Maximum effective lumen and pit pore sizes of the earlywood and the latewood of never dried loblolly pine sapwood

Summary Measurements of the air pressure required to initially displace a saturating liquid and allow a slow continuous stream of air bubbles to pass through wood cross sections of different thickness, together with the equilibrium surface tension of the saturating liquid, make it possible to calculate the maximum effective opening radii. Previous measurements were made for wood as a whole over complete annual rings. Measurements reported here were made separately for earlywood and latewood. Extrapolating plots of the maximum effective opening radius-cross section thickness, for thicknesses below the maximum fiber length, to zero thickness gave maximum lumen radii of 16 m for the earlywood and 10.3 m for the latewood. The values are only slightly greater than the calculated average values. Extrapolating the plots in the opposite direction to zero opening radius gave approximate maximum lumen or fiber lengths for the earlywood of 6 mm and for the latewood of 5 mm. The maximum effective opening radii for cross sections thicker than the maximum fiber length give maximum effective communicating pore radii. These values continue to decrease, with increasing thickness of the cross sections due to the decreasing probability of the largest openings falling in any one series path through the structures. The maximum effective pit pore radius for passage through fifty pits in series was 0.8 m for the earlywood and 0.28 m for the latewood.Paper No. 3787 of the Journal Series of North Carolina State University Agricultural Experiment Station, Releigh, N. C.