| 基于CFD技术脱硫泵的设计与试验 |
| |
| 引用本文： | 刘建瑞,肖志杰,王鸿睿,滕人博. 基于CFD技术脱硫泵的设计与试验[J]. 排灌机械, 2009, 27(1): 6-9 |
| |
| 作者姓名： | 刘建瑞 肖志杰 王鸿睿 滕人博 |
| |
| 作者单位： | 江苏大学,流体机械工程技术研究中心,江苏,镇江,212013 |
| |
| 基金项目： | 江苏省高技术研究项目 |
| |
| 摘 要： | 采用经验系数设计法对脱硫泵进行水力设计,适当增大叶片出口宽度,以改善颗粒通过性和叶轮出口的磨损情况.应用FLUENT软件,采用欧拉多相流模型,分别计算了颗粒直径为0.06,0.08和0.10 mm,体积浓度为11%工况下脱硫泵的两相流内部流场.得到以下结论：叶轮流道内,工作面上的静压值明显高于背面上的静压值;最低压力点出现在叶片进口背面侧,容易发生汽蚀;随着粒径的增大,颗粒逐渐向叶片工作面迁移.叶片的磨损主要发生在叶片进口处和叶片的出口段.通过试验验证：设计的脱硫泵效率为82.0%,性能曲线平坦,高效范围宽,各项技术指标均满足设计要求.
|
| 关 键 词： | 脱硫泵 水力设计 叶轮 数值模拟 |
Design and experiment of desulphurization pump based on CFD |
| |
| Liu Jianrui,Xiao Zhijie,Wang Hongrui,Teng Renbo. Design and experiment of desulphurization pump based on CFD[J]. Drainage and Irrigation Machinery, 2009, 27(1): 6-9 |
| |
| Authors: | Liu Jianrui Xiao Zhijie Wang Hongrui Teng Renbo |
| |
| Affiliation: | Technical and Research Center of Fluid Machinery Engineering;Jiangsu University;Zhenjiang;Jiangsu 212013;China |
| |
| Abstract: | Based on the empirical coefficient method,the hydraulic design of desulphurization pump has been improved by increasing the outlet width of the blade.The Fluent software and Euler model for multi-phase flow were adopted for the numerical simulation of the pump.The results show that the static pressure of pressure side is higher than that of the suction side;the lowest pressure of the inlet appears on the back side of the blade,which will result in cavitation;the grain was transferred to the direction of pre... |
| |
| Keywords: | desulphurization pump hydraulic design impeller numerical simulation |
| 本文献已被 CNKI 维普 万方数据 等数据库收录！ |
|
