| 基于废弃混纺纤维的花盆复合材料的成型工艺 |
| |
| 引用本文： | 王伟,于永玲,吕丽华.基于废弃混纺纤维的花盆复合材料的成型工艺[J].安徽农业科学,2011,39(31):19610-19612. |
| |
| 作者姓名： | 王伟 于永玲 吕丽华 |
| |
| 作者单位： | 大连工业大学绿色纤维应用技术研究所,辽宁大连,116034 |
| |
| 基金项目： | 辽宁省教育厅创新团队项目（2006T027） |
| |
| 摘 要： | 目的]研究不同工艺参数对花盆复合材料力学性能的影响。方法]以拉伸强度、冲击强度为主要指标,采用正交及单因素试验对成型工艺进行优化。结果]最优成型工艺条件为：热压温度185℃、热压压力12 MPa、热压时间9 min;该条件下的花盆复合材料的拉伸强度为68.76 MPa,冲击强度为9.13 KJ/m。结论]为废弃纺织纤维复合材料的扩大应用提供了依据。
|
| 关 键 词： | 混纺纤维 复合材料 成型工艺 拉伸强度 冲击强度 |
Molding Process of Flowerpot Composite Materials Based on Waste Blended Fibers |
| |
| Institution: | WANG Wei et al(Green Fiber Application Technology Research Institute,Dalian Polytechnic University,Dalian,Liaoning 116034) |
| |
| Abstract: | Objective] The aim was to study the influence of different process parameters on the mechanical properties of flowerpot composite materials.Method] Through taking tensile strength and impact strength as the main indexes,orthogonal experiment and single factor experiment were used to optimize the molding process.Results] The optimal molding process conditions were as follows: hot pressing temperature was 185 ℃,hot pressing pressure was 12 MPa and hot pressing time was 9 min;under these conditions,tensile strength was 68.76 MPa and impact strength was 9.13 KJ/m.Conclusion] This research provided references for the expanding application of waste fiber composite materials. |
| |
| Keywords: | Blended fibers Composite materials Molding process Tensile strength Impact strength |
| 本文献已被 维普 万方数据 等数据库收录！ |
|
