| 堆石体分区和堆石料压缩模量对面板坝变形影响分析 |
| |
| 引用本文： | 毛渐,王正中,刘铨鸿.堆石体分区和堆石料压缩模量对面板坝变形影响分析[J].中国农村水利水电,2011(8). |
| |
| 作者姓名： | 毛渐 王正中 刘铨鸿 |
| |
| 作者单位： | 西北农林科技大学水工程安全与病害防治研究中心,陕西杨凌,712100 |
| |
| 摘 要： | 采用邓肯-张E-B模型和ANSYS数值分析软件,结合水布垭面板坝工程,研究了200 m级面板坝主、次堆石料不同压缩模量及堆石分区形式对坝体的沉降、应力和面板挠度等的影响。通过比较分析,结果表明：坝体最大沉降和面板最大挠度均随着主、次堆石压缩模量比值增大而增大;顶部面板顺坡向0.35倍处的面板挠度最大并有较大程度的反弯,为了减小挠度和反弯趋势,可增大主堆石料的压缩模量;主、次堆石压缩模量比值在1~2以内,可以选择分界线在坝轴线上游的分区形式,可以明显提高软岩的利用量而且坝体和面板的变形尚在接受范围之内;否则,分界线要置于坝轴线下游1∶0.2~1∶0.5之间,保证主堆石在0.5~0.75倍的充分坝宽,这样的分区对坝体和面板的变形才更为有利,值得推广应用。
|
| 关 键 词： | 面板堆石坝 堆石分区 压缩模量比值 挠度分布 反弯 |
An Analysis of CFRD Deformation under Different Zonings and Compression Modulus of Rock-fills |
| |
| MAO Jian,WANG Zheng-zhong,LIU Quan-hong.An Analysis of CFRD Deformation under Different Zonings and Compression Modulus of Rock-fills[J].China Rural Water and Hydropower,2011(8). |
| |
| Authors: | MAO Jian WANG Zheng-zhong LIU Quan-hong |
| |
| Institution: | MAO Jian,WANG Zheng-zhong,LIU Quan-hong(Research Center of Water Engineering Safety and Disaster Prevention,Northwest Agricultural and Forestry University,Yangling 712100,Shaanxi Province,China) |
| |
| Abstract: | Based on E-B model and ANSYS software,200 m dam settlement and stress and displacement(panel) deflection with different compression modulus and boundary positions are studied.The comparisons show that dam settlement and the maximum panel deflection increases as the ratio of compression modulus increases;0.35 times of the panel from the dam crest the maximum deflection and a high degree of recurvation exists,then increasing the compression modulus of primary rock-fill materials can reduce the deflection and ... |
| |
| Keywords: | CFRD zoning of rock-fills ratio of compression modulus distribution of deflection recurvation |
| 本文献已被 CNKI 万方数据 等数据库收录！ |
|
