to conduct a preliminary assessment of the effectiveness of a variety of erosion‐control treatments and treatment effects on hydrologic parameters and erosion. The particular goal of this paper is to determine whether the RS method can measure revegetation treatment effects on infiltration and erosion. The RS‐plot studies were used to determine slope, cover (mulch and vegetation) and surface roughness effects on infiltration, runoff and erosion rates at several roadcuts across the basin. A rainfall rate of ≈60 mm h⁻¹, approximating the 100‐yr, 15‐min design storm, was applied over replicated 0·64 m² plots in each treatment type and over bare‐soil plots for comparison. Simulated rainfall had a mean drop size of ≈2·1 mm and approximately 70% of ‘natural’ kinetic energy. Measured parameters included time to runoff, infiltration, runoff/infiltration rate, sediment discharge rate and average sediment concentration as well as analysis of total Kjeldahl nitrogen (TKN) and dissolved phosphorus (TDP) from filtered (0·45 μm) runoff samples. Runoff rates, sediment concentrations and yields were greater from volcanic soils as compared to that from granitic soils for nearly all cover conditions. For example, bare soil sediment yields from volcanic soils ranged from 2–12 as compared to 0·3–3 g m⁻² mm⁻¹ for granitic soils. Pine‐needle mulch cover treatments substantially reduced sediment yields from all plots. Plot microtopography or roughness and cross‐slope had no effect on sediment concentrations in runoff or sediment yield. RS measurements showed discernible differences in runoff, infiltration, and sediment yields between treatments. Runoff nutrient concentrations were not distinguishable from that in the rainwater used. Copyright © 2004 John Wiley & Sons, Ltd.     

Runoff sediment particle sizes associated with soil erosion in the Lake Tahoe Basin,USA

Runoff sediment from disturbed soils in the Lake Tahoe Basin has resulted in light scattering, accumulation of nutrients, and subsequent loss in lake clarity. Little quantified information about erosion rates and runoff particle‐size distributions (PSDs) exists for determining stream and lake loading associated with land management. Building on previous studies using rainfall simulation (RS) techniques for quantifying infiltration, runoff, and erosion rates, we determine the dependence and significance of runoff sediment PSDs and sediment yield (SY, or erodibility) on slope and compare these relationships between erosion control treatments (e.g., mulch covers, compost, or woodchip incorporation, plantings) with bare and undisturbed, or ‘native’ forest soils. We used simulated rainfall rates of 60–100 mm h⁻¹ applied over replicated 0·64 m² plots. Measured parameters included time to runoff (s), infiltration and runoff rates (mm h⁻¹), SY (g mm⁻¹ runoff), and average sediment concentration (SC, g L⁻¹) as well as PSDs in runoff samples. In terms of significant relationships, granitic soils had larger particle sizes than volcanic soils in bulk soil and runoff samples. Consequently, runoff rates, SCs, and SYs were greater from bare volcanic as compared to that from bare granitic soils at similar slopes. Generally, runoff rates increased with increasing slope on bare soils, while infiltration rates decreased. Similarly, SY increased with slope for both soil types, though SYs from volcanic soils are three to four times larger than that from granitic soils. As SY increased, smaller particle sizes are observed in runoff for all soil conditions and particle sizes decreased with increasing slope. Copyright © 2008 John Wiley & Sons, Ltd.